Write assembly instruction sequence for the following instructions: (a) Load a data at memory location $C100 into [ACCA] (b) Load another data directly into [ACCB] (c) Add both the data and leaves the result in accumulator A (d) Subtract the data at memory location $C101 from accumulator A and leaves the result in ACCB. (e) Store the result at address $C102.

Q: Convert the following program to assembly - using the Assembly syntax. In the table below, enter the…

A: We need to convert the given program to assembly - using the Assembly syntax.

Q: 1. List all the types of addressing modes, explain them with example

A: Kindly Note: As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Convert the following high-level code into RISC-V assembly language. Assume that the signed integer…

A: Assembly language is a low-level programming language used to communicate directly with a computer's…

Q: Create an entry for the execution cycle of the instruction "ADD E" using the Register Transfer…

A: example entry for the execution cycle of the instruction "ADD E" using Register Transfer Notation…

Q: For the following MIPS assembly instructions what is the corresponding C statement? Assume that…

A: After the addi, register $t0 will be the memory address of A[1] which would be not A[1], but…

Q: construct the program for our imaginary computer!   There must be made of at least 5 instructions…

A: Assembly language which refers to the  a low-level programming language that are used for a computer…

Q: Consider the following registers - AX contains 1122h, BX contains 3344h, CX contains 5566h and DX…

A: ANSWER:-