x(t)= C0 + C1*cos(w*t+phi1) + C2*cos(2*w*t+phi2) x(t)= A0 + A1*cos(w*t) + B1*sin(w*t) + A2*cos(2*w*t) + B2*sin(2*w*t) C0= 6, C1=6.325, phi1=-18.435 deg, C2=6.083, phi2=-9.462 deg, w=400 rad/sec. Determine A0, A1, B1, A2, B2

Q: The electric field in some region is found to be E = RkR³ (V/m) in spherical coordinates (R, 0,6).…

A: E=RKR^3(V/m)

Q: The number (83.45) in base (r=10) can be represented as:

A: Here it is asked to find the decimal number in terms of power of base 10.

Q: To select the ROM the LS138 address lines A8-A6 must be:

A: -To select the ROM the input CS should be active LOW. -To make the input CS active LOW, output line…

Q: 18. Solve this K-map as you would when deriving a minimal sum-of-products expression. Circle the…

A:

Q: 1

A:

Q: Unsuppor dhedSimapdify the following expressions in (1) sum of the products and (2) products of…

A:

Q: A block diagram is shown in the following figure, try to calculate C(s)/ R(s). R(s) E(s) G₁ H₁ H₂ G₂…

A: In this question, we need to determine the transfer function.we solve this problem using mason gain…

Q: Practice Problems 1. A load draws 20 kW at a power factor of .8 lagging. The voltage across the load…

A:

Q: Please check the right statement(s) 1) The unit of J is A/m² 11) The unit of H is A/m² III) The unit…

A: We need to determine the units of current density (J), magnetic field intensity (H), Electric flux…

Q: Derive the minimum sum of products (MSOP) expression for the circuit

A: For the given circuit the minimum sum of the product needs to be obtained and the same can be…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.