The two site factors that contribute to energy-efficient design.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 12.7Q

To determine

The two site factors that contribute to energy-efficient design.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The calibrated Greenberg model is of the form, v = 32ln(295/k),where k is in veh/mile and v is in mile/hr.(a)Sketch the v-k relationship and discuss the obviousdisadvantage of the model. b)Determine (i) the jam density, (ii) the capacity or maximum flowand (iii) the values of speed and density at capacity. (c)Sketch the q-k and v-q relationshipsand indicate the points obtained in (b) above.

Vehicles begin to arrive at an amusement park entrance at 8:00 A.M. at a rate of 1000veh/h. Some of these vehicles have electronic identifiers that allow them to enter the park immediately, beginning at 8:00 A.M., without stopping (they are billed remotely). All vehicles without such identifiers stop at a single processing booth, but they wait in line until it opens at 8:10 A.M. Once open, the operator processes vehicles at μ(t) = 8 + 0.5t [where μ(t) is in vehicles per minute and t is in minutes after 8:10 A.M.]. An observer notes that at 8:25 there are exactly 20 vehicles in the queue. What percent of arriving vehicles have electronic identifiers and what is the total delay (from the 8:00 A.M. until the queue clears) for those vehicles without the electronic identifiers (assume D/D/1 queuing)?

1. For truss given in a figure below, determine reactions, and forces in all truss members. De- termine forces using two methods independently: (a) method of joints, and (b) method of sections. Compare your results and verify that your solutions are accurate. Assume that force F = 10kN. 2m 2m 2m ▼F ▼F 4m ▼F 4m