You are required to measure the temperature of exhaust gas from a petrol engine. During the measurement, the thermocouple reads 400°C while the temperature of the exhaust pipe is 350°C. The emissivity of the thermocouple is 0.7 and the convection heat transfer coefficient of the flow over the thermocouple is 90 W/m²-K. Calculate the actual temperature of the exhaust gas.

You are required to measure the temperature of exhaust gas from a petrol engine. During the measurement, the thermocouple reads 400°C while the temperature of the exhaust pipe is 350°C. The emissivity of the thermocouple is 0.7 and the convection heat transfer coefficient of the flow over the thermocouple is 90 W/m²-K. Calculate the actual temperature of the exhaust gas.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A mass of 300kg of oil is cooled in 1 hour from 70 celcius to 35 celcius in a cooler consisting of a bank of tubes through which hot oil passes. Cooling water circulates around the outside of the tubes. Calculate the mass of cooling water required per hour if the water temp increases by 21 degrees celcius . Specific Heat of Oil - 2.0 kJ/kg deg C Specific Heat of Water - 4.186 kJ/kg deg C
A small, oxidized, horizontal metal tube with an OD of 0.0254 m (1 in.), 0.61 m (2 ft) long, and with a surface temperature at 588 K (600°F) is in a very large furnace enclosure with fire-brick walls and the surrounding air at 1088 K (1500°F). The emissivity of the metal tube is 0.60 at 1088 K and 0.46 at 588 K. Calculate the heat transfer to the tube by radiation using SI units and AES units.
Two large plates are maintained at a temperature of 910 K and 500 K respectively. Each plate has area of 100cm^2. Compare the net heat exchange between the plates for the following cases. a. Both plates are black b. Plates have an emissivity of 0.5
A thermocouple shielded by aluminum foil of emissivity 0.15 is used to measure the temperature of hot gases flowing in a duct whose walls are maintained at Tw. = 380 K. The thermometer shows a temperature reading of Tth = 530 K. Assuming the emissivity of the thermocouple junction to be 0.7 and the convection heat transfer coefficient to be h = 120 W/m 2 C . determine the actual temperature of the gas. What would the thermometer reading be if no radiation shield was used?
I need unique and correct answer. Don't try to copy from anywhere. Do not give answer in image formet and hand writing
A solar collector consists of a horizontal copper tube of outer diameter 5 cm enclosed in a concentric thin glass tube of 9 cm diameter. Water is heated as it flows through the tube, and the annular space between the copper and glass tube is filled with air at 1 atm pressure. During a clear day, the temperatures of the tube surface and the glass cover are measured to be 60°C and 32°C, respectively. Determine the rate of heat loss from the collector by natural convection per meter length of the tube.
Consider a person standing in a room kept at 22°C at all times. It was observed that the interior surfaces of the walls, floor and ceiling of the house were at an average temperature of 15°C. If the exposed surface area of this person is 1.4 m^2 and the average external surface temperature is 30°C, determine the rate of radiation and heat transfer between this person and the surrounding surfaces. The spread of the person Ɛ=0.95 Stefan-Boltzmann constant σ=5.67X10^-8 W/m^2K^4
Four power transistors, each dissipating 12 W, are mounted on a thin vertical aluminum plate 22 cm * 22 cm in size. The heat generated by the transistors is to be dissipated by both surfaces of the plate to the surrounding air at 25°C, which is blown over the plate by a fan. The entire plate can be assumed to be nearly isothermal, and the exposed surface area of the transistor can be taken to be equal to its base area. If the average convection heat transfer coefficient is 25 W/m2·K, determine the temperature of the aluminum plate. Disregard any radiation effects.
A thermocouple shielded by a layer of aluminum foil and copper with an emissivity of 0.05 and 0.02 is used to measure the temperature of hot gases flowing in a duct whose walls are maintained at T= 380K. Assuming emissivity of the thermocouple junction is 0.7 and convection heat transfer coefficient to be h= 130 W/m2.C, determine the radiation heat transfer from thermocouple junction to duct wall.
A 1.2 m wide and 5.1 m long solar collector is mounted to a roof. Now the average surface temperature of the solar collector is measured to be 50 oC. The effective surrounding sky temperature is 8 oC. If the emissivity of the collector is 0.88, determine the rate of heat transfer from the collector to the surroundings due to radiation.
In a concentrated solar power plant, molten salt tank is used to store the thermal energy from the sun during the day. The tank wall thickness is 3cm containing molten salt at a temperature of 390 degree Celsius. There is atmospheric air outside the tank at a temperature of 30 degree Celsius. If the surface temperature of the wall on the hot side is 370 degree Celsius and on the cold side is 230 degree Celsius. Calculate the heat flux as a result of heat loss from the molten salt to the atmospheric air if the thermal conductivity of the wall is O.2 W/(m-K)? O 933 W/m2 O 1066 W/m2 O 1333 W/m2 O 2400 W/m²
HEAT TRANSFER SUBJECT