Concept explainers
(a)
Interpretation:
Total moles of gas in mixturehave to be determined.
Concept Introduction:
Here,
(a)
Answer to Problem 69AE
Total moles of gas in mixture are
Explanation of Solution
Rearrange expression (1) to calculate value of
Conversion factor to convert
Substitute
Hence, the total moles of gas in mixture are
(b)
Interpretation:
The number of grams of nitrogen in mixture of gas in mixture has to be determined.
Concept Introduction:
Refer to part (a).
(b)
Answer to Problem 69AE
The number of grams of nitrogen in mixture of gas in mixture is
Explanation of Solution
Moles of oxygen gas can be calculated as follows:
Moles of carbon dioxide can be calculated as follows:
Moles of nitrogen in mixture can be calculated as follows:
Mass of
Hence, the grams of nitrogen in mixture of gas in mixture are
(c)
Interpretation:
Partial pressure of each gas in mixture has to be determined.
Concept Introduction:
Refer to part (a).
(c)
Answer to Problem 69AE
Values of
Explanation of Solution
Mole fraction of
Therefore, partial pressure of
Mole fraction of
Therefore, partial pressure of
Partial pressure of
Hence, the value of
Want to see more full solutions like this?
Chapter 12 Solutions
FOUNDATIONS OF COLLEGE CHEM +KNEWTONALTA
- Pyruvic acid, HC3H3O3, is involved in cell metabolism. It can be assayed for (that is, the amount of it determined) by using a yeast enzyme. The enzyme makes the following reaction go to completion: HC3H3O3(aq)C2H4O(aq)+CO2(g) If a sample containing pyruvic acid gives 21.2 mL of carbon dioxide gas, CO2, at 349 mmHg and 30C, how many grams of pyruvic acid are there in the sample?arrow_forwardA student prepares phosphorous acid, H3PO3, by reacting solid phosphorus triiodide with water. PI3(s)+3H2O(l)H3PO3(s)+3HI(g) The student needs to obtain 0.250 L of H3PO3(d=1.651g/cm3). The procedure calls for a 45.0% excess of water and a yield of 75.0%. How much phosphorus triiodide should be weighed out? What volume of water (d=1.651g/cm3) should be used?arrow_forwardperform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.arrow_forward
- A mixture contained zinc sulfide, ZnS, and lead sulfide, PbS. A sample of the mixture weighing 6.12 g was reacted with an excess of hydrochloric acid. The reactions are ZnS(s)+2HCL(aq)ZnCl2(aq)+H2S(g)PbS(s)+2HCL(aq)PbCl2(aq)+H2S(g) If the sample reacted completely and produced 1.049 L of hydrogen sulfide, H2S, at 23C and 762 mmHg, what were the percentages of ZnS and PbS in the mixture?arrow_forwardWhat is the value of the ideal gas constant R if the volume is specified in milliliters rather than liters?arrow_forwardYou have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.arrow_forward
- Liquid oxygen was first prepared by heating potassium chlorate, KClO3, in a closed vessel to obtain oxygen at high pressure. The oxygen was cooled until it liquefied. 2KClO3(s)2KCl(s)+3O2(g) If 171 g of potassium chlorate reacts in a 2.70-L vessel, which was initially evacuated, what pressure of oxygen will be attained when the temperature is finally cooled to 25C? Use the preceding chemical equation and ignore the volume of solid product.arrow_forward109 An ore sample with a mass of 670 kg contains 27.7% magnesium carbonate, MgCO3. If all of the magnesium carbonate in this ore sample is decomposed to form carbon dioxide, describe how to determine what volume of CO2 is evolved during the process. What would have to be measured to predict the needed volume in advance?arrow_forwardConsider these four gas samples, all at the same temperature. The larger boxes have twice the volume of the smaller boxes. Rank the gas samples with respect to: (a) pressure, (b) density, (c) average kinetic energy, and (d) average molecular speed. (Green spheres are He; violet spheres are Ne.)arrow_forward
- 47 HCl(g) reacts with ammonia gas, NH3(g), to form solid ammonium chloride. If a sample of ammonia occupying 250 mL at 21 C and a pressure of 140 torr is allowed to react with excess HCl, what mass of NH4Cl will form?arrow_forwardDichlorine oxide is used as bactericide to purify water. It is produced by the chlorination of sulfur dioxide gas. SO2(g)+2Cl2(g)SOCl2(l)+Cl2O(g)How many liters of Cl2O can be produced by mixing 5.85 L of SO2 and 9.00 L of Cl2? How many liters of the reactant in excess are present after reaction is complete? Assume 100% yield and that all the gases are measured at the same temperature and pressure.arrow_forwardIf one mole of an ideal gas is held at a pressure of 1 atm and temperature of 25°C, its volume will be: (A) (B) 22.4 L Greater than 22.4 Larrow_forward
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningIntroductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage Learning
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage Learning