XAMPLE 2.8 Use of the Pressure Prism Concept GIVEN A pressurized tank contains oil (SG = 0.90) and has a FIND What is the magnitude and location ofite square, 0.6-m by 0.6-m plate bolted to its side, as is illustrated in on the attached plate? Fig. E2.8a. The pressure gage on the top of the tank reads 50 kPa, and the outside of the tank is at atmospheric pressure. +8613) 92049572 p= 50 kPa nole- Pls cntacime Nia what ap- beQuse Ia mm Oil surface Alr 2.6'm ebara girl Oit. 0.6 m 0.6 m 0.2 m Plate :Yth, - h,) ta) (b)

XAMPLE 2.8 Use of the Pressure Prism Concept GIVEN A pressurized tank contains oil (SG = 0.90) and has a FIND What is the magnitude and location ofite square, 0.6-m by 0.6-m plate bolted to its side, as is illustrated in on the attached plate? Fig. E2.8a. The pressure gage on the top of the tank reads 50 kPa, and the outside of the tank is at atmospheric pressure. +8613) 92049572 p= 50 kPa nole- Pls cntacime Nia what ap- beQuse Ia mm Oil surface Alr 2.6'm ebara girl Oit. 0.6 m 0.6 m 0.2 m Plate :Yth, - h,) ta) (b)

Name: EXAMPLE 2.8 Use of the Pressure Prism ConceptGIVENA Dressurized tank
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: EXAMPLE 2.8 Use of the Pressure Prism ConceptGIVENA Dressurized tank contains oil (SG. = 0.90) and has. FIND What is the magnitude and location ofiicresulsquare, 0.6-m by 0.6-m plate bolted to its side, as is illustraäted in on the attached plate?.F

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please include explanation and show handwritten solution
Question 3 pls. Complete solution and units
多95 6 نقاط Two tank with the same fluid at * their base are separated by piston whose weight is (50 N) and (30 cm) diameter, as shown below. Calculate the gage pressure at point A, B and * .C respectively Piston B Air Air 50 cm 30 cm 25 cm E 30 cm Water 90 cm
P1.9 A rubber balloon when fully inflated has a spherical shape with a radius of 0.3 m. The absolute pressure inside the balloon is 103 kN m²2 and the local barometric ambient pressure is 750 mm of mercury. By considering the equilibrium of a hemispherical portion of the balloon, calculate the tension in the rubber membrane per unit circumferential length. Neglect the effect of the thickness of the balloon. [Answer: 0.44 kN
An aquarium 7ft long, 3ft wide, and 5ft deep is full of water. The gravitational acceleration is g = 32ft/s². The density of water is p = 1.95slug/ft³. Answer the following questions. 1. Find the hydrostatic pressure on the bottom of the aquarium. Answer (in pounds per sq. foot): 2. Find the hydrostatic force on the bottom of the aquarium. Answer (in pounds): 3. Find the hydrostatic force on one end of the aquarium. Answer (in pounds): FI
Please show ALL calculations step by step
2.78 An automobile has just dropped into a river. The car door is approximately a rectangle, measures 36 in. wide and 40 in. high, and hinges on a vertical side. The water level inside the car is up to the midheight of the door, and the air inside the car is at atmospheric pressure. Calculate the force required to open the door if the force is applied 24 in. from the hinge line. See Fig. P2.78. (The driver did not have the presence of mind to open the window to escape.) 36" -24" V 40 ■FIGURE P2.78
Directions: Solve the following problems completely, and make a detailed solution. Any incompletesolution arriving at such answers will never be considered. A barrel contains a 15 cm layer of oil of density 5.88 kN/m3 floating on water that is 30 cm deep. What is the gauge pressure in mmHg at the oil-water interface?
A 30 m high vertical column of a fluid of density 1878 kg/m³ exists in a place where g = 9.65 m/s². What is the pressure at the base of the column.
P1.6 A U-tube manometer A is attached to two vertical tubes B and C as shown in Fig. P1.6. The cross-sectional areas of the tubes A, B and C are 80 mm?, 600 mm² and 900 mm? respectively. The specific gravities of the liquids in B and C are 0.75 and 0.85 respectively. Initially, the interface between the two liquids is on the side of the U-tube connected to B. Due to an increase in the pressure applied to C the interface between liquids rises by 50 mm in the U-tube section A. Determine the increase in pressure in Pa. [Answer: 135 Pa] AP B Final level ---- --- Initial level A. Fig. P1.6 Manometer