you are asked to design a heating system for a swimming pool that is 2m deep 25 m long and 25 m wide. your client desires that the heating system to be large enough to raise the water temperature from 20 to 30° C in 3h.the rate of heat loss from the water to the air at the outdoor design conditions is determined to be 960W/m^2 and the heater must also be able to maintain the pool at 30° C at those conditions.heat loses to the ground are expected to be small and can be disregarded.the heater considered is a natural gas furnace whose efficiency is 80 percent. what heater size (in kW input) would You recommend tO YOur client?

you are asked to design a heating system for a swimming pool that is 2m deep 25 m long and 25 m wide. your client desires that the heating system to be large enough to raise the water temperature from 20 to 30° C in 3h.the rate of heat loss from the water to the air at the outdoor design conditions is determined to be 960W/m^2 and the heater must also be able to maintain the pool at 30° C at those conditions.heat loses to the ground are expected to be small and can be disregarded.the heater considered is a natural gas furnace whose efficiency is 80 percent. what heater size (in kW input) would You recommend tO YOur client?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

169 g of solid water (i.e. ice), at -17 °C, is placed into a sealed, insulated container with a volume of 0.29 m^3. A 1457 W heater is used to heat and change the phase of the sample until it is a gaseous water (i.e. steam). The heater runs for 433 s. What is the pressure, in kPa, of the gaseous water in the container at the end of the heating process? Round your answer to the first decimal place.
SANAE IV, a research station of The South African National Antarctic Programme (SANAP), is located on Vesleskarvet, Queen Maud Land. It uses an underground lake as the cold reservoir of a Carnot heat pump that maintains the temperature of a science lab at 307.8 K. To deposit 17360 J of heat in the lab, the heat pump requires 1086 J of work. Determine the temperature of water in the underground lake, in Kelvin.
The Ocean Thermal Energy Conversion (OTEC) system in Hawali utilizes the surface water and deep water as thermal energy reservoirs Assume the ocean lemperature at the surface to be 20 "C and at some depth to be 6 C Determine the maximum possible thermal efficiency achievable by a heat engine. Express the thermal efficiency as a percentage to three significant figures. Thh = 478 % Previous Answers V Correct
b andc
Unreasonable Results - A slightly deranged Arctic inventor surrounded by ice thinks it would be much less mechanically complex to cool a car engine by melting ice on it than by having a water-cooled system with a radiator, water pump, antifreeze, and so on. (a) If 80% of the energy in 1.00 gal of gasoline is converted into “waste heat” in a car engine, how many kilograms of 0C ice could it melt? (b) Is this a reasonable amount of ice to carry around to cool the engine for 1.00 gal of gasoline consumption? (c) What premises or assumptions are unreasonable?
A 10 gallons of water has an inital temperature of 25 degrees Celsius. What is the input power needed to raise the temperature up to the boiling point after 25 minutes Assume heat loss 12%
Mc Graw Hill It is commonly recommended that hot foods be cooled first to room temperature by simply waiting a while before they are put into the refrigerator to save energy. Despite this commonsense recommendation, a person keeps cooking a large pan of stew three times a week and putting the pan into the refrigerator while it is still hot, thinking that the money saved is probably too little. But he says he can be convinced if you can show that the money saved is significant. The average mass of the pan and its contents is 5 kg. The average temperature of the kitchen is 23°C, and the average temperature of the food is 95°C when it is taken off the stove. The refrigerated space is maintained at 3°C, and the average specific heat of the food and the pan can be taken to be 3.9 kJ/kg-°C. If the refrigerator has a coefficient of performance of 1.5 and the cost of electricity is $0.165/kWh, determine how much this person will save a year by waiting for the food to cool to room temperature…
A tank of air is expanded via heat transfer at a constant pressure such that its volume is 2.5 times its original volume. If the initial temperature of the tank was 23 Celsius, what is the amount of heat transfer required for this process in kJ/kg? Calculate this with the following 3 approaches: Constant Specific Heats (use the average temp) The equation as seen on table A-2 Air property tables
solve, show all steps and solutions. list assumptions and concluding comment heat transfer. show resistor diagram for Rs as well use k aluminum = 177 and k carbon steel = 60.5
A 12-by-12 in. open pan containing water at 140 °F is placed in the exact center of a 16-by-20 ft room having a ceiling temperature of 75°F. If the distance from the water surface to the ceiling is 10 ft and the ceiling is painted with an oil paint, what is the net radiant-heat exchange between the water surface and the ceiling?
Hot and cold liquid water are sent through a mixing chamber. The device is not insulated and the water exiting is warmer than the cold water entering. Which terms in the energy equation are not zero? (Click all that apply) Qin Win Qout Wout V Emi - Eme O APE O AKE O AEsys
Apply the first law of thermodynamics to flow system with two inlets and one outlet. Assume that heat is supplied to the system. Draw the neat sketch and lable inlet and outlet properties