Refrigerant 134a is stored inside an uninsulated rigid tank (see figure below) and heated by an electric resistor for 5 minutes. How much energy is lost from the refrigerant through the tank walls during this process? Refer to the table below for properties

Refrigerant 134a is stored inside an uninsulated rigid tank (see figure below) and heated by an electric resistor for 5 minutes. How much energy is lost from the refrigerant through the tank walls during this process? Refer to the table below for properties

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

explained please
Mechanical Engineering A steam turbine receives hot & pressurized steam from the inlet (port 1 in the figure), produces work, and discharges steam at low pressure and temperature to the outlet (port 2). P1 = 1.5 x (modifier) MPa, T1 = 350 x (modifier) °C. P2 and T2 are given in the figure. The turbine is at a steady state. Kinetic energy and gravitational potential energy of the steam are negligible compared to its thermal energy. q is negligible Turbine w? P1= T = im =16 kg/s 2+ P, = 0.2 Mpa | T, = 150°C (a) Mass flow rate at the inlet is 10 kg/s. Compute the mass flow rate at the outlet. Show your reasoning (b) Determine the change of specific enthalpy of the steam between the inlet and the outlet. You can assume the specific heat of steam remains essentially constant during the process, with C, = 1.9 kJ/kg.K (c) Compute the work produced by the steam turbine, per unit mass of steam. (d) Compute the power production from the turbine. Power is the work produced per time, and its most…
For the air compressor shown in Figure below, the air enters from a large area and exit from small one, explain why?
In the piston-cylinder system shown in the figure, the piston rises up to (3) position. Choosing one of the 3 options given in the table, a) the pressure and temperature in positions (2, 3), b) Show the process change (1-2, 2-3) on the P-v diagram by drawing the saturation actions, c) find the total limit work and spring work, d) Find the heat transferred.
Using 1st and 2nd law of thermodynamics for irreversible expansion of Krypton: Krypton (ideal monatomic gas) is confined in one-fourth of a 48-litre container. The other part of the container is evacuated. When the partition is removed, the gas expands and fills the whole container, while the system loses 400J of heat to the environment at 290K. It is found that in the final state, the Krypton is at p2 = 5.5bar, T2 = 400K. Is this process possible or not? (?k?????? = 83.8 kg/kmol)
The total volume of the water tank used in the equipment is 0.02 m3", and the water is heated through the heating rod. The efficiency of the water circulator 40W is 40%, and the remaining energy is released as heat. Given that the heat lost in the entire area in contact with the outside is KI(T-Ta)dT, find the following. O 25 °C → 30 °C. 2 30 °C → 35 °C (C.=4.184J/ml-C, Ta=20 °C. K = 10 J/s-C) (1) Energy balance: equation (2) Total energy used by Heating rod (J)
Solve the problem and show the solution.Note: The answer is given on the bottom right side of the image, just show the solution on how to get it.Thanks!!!
2) Two glass bulbs, one on the left with a volume of 2 liters and the other on the right with avolume of 6 liters, are connected to one another by a thin tube that is initially closed by astopcock. The bulb on the left has 0.1 moles of ideal gas, and the bulb on the right isevacuated. The system is in thermal equilibrium with the surroundings at 300K. When thestopcock is opened, the gas flows out to fill both bulbs. Calculate A for this process. If wewere to insert a propeller to extract work as the gas flows from left to right, what is themaximum amount of work that we could possibly extract?
c. Before going to school and attend his physics class, an engineering student fills the 60-L steel tank of his brand new car with gasoline at 60°F. The car is left in the sun in the school parking area, and the temperature of the gasoline rises to 110°F. Approximately how much gasoline is lost to overflow caused by thermal expansion. Consider the expansion of the tank.
Please show steps I keep coming up with -0.0044
A 1.5m diameter spherical balloon containing air at (162 + 10) kPa is cooled such that the volume is reduced by 25%. For the process, the pressure is proportional to the square of the sphere’s diameter. What is the work done by the surrounding?
Problem A steam turbine operates with 1,6 MPa and 350 deg C steam at its inlet and saturated vapor at 30 deg C at its exit. The mass flow rate of the steam is 22 kg/s, and 610.2 kW of heat is lost through the casing of the turbine. 1. Create a sketch of the problem and indicate the control volume. 2. Write the continuity and energy equations and cross out terms by stating the relevant steady state assumptions. 3. Determine power produced. 4. Determine the specific work.