You are an electrician working in an industrial plant. The company is constructing a maintenance shop located 225 feet from the main plant electrical system. You are to install a 400-ampere three-phase wire system in the new maintenance shop. The service is supplied by the existing plant service. The voltage is 480 volts and the voltage drop is to be kept at 3% or below at full load. The conductors are to be aluminum. What size conductors should be installed for the new service? Express your answer to the nearest standard wire size. (Note: Determine the wire size by calculating length, resistance, and voltage drop as opposed to using the National Electrical Code

Q: Whether Surge resistor 10 Ohms should include in calculation?

A: Surge resistor: It is a resistor which is inserted between the rectifier circuit and filter circuit…

Q: Six 1/0 aluminum conductors are to be run in a conduit. Each conductor has type THWN insulation's,…

A:

Q: When installing grounding electrode conductor at services, it's common to use a single large common…

A: Here we discuss about grounding/earthing related concept.

Q: The minimum size for copper branch conductors in a dwelling is

A: The minimum size for copper branch conductors in a dwelling is

Q: Several factors or conditions can cause conductors to overheat, but often overlooked is the…

A: The heating is the major concern in the conduction as the temperature increases then the resistance…

Q: Draw a figure that represents one cycle of the AC voltage signal present at a typical household wall…

A:

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: Given information, Number of conductors=5. Type of insulation is THW. Size of wire=10 AWG. Raceway…

Q: Hoq do current transformers differ from voltage transformers?

A: Current Transformer is used to measure current while, Voltage transformer is used to measure…

Q: How does the skin effect phenomenon affect the performance of copper cables?

A: The skin effect is a phenomenon that occurs in conductors carrying high-frequency alternating…

Q: Why is the voltage between two phases of 2400 volts 4160 volts and not 4800 volts?

A: Why is the voltage between two phases of 2400 volts 4160 volts and not 4800 volts? Given Vp = 2400…

Q: How can lighting fixture be ground and what size of the conductor can be used

A: There are so many things that come in our mind which is related to light. It may be an artificial…

Electrical Power Generation

In an electric power generator, one type of energy is converted into electrical energy. Power-generating systems are simply a combination of potential or stored energy that is converted to provide kinetic energy, which, in turn, generates electrical energy for use in engines, lighting, heating, and other benefits of modern life.