Write legibly, provide manual step by step solution, and diagram for below given problem. A 100 mm diameter 4-spline shaft ( d= 0.75D, w= 0.24D, h= 0.125D ) and to slide when not under load has a compressive force of 2100 lbs. Find the compressive stress if

Q: Q.4: A shaft subjected to tensile load has stress-strain curve is define by 125+185 01 find the…

A:

Q: Problem 8-53: The coiled spring is subjected to a force P. If we assume the shear stress caused by…

A: Given Data:A coiled spring is subjected to a force P.The shear stress caused by this force on any…

Q: A steel bolt 25 mm in diameter carries a load of 4 kN in tension. Estimate the tensile stress of the…

A: Given data Load= 4 kn Diameter of bolt = 25 mm Diameter of thread = 20 mm Find the tensile stress at…

Q: ! Required information The steel eyebolt shown in the figure is loaded with a force F= 86 lbf. The…

A:

Q: THE ORIGINAL QUESTION IS: For the beam shown, find the reactions at the supports and plot the…

A:

Q: Problem 1: In the figure below a solid bar with a 1.00 in diameter is subjected to a bending moment…

A: Given data, Diameter of the solid bar, d = 1 in Twisting moment and bending moment are equal, i.e.,…

Q: A bar of steel has the minimum properties Se= 40 kpsi, Sy = 60 kpsi, and Sut = 80 kpsi. The bar is…

A: Given:The endurance stress is The yield stress is The ultimate stress is The steady torsion stress…

Q: The cantilevered bar in the figure is made from a ductile material and is statically loaded with Fy=…

A: Load at D in y direction, Fy= 250 lbf (pound force)Load at D in x and z direction is zero, i.e.…

Q: 4 kN 3 kN 375 mm 375 mm B 750 mm As shown in the figure, the shaft is supported by bearings A and B…

A: Given data Material used A36  Diameter of the shaft = 50mm To determine the maximum theoretical…

Q: The A frame shown in the figure is attached to an overhead beam by 2 cap screws, each of which can…

A: To determine the appropriate screw for the given load and conditions, we need to follow several…

Q: 1) Ball bearings support the rotating axle shown below at points A and D. The rotating axle is…

A: Treat the shaft as simply supported beam with supports at A and D.Here  are reaction forces at…

Q: Parvinbhai

A: The objective of this problem is to draw the shear force and bending moment diagrams for a car jack…

Q: Q2: Figure (2) shows a rotating shaft, simply supported at bearings atA and B. The shaft is loaded…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.