Concept explainers
A species of aster normally blooms between mid-August and late September. The range of the aster is located in a climate that usually produces freezing temperatures in late October. The pollinators (bees, ants, and other insects) of the aster are active between late April and early October. Mutations can occur in the gene that controls flowering time for some individuals of this aster, causing them to flower earlier or longer than normal. The table shows possible flowering times.
Describe how this population of asters might split into two species.
Want to see the full answer?
Check out a sample textbook solutionChapter 13 Solutions
Pearson eText Biology: Science for Life -- Instant Access (Pearson+)
Additional Science Textbook Solutions
Biological Science (6th Edition)
Introductory Chemistry (6th Edition)
Laboratory Manual For Human Anatomy & Physiology
Chemistry: Atoms First
Microbiology Fundamentals: A Clinical Approach
- Monoecious plants such as corn have either staminate or carpelate flowers. Knowing what you do about the molecular mechanisms of floral development, which of the following might explain the development of single-sex flowers? a. Expression of B-type genes in the presumptive carpel whorl will generate staminate flowers. b. Loss of A-type genes in the presumptive petal whorl will allow C-type and B-type genes to produce stamens instead of petals in that whorl. c. Restricting B-type gene expression to the presumptive petal whorl will generate carpelate flowers. d. All of the choices are correct.arrow_forwardThe ABCDE Model of flower development dictates the combination of transcription factors require to initiate each whorl of a flower. Based on the diagram below, what would happen if: Carpels and ovules Sepal Petal Stamen 2 4 Whorl A Genes E 25-40 The ABCDE model of floral organ determination in Arabidopsis In addition to the A-, B-, and C-function genes of the ABC model, this model includes two additional gene classes, D and E. In the ABCDE model, class A + E genes specify sepals; class A + B + E, petals; class B +C +E, stamens; class C + E, carpels; and class C+ D + E, ovules. 1. Gene D was non-functional: 2. Gene E was non-functional: 3. Only Gene A was functional: 4. Gene B and E were non-functional: 5. Only Gene A and Gene E were functional: Hint: If Gene A was non-functional the flower would have no sepals or petals, it would be composed of only stamens and carpels.arrow_forwardThe physical and purposeful process of crossing the pollen of one plant to the stigma of another plant is known as cross pollination or A self pollination artificial fertilization cross fertilizationarrow_forward
- Plants reproduce through various methods. Explain which method helps to create genetic variability in crop plants? Moreover elaborate mechanisms promoting self or cross pollination.arrow_forwardThe image below represents a flower meristem viewed from above. At the time the image represents, the cells are undifferentiated, although their eventual fates are determined (e.g. carpels, etc.). The rectangles indicate the regions of the meristem where particular genes (A, B, and C) are expressed. Note that these genes are expressed all around the circumference of the meristem at the location indicated; in other words, gene A is active in all cells in the rings labeled sepal and petals. Interpret the figure by filling in the following table: I've numbered each row to help with writing the answer below. Determined by the activity of which gene(s) - A,B,C? Organ Carpel 1. Stamen 2. Petal 3 Sepal 4 Sepals Petals Stamens Bn Carpelsarrow_forwardThe image below represents a flower meristem viewed from above. At the time the image represents, the cells are undifferentiated, although their eventual fates are determined (e.g. carpels, etc.). The rectangles indicate the regions of the meristem where particular genes (A, B, and C) are expressed. Note that these genes are expressed all around the circumference of the meristem at the location indicated; in other words, gene A is active in all cells in the rings labeled sepal and petals. Sepals Petals Stamens LEnCarpels A close relative of this flower has very large sepals compared to this one. Apply what you know about morphogenesis in plants to make a hypothesis of how gene expression might differ in the relative compared to this plant. Be sure to relate it to the figure above.arrow_forward
- The image below represents a flower meristem viewed from above. At the time the image represents, the cells are undifferentiated, although their eventual fates are determined (e.g. carpels, etc.). The rectangles indicate the regions of the meristem where particular genes (A, B, and C) are expressed. Note that these genes are expressed all around the circumference of the meristem at the location indicated; in other words, gene A is active in all cells in the rings labeled sepal and petals. Sepals Petals Stamens UEn Carpels Explain what cue the floral cells are likely using to determine the cells that will differentiate into the different parts (ie. sepal, petal, etc.) based on the given scenerio.arrow_forwardEach of the components below should be 1 or at most 2 sentences. Abstracts are 1 paragraph, it is unusual for them to have a reference and must be concise. Explain this hypothesis in detail: The hypothesis can be tested by subjecting groups of Brassica rapa plants to different light exposure durations while keeping other growth conditions constant and recording the time taken for each group to reach the flowering stage. Summarize the methods and experimental design including control and experimental groups and the length of this Brassica rapa experiment. Describe results and analysis Complete the abstract with a brief conclusion of the results of your experiment.arrow_forwardin flowering control of plant, describe a situation wherein there are mutations in at least one or all of the genes responsible for control of the floral development.arrow_forward
- In the experiment conducted to test why individuals in the tree species Fuschsia excorticata retain flowers after they turn red even though the trees pollinate and offer a nectar reward only when flowers are green (Figure attached 10.28 first tested the 'pollinator-attraction' hypothesis that red flowers attract pollinators: once drawn to a tree, pollinators could forage on the green flowers still present, increasing overall pollination efficiency. Please assess the lowercase-Roman-numeral-labelled statements that appear immediately below and click the uppercase-letter-labelled response that appears below and conveys the most accurate information. i. If the pollinator-attraction hypothesis were correct, then green flowers surrounded by red flowers should receive more pollen than should green flowers surrounded by only green flowers. ii. The prediction in statement i could be tested by removing red flowers from some trees, forming one experimental group, and leaving red flowers on…arrow_forwardIn the Kotukutuku plant, Fuchsia excortiata, why do pollinated flowers remain attached to the plant for several days after pollination occurs and nectar is no longer produced Size of flower and pollination Annual versus perennial reproduction Time and expense to grow the pollen tube outweighs the cost of maintaining the flower on the tree Size of flower and number of flowers on inflorescencearrow_forward1) Does the three t-tests support the hypothesis: of manipulating light exposure will influence the flowering time of Brassica rapa plants by using light from the sun and using incandescent bulbs, or not? If it did not support the hypothesis, then what changes would you make? 2) Do these three t-tests have different growth rates? 3) Is there anything to learn about this study of the graphs and t-tests?arrow_forward
- Biology: The Dynamic Science (MindTap Course List)BiologyISBN:9781305389892Author:Peter J. Russell, Paul E. Hertz, Beverly McMillanPublisher:Cengage Learning