Chapter 11, Problem 11.34P

ฉันต้องการหา อุณหภูมิสุดท้ายของกระบวนการนี้และงานของกระบวนการนี้มีค่าเท่าใด

The pressure and temperature at the beginning of compression of a cold air-standard Diesel cycle are 100 kPa and 300 K , respectively. At the end of the heat addition, the divssure is 7.2 MPa and the temperature is 2050 K . Assume constant specific heats evaluated at 300 K . Determine:(a) the compression ratio.(b) the cutoff ratio.(c) the percent thermal efficiency of the cycle.(d) the mean effective pressure, in kPa .

Q3. Determine the reaction force at A and force P applied at 45° to the horizontal just necessary to start a roller 100 cm diameter over an obstruction 25 cm high, if the roller weighs 1000 N, as shown in Fig. 3. Fig. (3)

Correct Answer is written below(preferably handwritten solution) . Detailed and complete fbd only please. I will upvote, thank you.

The pressure and temperature at the beginning of compression of a cold air-standard Diesel cycle are 100 kPa and 300 K , respectively. At the end of the heat addition, the pressure is 7.2 MPa and the temperature is 2050 K . Assume constant specific heats evaluated at 300 K . Determine:(a) the compression ratio.(b) the cutoff ratio.(c) the percent thermal efficiency of the cycle.(d) the mean effective pressure, in kPa

Correct Answer is written below(preferably handwritten solution) . Detailed and complete fbd only please. I will upvote, thank you.

Correct Answer is written below(preferably handwritten solution) . Detailed and complete fbd only please. I will upvote, thank you.  7: The round bar AB in the figure is formed into a quartercircular arc of radius R that lies in the horizontal plane. The bar is built in atB and carries the vertical force P at end A. Given: P = 3 kN, R = 900 mm andα = 25°.1. Calculate the bending moment (kN-m) acting at section C.2. Calculate the torsional moment (kN-m) acting at section C.3. If the allowable torsional stress is limited to 65 MPa, calculate therequired minimum diameter of the bar (mm).ANSWERS: 1.14 kN-m; 0.25 kN-m; 60 mm

Correct Answer is written below(preferably handwritten solution) . Detailed and complete fbd only please. I will upvote, thank you.

Current Attempt in Progress A cold air-standard Otto cycle has a compression ratio of 9 and the temperature and pressure at the beginning of the compression process are 520°R and 14.2 lbf/in.², respectively. The heat addition per unit mass of air is 600 Btu/lb. Assume constant specific heats evaluted at 520°R. Determine: (a) the maximum temperature, in °R. (b) the maximum pressure, in lbf/in.² (c) the percent thermal efficiency. (d) the mean effective pressure, in lbf/in.²