You are given the following transfer function, 20 (s2 + 5s + 25) (s + 0.2) (s² + 5s + 2500) H(s) = (a) Plot the bode diagram clearly showing the slopes of the asymptotes and the height of any peaks. Compute the exact phase and magnitude at the frequencies o = 5 rad/s, o = 50 rad/s. Specifically plot the points at o = 5 rad/s, o = 50 rad/s and clearly mark these points on your Bode plot. Explain why your results make sense with regards of heights of peaks and asymptotes. Your explanation is important. (Do not use Matlab! A Matlab graph will not be accepted) (b) The input to the system is x(t) = 10 sin(100t), what is the output, y(t) in steady state? Roughly sketch both the input and the output on the same graph. Explain your sketch based on the Bode diagram.

You are given the following transfer function, 20 (s2 + 5s + 25) (s + 0.2) (s² + 5s + 2500) H(s) = (a) Plot the bode diagram clearly showing the slopes of the asymptotes and the height of any peaks. Compute the exact phase and magnitude at the frequencies o = 5 rad/s, o = 50 rad/s. Specifically plot the points at o = 5 rad/s, o = 50 rad/s and clearly mark these points on your Bode plot. Explain why your results make sense with regards of heights of peaks and asymptotes. Your explanation is important. (Do not use Matlab! A Matlab graph will not be accepted) (b) The input to the system is x(t) = 10 sin(100t), what is the output, y(t) in steady state? Roughly sketch both the input and the output on the same graph. Explain your sketch based on the Bode diagram.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q.1. (a) Briefly explain how a galvanometer is converted into a Voltmeter. Draw the circuit for fixed & multi range Voltmeter and write equations for Rs. (No simulation is required, only paper work) (b) What is loading effect in Voltmeter?
THREE PHASECONTROLED RECTIFIER It is used to feed a physical load which is resistance of 6 ohm And inductive impedance high enough for the current to be continuous and free from vibrations and the THREE PHASECONTROLED RECTIFIER is connected to delta and his voltage 100 volt , What is the value of the power drawn from the source if the ignition angle is 45 degrees?
Task 1: a) Explain how you would practically test the accuracy of an electronic thermometer. b) Using TINA-TI: i) Create a circuit that will read the voltage output of a thermistor. ii) Run a DC analysis of the system monitoring the system between 0•CC and 100•CC. Displaying your results on a graph. c) Explain the advantages and disadvantages of practical testing and simulations, compare the two and explain why both are important when developing the final system.
Question 1 AC supply voltage with f=50-Hz is connected to a bridge rectifier via a step-down transformer if the rectifier output is connected to a resistive load with 472 and the output power seen across the resistor is 2.5-watt a) Calculate the output peak voltage and current b) Calculate the secondary and primary ms voltages seen across the transformer c) Calculate the secondary and primary peak-currents seen across the transformer ) Draw the output instantaneous voltage and current showing the relevant peak and DC quantities c) Derive the instantaneous equations for the output ac voltage and current (seen across the resistor) Hint: use the 2" approximation (practical model) N-100 turns N-20 turns D3 DI f= 50 Hz D2 D4 R=470 R-2.5w
A snubber protection circuit has snubber time constant (5msec), voltage source (5kV), discharge current of Thyristor (2µA), frequency (50HZ) and resistive load 50. Find the rate of voltage changing with the time and snubber circuit power losses?
2. A moving coil instrument has an initial range of 75 millivolts and a resistance of 5 ohms. Determine the resistance of a voltmeter multiplier to be connected in series with the coil to allow this instrument to function asa voltmeter capable of indicating a full scale deflection of 300 volts. With complete explanation please
A device used to protect a circuit against over currents is a what? a. Polyswitchb. Capacitorc. Dioded. Resistor
(iii) Having determine the unknown resistance in (ii), you decide to adjust the variable to equal that of Roc. determine across the galianometa the potential difference across the resistance
What is the multiplier for the service demand of electric vehicle charging equipment