You are tasked with manufacturing of a hydrogen tank by using a 1.8 cm thick steel plates with 760 MPa tensile strength. What is mass of hydrogen to be stored in individual tanks and volume of tanks if hydrogen will be compressed up to 70 MPa pressure and tanks have a length to radius ratio of 40:3.

Q: 1. ( described as u = (0.5y – 50y²) m/s, and the unit of y is m. If the viscosity of the fluid is u…

A: Note: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: A cylinder has a of 0.35 MPa. What i

A: The minimum allowable thickness is thickness of sheet required to sustain pressure of system

Q: An oil-water mixture is separated in a decanter. The properties of oil and water are summarized in…

A: For oil,For water,

Q: Estimate the mass, kg, and weight, N, of the air contained in a classroom with STP conditions.…

A: The dimension of the classroom: 3.2m x 8m x 20m Air is at STP i.e. Standard temperature and pressure…

Q: Below is shown the results for a series of cake filtration experiments on two types of waste sludges…

A: Correct. The higher slope (1.27) for Type B implies a greater increase in specific cake resistance…

Q: What is potential energy surface (PES)? Draw PES to represent the variation of energy during…

A:

Q: If the tank was actually pressurized such that the top surface of the milk was at a pressure of…

A: Given Bottom pressure=40kPa Top pressure=110kPa SGmilk=1.030 Find Actual height of milk in the…

Q: 5. . . ) In a manufacturing process, a long, coated plastic rod (p = 2200 kg/m³, c = 800 J/kg K, k…

A: The time it take to the surface of the rod to reach 175o C, the temperature above which the special…

Q: is flowing at a rate of 15 kg/s. For this type of flow, the Nusselt number is given by the following…

A: Given data: Mass flow rate of fluid = 15 kg/s Density of the fluid = 881 kg/m3 Viscosity =…

Q: Verify that thermal conductivity

A:

Q: 2) A cylinder holds 200 kg of water at 120 °C at a pressure of 20 MPa. The temperature is increased…

A:

Q: A reservoir of 1300 ft radius with 42 ft thickness experiences a drop in fluid pressure from 5300…

A: Given,initial porosity of reservoir, φ1=16.4%=0.164formation compressibility ,Cf=4×10-5…

Q: Design a vertical separator to separate 10000 kg/h of liquid, density 962.5 kg/m³, from 15000 kg/h…

A: Given :The pressure, The liquid flow rate                                 The vapor flow rate…

Q: Reynolds analogy is preferred over Chilton-Colburn analogy. O True False Depends on Sh O Only for…

A: Chilton Coulburn analogy is widely successful analogy used for estimating mass transfer…

Q: The strain of a component, which has a tensile modulus of 6 X 105 MPa, and subjected to a stress of…

A: The strain of the component with the given tensile modulus is to be determined.