Sustainable Energy
2nd Edition
ISBN: 9781337551663
Author: DUNLAP, Richard A.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 1, Problem 9P
To determine
Find the current flowing through the given resistor.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
In a parallel electrical circuit, the total current is the sum of the individualcurrents. An air conditioner has a blower and a compressor that are wired ina parallel circuit. The blower draws 1.042 amperes and the compressor draws11.95 amperes of current. When both are operating, what is the total currentdrawn?
2. A parallel-plate capacitor initially has a capacitance of 100 F. What will be the
capacitance if the distance between the plates is doubled?
Is the flow of conventional
2 points
current from negative to
positive terminal? *
YES
O NO
What object did Mr. Benjamin 2 points
Franklin put on the kite when
he discovered the direction of
conventional current? *
Your answer
If there is a potential
2 points
difference of zero in any two
points in a circuit, is the
current still flowing? *
O YES
NO
Chapter 1 Solutions
Sustainable Energy
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- One of the most common appliances used on a daily basis is the hair dryer. A hair dryer is basically a duct in which a few layers of electric resistors are placed. A small fan at the back of the device pulls the air in and forces it through the resistors where it is heated (see Fig. 1). The power consumed by the heating elements (i.e. electric resistors) of the hair dryer is 1258 Watts. Air enters the hair dryer at 95 kPa and 25°C and leaves at 50°C. The cross-sectional area of the hair dryer at the exit is 55 cm². The power consumed by the fan is 2 Watts and the heat loss through the walls of the hair dryer is 5 Watts. By clearly stating your assumptions throughout, 1.Analytically describe the Fluid Mechanics and Thermodynamics working principles of the hairdryer; 2. Provide a schematic diagram of the hair dryer clearly indicating the system's boundaries, mass flows and energy/heat flows; 3. Determine the volumetric flow rate of the air at the inlet; 4. Determine the velocity of the…arrow_forward509% Part (b) Consider a 5.0om long wire of mass 10.0 g. The wire is suspended between the poles of a magnet as shown (end view of wire). When a 0.7 A current in the wire is turned on, the wire and magnet are attracted to each other. wire What can you learn about the magnet and the direction of the current through the wire with this information?arrow_forward4. An incandescent lamp has a tungsten filament whose resistance is 96 ohm at its operating temperature of 2900°C. Calculate the filament resistance when the lamp is disconnected from the electric source under which conditions the temperature is 24°C.arrow_forward
- If the current through a 100K resistor is 3.6 UA, what does the voltage drop across the resistor?arrow_forwardww An AC voltage source is connected to a resistor, a capacitor, and an inductor, as shown above. (a) If the frequency of the voltage sine wave is very, very high, which component (R, C, or L) do you think will have the greatest average magnitude of current flowing through it? Which do you think will have the least? Why? (b) Same question as (a), but with an input voltage with a very, very low frequency.arrow_forwardA-10.0 nC point charge and a +20.0 nC point charge are 17.5 cm apart on the x-axis. Part A What is the electric potential at the point on the x-axis where the electric field is zero? Express your answer with the appropriate units. ▸ View Available Hint(s) V = Value Units Submit Part B ? What is the magnitude of the electric field at the point on the x-axis, between the charges, where the electric potential is zero? Express your answer with the appropriate units. ▸ View Available Hint(s) E= Value Units ?arrow_forward
- A portable heater is listed for 115 volts. It uses 12 amperes of current. Whatis the resistance of the heater?arrow_forwardAssuming the plates are 12 feet tall and 8 feet long, and are arranged with four mechanical fields, calculate the aspect ratio. An ESP must treat 400,000 aefin with 98.6% efficiency.arrow_forwardCalculate the change in a 5-m long copper wire when its temperature changes by 120 oF. Thecoefficient of thermal expansion for copper is approximately 17 x 10-61/oC. Express your answerin SI units.arrow_forward
- What volume at STP is produced when a current of 20 A is passed through a molten NaCl (l) for 2.0 hoursarrow_forwardQuestion 10 Define thermal bridge in buildings, and explain how thermal bridge can be controlled in the following building components: Window frames: Balcony slab: Stud frame walls: Roof to wall connection: Window to wall connection:arrow_forward4. The human heart pumps the average adult's 6.0 liters (6000 cm3) of blood through the body every minute. The heart must do work to overcome frictional forces that resist blood flow. The average blood pressure is 1.3x104 N/m² a) How much work does the heart do to move the 6.0 liters of blood completely through the body? b) What power output must the have to do this task once a minute? Hint: When the heart contracts, it applies a force to the blood. Pressure is force/area. Model the circulatory system as a single closed tube, with crosssectional area A and volume V=6.0 liters, filled with blood to which the heart applies a force.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning
Engineering Fundamentals: An Introduction to Engi...
Civil Engineering
ISBN:9781305084766
Author:Saeed Moaveni
Publisher:Cengage Learning