Network latency: Network latency is a kind of delay that occurs in data communication over a network. Typically, small delays occurring in network connections are termed as low latency whereas long delays are termed as high latency. Generally, high latency leads to bottlenecks in the network connections. Often, it inhibits data from using network pipe and decreases the bandwidth of the network. Network administrators often consider network latency as a metric while computing performance and efficiency of the network. Packet loss: Packet loss refers to the number of packets that fail to reach their intended destination. Packet loss is caused either by network congestion or errors in data transmission. Network administrators often consider packer loss as a metric while computing performance and efficiency of the network.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 2HA2

Program Plan Intro

Network latency:

Network latency is a kind of delay that occurs in data communication over a network.

Typically, small delays occurring in network connections are termed as low latency whereas long delays are termed as high latency.

Generally, high latency leads to bottlenecks in the network connections.

Often, it inhibits data from using network pipe and decreases the bandwidth of the network.

Network administrators often consider network latency as a metric while computing performance and efficiency of the network.

Packet loss:

Packet loss refers to the number of packets that fail to reach their intended destination.

Packet loss is caused either by network congestion or errors in data transmission.

Network administrators often consider packer loss as a metric while computing performance and efficiency of the network.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

5. Draw the value of the Q and -Q outputs for a positive edge-triggered J K flip-flop in the timing diagram below. Assume that Q is initially a '0' and ~Q is initially a '1': CLK 0 10 ° 1 J Q CLK K а

For the timing diagram shown in figure below, draw the output Q for a rising edge-triggered D- Flip-Flop with active high Reset. Clock Reset 12 t ta

Answer only 6 questions for 12 mark every question have 2 mark 1- Explain advantages and disadvantage The Local and Remote Network Segments with detail? 2- What are the Criteria for Dividing the Local Network list it with explain? 3- What is the categories are used to classify types of personal data? 4- When a host is configured with DHCP, it will attempt to obtain its IPv4 address, subnet mask, default gateway, and DNS server from DHCP. What operations does this protocol take? 5- Compare IPv4 and IPv6 Addressing? 6- Which technique allows IPv4 and IPv6 to coexist on the same network? 7- TCP/IP vs OSI Model what difference between them? 8- Explain the Email Protocols (SMTP), (POP3) and (IMAP4)? 9- Define the following concept (Socket, Encapsulation, Ethernet, frame). 10- There are four primary cloud models or type explain them? 11- What are Difference and advantages between "cloud computing" and "virtualization"? 12- When a threat actor gains access to the network, four types of threat…