wrapped around a spool of weight W with inner radius r and outer radius R as shown above. The rope is pulled with a tension T at an angle e. Which of the following conditions must be satisfied for the spool to slide uniformly without rolling? (A) cose = r/R (B) sine = r/R (C) T = W DT=W sine (E) T= W cose L axis L 2m 18. A point object of mass 2m is attached to one end of a rigid rod of negligible mass and length L. The rod is initially at rest but free to rotate about a fixed axis perpendicular to the rod and passing through its other end (see diagram above). A second point object with mass m and initial speed v collides and sticks to the 2m object. What is the tangential speed vt of the object immediately after the collision? ט (A) (B) (C) 1-1 3 2 V √ √ (D) (E) 2 allm W ME MET муз M=2 THM 2 2m² v=

wrapped around a spool of weight W with inner radius r and outer radius R as shown above. The rope is pulled with a tension T at an angle e. Which of the following conditions must be satisfied for the spool to slide uniformly without rolling? (A) cose = r/R (B) sine = r/R (C) T = W DT=W sine (E) T= W cose L axis L 2m 18. A point object of mass 2m is attached to one end of a rigid rod of negligible mass and length L. The rod is initially at rest but free to rotate about a fixed axis perpendicular to the rod and passing through its other end (see diagram above). A second point object with mass m and initial speed v collides and sticks to the 2m object. What is the tangential speed vt of the object immediately after the collision? ט (A) (B) (C) 1-1 3 2 V √ √ (D) (E) 2 allm W ME MET муз M=2 THM 2 2m² v=

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 76P: The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4...

See similar textbooks

Similar questions

A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?
The band brake of Fig. is used to control the rotation of a drum. The coefficient of friction between the belt and the drum is 0.30 and the weight of the handle is 15 N. Determine the force P that must be applied to the end of the handle to resist a maximum toraue of 75 N m if the torque is applied Clockwise. mm 60 80 80 240 mm mm mm mm
To polish a filling, a dentist attaches a sanding disk with aradius of 3.20 mm to the drill. (a) When the drill is operated at2.15 * 104rad>s, what is the tangential speed of the rim of thedisk? (b) What period of rotation must the disk have if the tangential speed of its rim is to be 275 m>s?
A solid cylinder haas a mass off 1.39 kg and a radius of 0.398 m. The cylinder is placed on an inclined surface and released from rest. The cylinder accelerates down the incline at a rate of 2.42 m/s^2, What is the manitude of the static frictional force that acts on it?
A steel wire 2 mm diameter is held between self aligning bearings. The wire weighs 0.241 N/m and the flexural stiffness is 0.157 N.m2. If the highest critical speed is 5000 RPM with the length of the wire 1.0m, what is the approximate number of mode (n=?).
A 2kg disk has a radius of 18cm and rotates with an angulas acceleration of 12 rad/s^2 about an axis through its center and peroendicular to the plane of the disk. Determine the tangential force at the rim of the disk.
Cable is unwound from a spool supported on small rollers at A and B by exerting a force T = 300 N on the cable. The spool and cable have a total mass of 540 kg and a radius of gyration of ko = 1.2 m. For the calculation, neglect the mass of the cable being unwound and the mass of the rollers at A and B. The rollers turn with no friction. (Figure 1) %D Figure < 1'of 1 T 300 N 1.5 m o.s.m 30 1 m
A drum is used to drag a [ma]-kg block A up the slope (0 = [0]°). The coefficients of static and kinetic friction between the block and slope are 0.5 and 0.3 respectively. The [mp]-kg drum has a radius of 0.6 m and a radius of gyration of [k] mm. A constant torque of [t] Nm (CCW) is supplied to the drum. Assume the drum pivot is frictionless. „Lightweight cable A 0 T (a) Draw clear free body diagrams of block A and the drum. Values (b) Calculate the acceleration of block A and the tension in the cable. 24.1 MA 13.6 8.4 나나8 mp = k = 149
Calculate the tension force on the rope. Calculate the torque produced by the tension about the axis of rotation .
Cable is unwound from a spool supported on small rollers at A and B by exerting a force T = 300 N on the cable. The spool and cable have a total mass of 480 kg and a radius of gyration of ko = 1.2 m. For the calculation, neglect the mass of the cable being unwound and the mass of the rollers at A and B. The rollers turn with no friction. (Figure 1) Part A Compute the time needed to unravel 5 m of cable from the spool. Express your answer to three significant figures and include the appropriate units. Value Units t= Submit Request Answer Figure Provide Feedback Next > T= 300 N -15m0.8m- 30° to -1m-
A 57.5-kg grindstone is a solid disk 0.6 m in diameter. You press an ax down on the rim with a normal force of 164.9 N. m The coefficient of kinetic friction between the blade and the stone is 0.7, and there is a constant friction torque of 9.5 N m between the axle of the stone and its bearings. Another force is applied tangentially at the end of a crank handle 0.5 m long to bring the stone from rest to 164.1 rev/min in 8.1 s. After the grindstone attains an angular speed of 120 rev/min, what tangential force at the end of the handle is needed to maintain a constant angular speed of 120 rev>min? *1 = 1/2 MR2