Write the differential equations of motion, convert to Laplace domain with zero initial conditions. Use: k1= k2= 2, m1=m2= 1, c=1

Q: Applying 'Superposition Theorem', calculate I for the circuit shown in Fig.4 (b). 2KΩ 6KO 15 VA 30…

A: WE NEED TO DETERMINE THE DIRECTED CURRENT IN THE GIVEN CIRCUIT BY SUPERPOSITION THEOREM

Q: For this second circuit, what is the inductor current for t>0 (again a "natural" response, going to…

A:

Q: The Z-transform of a sequence x[n] is 4 3 given as X(z) = 2z+4-=+ Z If y[n] is the first difference…

A: It is given that: The Z transform of a sequence x(n) is, X(z)=2z+4-4z+3z2

Q: Vino- DUT Rg www -+Vs o Vout Figure 2: Impedance meter circuit a) Assuming ideal op amps, find an…

A:

Q: A 30 60-Hz induction motor runs at 715 rpm at no load and at 670 rpm at full load. The slip-torque…

A:

Q: 10.30 Use mesh analysis to find u, in the circuit of Fig. 10.78. Let u,₁ = 120 cos(100r +90°) V, V2…

A: Given that,Vs1=120 cos100t+90°=120∠90° VVs2=80 cos100t=80∠0° VImpedances-300 mH→ jωL=j100300×10-3=j…

Q: please show the solution and answers in each. Thank you

A:

Q: Consider the circuit in (Figure 1). Part A Find the average power delivered by the ideal current…

A:

Q: electrical

A:

Q: A continuous-time signal is given by x(t) = 10e-5tu(t). 1. Determine the frequency response X(jw)…

A: 1)The question is about Fourier transform.By terms and conditions I am doing only first question.

Q: Question: 1) Use superposition technique to determine V, in the circuit given in figure 01. 600 N…

A: Given circuit is: 1. Turn off all independent source except one source 2. If we desire to calculate…

Q: Which of the following is true regarding a portable oloctrical power tool which is double insulated…

A:

Q: Resistor Current Versus Log Frequency 0.016 0.014 0.012 0.01 0.008 0.006 0.004 0.002 0.5 1 1.5 2 2.5…

A: Resonance is the frequency response of a circuit when it's operating at its natural frequency or…

Q: In the circuit shown in (Figure 1), the capacitors are all initially uncharged and the battery has…

A: According to the question as per your requirement, we need to solve the value of part E, F, G. we…

Q: Ri R3 35 fig. 5

A:

Q: 4.6 Use the node-voltage method to find vị in the circuit shown. 60 v 24 N Answer: 48 V.

A:

Q: Problem 4. Use the superposition principle to find io, vo in Figure 3. Vo 6 mA Som frem for 1kQ 2 ΚΩ…

A:

Q: 5.WHAT IS THE CURRENT AND THE VOLTAGE IN THE FOLLOWING CIRCUIT? (VALUE 10% POINTS) | = %3D V =…

A: The power absorbed by the resistor (P) in terms of voltage and current is given by: Where, The…

Q: Signals and systems Only 29. a

A:

Q: A3-phase, 60 Hz, 35 km long overhead line supplies 550 kW at 11 kV, 0.6 p.f. lagging. The line…

A: Given Data: Frequency f = 60 Hz Length l = 35 km Load Power Pl = 55 kW Receiving end voltage Vrl =…

Q: R, = 20 2 En= las R = 20 2 V En R, = 10 2 V R, = 10 2 A %3D En, V=100V R, = 5 à V R, = 15 2 V En R,…

A: When two resistors R1 and R2 are connected in series. their equivalent resistance is Req = R1 + R2…

Q: Clock Construct the State Transition Diagram for the following circuit. Please include all steps. 1…

A: Given

Q: Draw a signal flow graph for the following set of algebraic equations: Y2 = ay₁ - 9Y3 Y3 = ey₂ + CY4…

A: We have to draw the signal flow diagram for the following algebric equations: y2 = ay1 - gy3 y3 =…

Q: ↑ R₂ www 3.3 ΚΩ 5 mA IRI R₁ • 2.2 ΚΩ www units R3 8 V 4.7 k Using superposition, find the voltage…

A: Superposition states that in linear network the voltage across any element (or current through it)…

Q: QUESTION 13 Three capacitors, a 10 micro-F, a 15 micro-F and a 32 micro-F, are connected in…

A: (13) if capacitor are connected in parallel theequivalent capacitance Cth = C1+C2+C3 Cth=10+15+32 uF…

Q: Determine Vab in the circuit below

A:

Q: Let the following symbols be used: Ya1): impulse response Yesa(1) : unit-step response Ys ():…

A: According to the question, we need to calculate the system response under different conditions.

Q: Use the definition of the Laplace transform to determine the Laplace transform, including its ROC,…

A: The signals are given bya. x(t)=−te−αtu(−t).b. x(t)=e−αtsin(ωot)u(t).Where α and ωo are real valued…

Q: Od. 90.35 ohms QUESTION 8 An inductor has an inductive reactance of 24 ohms, and a resistor…

A:

Q: 52 2. Using mesh analysis to find v. in the circuit. 3 V 2Ω ww ww

A: We will apply KVL in two loops to find two equations relating loop currents.  Solving two equations…

Q: For the circuit below, the sources are given in RMS. 592 40/90° V ww +1] 8Ω Ξj2Ω ww 11 12 3/0° A 10…

A:

Q: -A 480 kW, 50 Hz, 3.3 kV, eight-pole-ped wound-rotor induction motor has the following parameters…

A: Since you have posted a question with multiple sub-parts, we will solve the three sub-parts for you.…

Q: 1. In the system in Figure E.1, x,(t) = sinc(t), fc = 10 and the cutoff frequency of the lowpass…

A: Given the system a shown below: xt(t)=sinc(t), fc=10 and the cut-off frequency of the low-pass…

Q: or the given circuit switch is opened at t=0 after being closed for a long time. =40 Ohm, C=25mF,…

A:

Q: Find the node voltage V.

A: According to Kirchhoff's current law, the sum of all the currents leaving a node is always zero.

Q: QUESTION 12 In an RL parallel circuit, ET = 120 V, R = 15 ohms, and X L= 20 ohms. What is the power…

A: Answer 12:  Given that R= 15 ohm XL= 20 ohm

Q: Electrical Principles Part B: Superposition Principle Objective: - To build and make measurements on…

A: Given Data:A DC resistive circuit of,The measured values of the circuit parameters…

Q: Q: I need an Introduction for my report about this experiment : Speed control of seperately Excilted…

A:

Q: 1. The current density J 5ay A/m2 for z| 2 m. (b) Repeat part (a) for 0 2 m assuming Vm 0 at P(0,…

A: c)Determine Vm for z>2 m assuming Vm=0 at P(0,0,2). d)Determine A for 0<z<2m assuming A=0…

Q: 9. If vi(t) = 10 cos(150t) V A) 9.2 V B) 6.2 V what is the amplitude of vo? C) 8.3 V D) 5.6 V

A: In the question 9 We need to determine the amplitude of the output voltage Vo  as shown the circuit.…

Q: 1. a) b) c) Given the circuit shown below. The variable L takes its value as a function of t. R=3N…

A: As per the honor code I will do only first three parts of the question. Kindly repost the other…

Q: 3. For an linear time invariant continuous system, an input x(t) produces an output y(t) as shown in…

A: Since you have posted a question with multiple subparts we will provide the solution only to the…

Q: Find (a)V₁ and (b)V₂ in the circuit in the figure using nodal analysis. + 8 mA 4 ΚΩ +

A: Circuit is given that

Q: In the network below, find the power associated to the current source, for V1 = 4 V. Vi + 2 A ( 14 V…

A:

Q: For a sinusoidal input of 2 sin (3t-30), the output has: 1. A phase of 0°. ii. A magnitude of 5. A.…

A: Given data, Transfer function is given by, Gs=1s+1.

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.