X Incorrect The 60-lb boy has taken a running jump from the upper surface and lands on his 12-lb skateboard with a velocity of 14 ft/sec in the plane of the figure as shown. If his impact with the skateboard has a time duration of 0.05 sec, determine the final speed valong the horizontal surface and the total normal force Nexerted by the surface on the skateboard wheels during the impact. 24° 14 ft/sec

X Incorrect The 60-lb boy has taken a running jump from the upper surface and lands on his 12-lb skateboard with a velocity of 14 ft/sec in the plane of the figure as shown. If his impact with the skateboard has a time duration of 0.05 sec, determine the final speed valong the horizontal surface and the total normal force Nexerted by the surface on the skateboard wheels during the impact. 24° 14 ft/sec

Name: X IncorrectThe 60-lb boy has taken a running jump from the upper surf
Uploaded: 2024-03-20T06:57:37.000Z
Channel: Bartleby
Description: X IncorrectThe 60-lb boy has taken a running jump from the upper surface and lands on his 12-lb skateboard with a velocity of 14 ft/sec in theplane of the figure as shown. If his impact with the skateboard has a time duration of 0.05 sec, determine

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Problem 3 Consider a vane used to redirect a stream of water, as shown below. The thin water film has a thickness of 8 = 10 mm and goes deep into the page. Your goal is to determine the reaction force necessary to keep the vane stationary, as well as the instantaneous acceleration in the absence of a reaction force in the x-direction. The velocity of the jet is 20 m/s and 0 = 35°. Assume the system extends into the page 1 m, and the mass of liquid plus cart is 25 kg. 1. Sketch and annotate an appropriate control volume to calculate reaction forces. 2. Assuming Vyane = 0, calculate the rection forces necessary to keep the vane stationary. 3. Calculate the instantaneous acceleration of the control volume in the absence of a reaction force in the x-direction (Voane = 0). 4. Calculate the instantaneous acceleration at the moment the vane velocity is half the jet velocity. Vrane Vjet
Plz
block of mass m= 5 Kg is sent sliding up a large plane inclined at 0 = 37° while a horizontal force of magnitude 50 Newton acts on it. The coefficient of kinetic friction between the block and the plane is u= 0.3, and the coefficient of static friction is us= 0.35. g 5 The blocks initial speed is 4m/s If the blocks slides back, calculate its acceleration (provide magnitude, corresponding unit vector
A 69.0-kg ice skater is moving at 4.09 m/s when she grabs the loose end of a rope, the opposite end of which is tied to a pole. She then moves in a circle of radius 0.900 m around the pole. (a) Determine the magnitude of the force exerted by the horizontal rope on her arms. kN (b) Compare this force with her weight. rope W
m1 A block with mass m, = 8.8 kg is on an incline with an angle 8 = 22° with respect to the horizontal. For the first question there is no friction, but for the rest of this problem the coefficients of friction are: H, = 0.2 and u, = 0.22. 1) When there is no friction, what is the magnitude of the acceleration of the block? m/s Submit You currentiy have O submissions for this question. Only 5 submission are allowed. You can make 5 more submissions for this question. 2) Now with friction, what is the magnitude of the acceleration of the block after it begins to slide down the plane? m/s Submit You currently have O submissions for this question. Only 5 submission are allowed. You can make 5 more submissions for this question. 3) m, To keep the mass from accelerating, a spring is attached. What is the minimum spring constant of the spring to keep the block from sliding if it extends x = 0.13 m from its unstretched length. N/m Submit You currently have O submissions for this question. Only…
A single circular loop of wire of radius 0.25m is positioned in a uniform magnetic field of 0.25T that points out of the page. What is the magnitude of the average EMF induced in the loop if it's orientation changes from being in the plane of the page to out of/into the page over a time period of 0.59seconds?
Problem 1 student tries to help some local kids make a tire swing by throwing a rope over a branch, which is difficult because there are two branches (they should pick a different tree). The lower branch is e = 7 m off the ground and upper is d = 1 m above that. The student throws the weighted end of a very light rope with an initial angle of 0 = 70° releasing it underhand at a = 0.5 m firom the ground while standing b = 6 m from the tree. %3D Determine the range of minimum and maximm initial velocities required to get over the lowest limb (B) without hitting the upper branch (C).
A 72.5-kg person is riding in a car moving at 18.5 m/s (assume this is the positive direction) when the car runs into a bridge abutment. This problem will illustrate why the invention of the airbag dramatically improved the safety of automobiles. a. Calculate the horizontal component of the average force, in newtons, on the person if he is stopped by a padded dashboard that compresses an average of 0.85 cm. b. Calculate the horizontal component of the average force, in newtons, on the person if he is stopped by an air bag that compresses an average of 16 cm?
25) In a movie stunt, a car leaves an inclined ramp with a speed of 32.0 m/s. The car's mass is 1050 kg and its velocity is 29.0 m/s at the peak of its flight. How high in the air (relative to the location where it left the ramp) is the car at the peak of its flight? Assume that there is no air problem can be done using Kinematics too. g although the v = 32 m/s h = ? m = 1050 kg 0.01 lo ribar a and boa pugi oq anoiudover '01
A small block slides at a speed von a horizontal surface. Knowing that h=04 m, determine the required speed of the block if it is to leave the cylindrical surface BCD when 0 = 35". The required speed of the block to leave the cylindrical surface is m/s
In an experiment conducted at Carleton university, following experimental setup has been prepared. In this experiment, block A is released from rest and strikes cart B. Neglecting the effect of friction, find the maximum displacement s that cart B travels beyond point C. The coefficient of restitution for the collision is e = 0.7. 0.6 m 30 Impact Test 3 kg 60° 1.8 m B 1 kg This region is the arc of a circle
PROBLEMI The 260kg crate shown in the figure rests on a horizontal surface for which the coefficient of kinetic friction is 025. If the crate is subjected to a 400 N towing force as shown determine the velocity of the crate in 5 s starting from rest PROBLEM 2 PROBLEM 3 The 80 kg block A shown in Figure is released from rest If the masses of the puleys and the cord are neglected determine the speed of the 12 kg block B in 38 m₁ P = 400 N IIA 8 = 30° 30° Consider the masses m, 20 kg and m, 18 kg in the system represented by the figure below. If the coefficient of friction is Of and the inclination angle is 30°, find the acceleration of the system and the tension in the cord joining two masses Datum m₂