You have an aqueous extract that has been dried and you are going to perform a liquid/liquid separation. You must use a mixture of two solvents: a. Which solvent mixture would you use? Available solvents: cyclohexane, chloroform, ethanol, methanol, hexane, acetone. b. What compounds would you expect to be in each phase

Q: 11. How much fluorouracil powder is in 5% Efudex® cream 50 g? 12. How much oxiconazole nitrate…

A:

Q: One liter of hot water will dissolve 83 g of compound Z.  One liter of cold water will dissolve 12 g…

A: Undissolved amount = total amount - dissolved amount

Q: A mixture of cyclohexane (b.p 81 °C) and toluene (b.p 110.8 °C) need to be separated and collected…

A: Given that, a mixture of cyclohexane (b.p 81 °C) and toluene (b.p 110.8 °C) needs to be separated…

Q: 14% ethanol. How much of 14% v/v ehathol to acquire 14ml of acetic acid?

A: Volume Percent: The volume percent is used to express the concentration of a solution when the…

Q: You are going to mix a 1:10 bleach solution with water to make 500 mL of a 1:35 bleach solution. How…

A: This problem is based on Law of equivalence.Here the solution is being diluted . So here water will…

Q: city factor that can be separated with a given efficiency by a particular prom c)-Efficiency d-Load…

A: 24. b.3M  25.a. Reverse osmosis 26. C.Silica gel & alumina 27.b.Aromatic compounds  28.a. Flame…

Q: If you are performing a solvent extraction using 1M HCl (Density slightly > 1.00 g/mL) and diethyl…

A:

Q: Suppose you have a mixture of saturated aqueous sodium chloride (brine) and your…

A: The substance whose density is high remain as bottom layer while with lesser density remain as top…

Q: What are some of the uses of distillation? Choose all that apply. O Purify an organic reaction…

A: Distillation is the  separation process in most of the organic products.

Q: Why is better separation of two liquids achieved by slow rather than fast distillation?

A: Distillation is a process in which separation of the mixture of liquids take place both the liquids…

Q: You are assigned one of the unknown compositions below according to your last name. Let’s assume you…

A: The three components can be separated by the principle of solubility of organic and ionic compounds.…

Q: You have an unknown with an observed melting point of 123-126"C. Which of the following standards…

A:

Q: Benzillic Acid Lab Q3. Cold water and ethanol was used to wash/rinse the collected solid during…

A: The rinse is to wash off impurities that adhere to the surface of the tetraphenylcyclopentadienone…

Q: 3.Why is it dangerous to perform distillation on a closed (airtight) system?

A: The process distillation involves the conversion of a liquid into vapour that is subsequently…

Q: If you have a beaker filled with 50/50 t-butyl methyl ether/water, how many layers do you predict…

A: t-butyl methyl ether is a non-polar organic compound. Non-polar solvents will not be soluble in…

Q: Based on the six given solvents, which of the following answers lists ALL of the solvents that ARE…

A: Here the general rule is:  The more polar the organic solvent,the more it is miscible (soluble) with…

Q: Melting point is Pressure dependent. Choose... TWo different pure compounds can have the same…

A: Note: According to the rules we can answer first three because they are very short but fourth is…

Q: How do I create a detailed separations flowchart of the isolation process of caffeine from soda? The…

A: One of the separation processes that is used to isolate a particular compound from mixture or a…

Q: You and your partner independently measure the melting point of the same pure sample .you observe q…

A: Given:    observed melting       points Partner A 126.5-129 oC Partner B 126-132 oC How…

Q: 5.Where should the thermometer bulb be located in the following setups? a. a microscale distillation…

A: a) Answer -

Q: Use the dropdown menus to indicate whether a solvent pair could be used successfully in a…

A: Ideal properties of mixed solvents in recrystallization: 1) The compound should be readily soluble…

Q: Which of these solvent systems would cause a compound to elute from the column fastest (a,  b, or…

A: Column chromatography is a technique used for the purification of compounds. In this technique, a…

Q: Incorrect Separation Scheme NH2 ether, 10 % NaOH aq ether NH 6 M HC1 Na,SO4. gravity filtration…

A:

Q: Consider the volume vs temperature graph below of an unknown 36.00 mL alcoholic moture: Distillation…

A: Volume of alcoholic mixture = 36 mL Volume of distillate collected  = 18 mL Remaining volume in the…

Q: Suppose that you have a 1:1 mixture of compounds that is comprised of compound X and compound Y. You…

A: The amount of solute which can be dissolved in given amount of solvent is termed as its solubility.…

Q: 1. A vial containing an unknown sample is suspected to be one of the following compounds (mp.): urea…

A: A vial consists of an unknown organic compounds which can be urea, 2,4-dimethylacetanilide,…

Q: Which would be the best way to determine the melting point of a compound? Why?   Slowly run two…

A: Since the melting point is a singular, measurable, precise point on the thermometer scale where the…

Q: 3.007 g nutmeg powder 15 ml diethyl ether used as solvent 0.1865 g purified trimyristin a)…

A:

Q: The melting point (mp) range of reference compound A is 320-340°C. The mp range of a 1:1 mixture of…

A: Given, Melting point range of compound A is ---- 320-340oC. Mixture of compound A and unknown…