To explain based on the chemistry that takes place “why an alkaline battery is called “alkaline” Concept introduction: Battery is an electrochemical cell that converts chemical energy into electrical energy. A typical battery consists of a cathode, an anode, and an electrolyte. Cathode and anode are connected externally by an electrical circuit. During chemical reaction inside the battery, electrons are accumulated at the anode which results in an electrical difference between the cathode and the anode. When the circuit is closed, excess electron will flow towards the cathode, generates power.

Question

Want to see the full answer?

Answer 1

Question

Chapter 13, Problem 13.57PAE

Interpretation Introduction

Interpretation:

To explain based on the chemistry that takes place “why an alkaline battery is called “alkaline”

Concept introduction:

Battery is an electrochemical cell that converts chemical energy into electrical energy. A typical battery consists of a cathode, an anode, and an electrolyte. Cathode and anode are connected externally by an electrical circuit. During chemical reaction inside the battery, electrons are accumulated at the anode which results in an electrical difference between the cathode and the anode. When the circuit is closed, excess electron will flow towards the cathode, generates power.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Given a system with an anodic overpotential, the variation of η as a function of current density- at low fields is linear.- at higher fields, it follows Tafel's law.Calculate the range of current densities for which the overpotential has the same value when calculated for both cases (the maximum relative difference will be 5%, compared to the behavior for higher fields).

Using reaction free energy to predict equilibrium composition Consider the following equilibrium: N2 (g) + 3H2 (g) = 2NH3 (g) AGº = -34. KJ Now suppose a reaction vessel is filled with 8.06 atm of nitrogen (N2) and 2.58 atm of ammonia (NH3) at 106. °C. Answer the following questions about this system: rise Under these conditions, will the pressure of N2 tend to rise or fall? ☐ x10 fall Is it possible to reverse this tendency by adding H₂? In other words, if you said the pressure of N2 will tend to rise, can that be changed to a tendency to fall by adding H2? Similarly, if you said the pressure of N will tend to fall, can that be changed to a tendency to rise by adding H₂? If you said the tendency can be reversed in the second question, calculate the minimum pressure of H₂ needed to reverse it. Round your answer to 2 significant digits. yes no ☐ atm Х ด ? olo 18 Ar

Four liters of an aqueous solution containing 6.98 mg of acetic acid were prepared. At 25°C, the measured conductivity was 5.89x10-3 mS cm-1. Calculate the degree of dissociation of the acid and its ionization constant.Molecular weights: O (15.999), C (12.011), H (1.008).Limiting molar ionic conductivities (λ+0 and λ-0) of Ac-(aq) and H+(aq): 40.9 and 349.8 S cm-2 mol-1.