Width U/S of dam = 48.7 , length of spillway = 9.2, head above crest = 10.3 if approach velocity will not effect ,then height of water U/S dam above the crest will be greater than 9.729 A 217.495 .B 1.95.C 272.614 .D

Width U/S of dam = 48.7 , length of spillway = 9.2, head above crest = 10.3 if approach velocity will not effect ,then height of water U/S dam above the crest will be greater than 9.729 A 217.495 .B 1.95.C 272.614 .D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 12. Find the discharge over the rectangular, sharp-crested weir shown below. Elev. 121.32 Crest…

A: Given above sharp cresred weir with H = 121.32 - 120= 1.32

Q: Water is flowing through a rectangular channel at 60 ft3/s. The channel is 5 ft wide, n = 0.012,…

A: Reference : Fluid mechanics, Flow in rectangular channel. Given : Flow, Width and bump height To…

Q: The two-stage weir below is at the right edge of the reservoir. If the water elevation is as shown…

A: Elevation of water surface = Elev. 610.50' To find:- Flow over the weir Concept:- Discharge flow…

Q: Ex 4: Water flows at 600 ft/min in a right triangular flume for which n=0.012. Find the critical…

A: step 1-

Q: What should be the slope of a planed-timber flume, rectangular in cross-section, to carry 0.80 m³/…

Q: A flow rate of 2.1 cu.m./s is to be carried in an open channel at a velocity of 1.3 m/s. n = 0.020…

A: Find slope for each case

Q: Consider uniform water flow in a 5m wide channel made of unfinished concrete laid on a slope of…

Q: A 1 km long trapezoidal, concrete-lined (n = 0.013) channel is required to convey water at 10 m3…

A: A trapezoidal channel is an open channel with a trapezoidal cross-section where both sides have the…

Q: In a rectangular open channel, 2.0 m wide, water flows at a depth of 0.8 m. It discharges over an…

A: given- width B=2 mdepth y=0.8 mCc=0.612g=4.43H=0.25 m

Q: A pump draws water from a reservoir A (EL 0m) and lifts it to reservoir B (EL. 80m), the headloss…

A: Given: The flow rate is 15 L/sec. The diameter of the pipe at point 1 is 15 cm. The diameter of the…

Q: Find the critical depth of a rectangular channel having a width of 6 ft. which carries a discharge…

A: Given data Type of the channel = Rectangular Width of the channel (B) = 6 ft Discharge (Q) = 120…

Q: An artificial lake is impounded by an earth dam with a square-edged orifice 12 inches by 12 inches…

A: Square Edged Orifice with dimensions 12 in by 12 in Elevation of surface of lake = 928.75 ft…

Q: Water flows through a gravel (very rough), earth excavated, triangular channel at a rate of 150L/s.…

Q: A trapezoidal channel carry water at a rate equal to 10 m3/sec, Manning's n is 0.02 and bed slope is…

Q: A trapezoidal canal is to carry water at (22,649.7 L/s). The grade (slope) of the canal is So, the…

Q: Q2: A circular concrete culvert of diameter 120 cm carries water of depth 75 cm to irrigate a…

Q: B Ye 1 3.

Q: A 180 degree horizontal bend narrows from a 14in. diameter upstream to a 10in. diameter downstream.…

A: Since the question comprises of a number of subparts, the solution for first three subparts is as…

Q: ater flows in a trapezoidal channel with side slope 1V:3H, bottom width of 16ft and water depth of…

A: V= 4.885 ft/sec

Q: 14.5 15.0 14.5 region 2 region 1 region 3 4 10 10 2 5

Q: Example: A concrete-lined trapezoidal channel (n 0.015) is to have a side slope of 1.0 horizontal: 1…

A: Prismatic channels are those channels in which cross-sectional shape, size, and bed slope are…

Q: Find the width (in m) of an elementary gravity dam whose height is 150 m. Specific gravity of dam…

A: Height H=150 m Specific gravity S=2.3 Seepage coefficient C=0.6 It is needed to find the width B…

Q: A trapezoidal channel has n = 0.022 and s = 0.0003 and is made in the shape of a half-hexagon for…

Q: What will be the depth of flow in a trapezoidal concrete-lined channel that has a water discharge of…

A: It is required to determine the area of trapezoidal channel. A=B+zyy Here B is the bottom width, z…

Q: An open channel with n=0.011 is tc slope of 0.0065. Find the most effic a. A rectangular b. A…

Q: 2. A rectangular concrete canal is to carry O.152cms.The bottom width is twice the depth. What…

Q: 2-3 A channel of rectangular cross section and width 4 m is carrying a discharge of 2 m3/s at a…

Q: The discharge in a channel with bottom width 3 m is 12 m³ s¹. If Manning's n is 0.013 m nd the…

Q: The bankfull dimension of the Little Alamance Creek at this same spot is diagrammed in the…

A: Area of bank, A = 12a+bh =12×22+30×12 = 312 ft2…

Q: A rectangular section 2.5m wide carries a flow of 5cu.m./s/ Find the critical depth, the critical…

Q: Uniform flow We will observe the stretch of the Salt River below Stewart Mountain Dam, Arizona. If…

A: A rectangular open channel flow is given, Discharge,Q = 150 cfs Width, B = 60 ft Slope, S = 0.001 n…

Q: What should be the slope of the planed-timber flume (n=0.009) rectangular in cross-section to carry…

Q: The upstream channel width = 322 ft; depth = 8.6 ft. The discharge is 27,300 cfs and is all…

A: Channel width= 322 ft depth= 8.6 ft Q= 27300 cfs S0= 0.004 (ft/ft) wing wall width= 122 ft…

Q: ortando anyn 18. A rectangular section 2.5 m wide carries a flow of 5 m³/s Find the critical depth,…

A: step 1-

Q: The flow depth in a long trapezoidal channel (bottom width = 8 m, side slopes 1:1) for a flow of 28…

A: Given : Bottom width = 8m Side slopes = 1:1 Q = 28 m3/s Bottom slope = 0.0001 To Determine : Flow…

Q: The normal depth of flow in a rectangular channel (2 m deep and 5 m wide) is 1 m. It is laid to a…

Q: For a triangular channel with the horizontal dimension of the side slope is 3 (i.e Z-3), a normal…

Q: A rectangular channel (n = 0.014) 7.09 ft. wide is to carry water at a flow rate of 3.502 ft3/s.…

A: The critical slope of the flow measured from the discharge equation,…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Width U/S of dam = 48.7 , length of spillway = 9.2,
head above crest = 10.3
if approach velocity will not effect ,then height of
water U/S dam above the crest will be greater than
9.729 .A
217.495 .B
1.95.C
272.614 .D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

create the jump. [0.61 m] 4. A river is 30 m wide and has a rectangular shape. At a bridge location the flow width is restricted to 25 m by the piers of the bridge and the river bed is approximately horizontal. Describe the flow which obtains underneath the bridge with minimum upstream depth when a flood of 450 m/s flows in the river
3) Water flows in a triangular V-Notch steel channel, with vertex angle of 60°, at a velocity of 1.2 m/s. Find the normal depth of flow if the channel is laid on a slope of 0.0017. Use n=0.014.
Q.4] An inverted siphon was used to pass a discharge of canal under the main road with 0.2m head loss. The inner dimensions of this siphon are (1.5X1.5)m, safety screen used at entry and exit. The elbows of 22.5 degree were used in this siphon. Find the discharge of the canal. given the following site dimensions. Manning n of the siphon= 0.013, cross section area of the canal = 6.8 m². k₁=0.2, K₂=0.3, kscreen= 0.2, Kelbow 0.05, length of siphon=(15+20+15)m. Sketch the structure with all details.
A triangular shaped channel having a slope of 0.0001with a depth of 1.215 m..It is made of timber with n=0.012.Calculate the discharge of the channel using the best hydraulic or the most economical triangular section Select one: O a. 0.4371 cu m/s O b. 0.6982 cu m/s O c. 0.5892 cu m/s d. 0.6434 cu m/s O e. 0.3092 cu m/s
A triangular channel with side slope 3H:1V, n=0.012, is to carry a flow rate 10 m3/s find the critical depth choices: 1.178 7.811 1.781 7.118 A triangular channel with side slope 3H:1V, n=0.012 is to carry a flow rate 10 m3/s Find the critical slope Choices: 0.181 0.811 0.0118 0.00181 NOTE: this ia not a graded questions please help us in this question so that we understand how to solve this and please base your answer on the given choices thank you in advance
1. A triangular channel with side slope 3H:1V, n=0.012, is to carry a flow rate 10 m3/s. Find the critical slope. a. 0.00181 b. 0.181 c. 0.0118 d. 0.811 2. A discharge of 4m3/s occurs in a rectangular open channel 1m wide with s=0.002 and n=0.0145 Find the normal depth in m a. 9.51 b. 5.91 c. 1.95 d. 1.59
laid on a slope of 1 in 4 000? 10.16. At what depth will 400 cfs flow uniformly in an earth- lined (n = 0.025) trapezoidal canal of base width 15 ft, having side slopes 1 on 3, if the canal is laid on a slope of 1 in 10 000? 10.17. Calculate the depth of uniform flow for a flowrate of
A trapezoidal channel of bottom width 25 ft and side slope 1:2.5 carries a discharge of 450 cfs with a normal depth of 3.5 ft. The elevations at the beginning and end of the channel are 685 an 650 ft., respectively. Determine the length of the channel if n = 0.02.
Q3/ The width of the trapezoidal channel is (2 m) and side slope (Z = 1 m). The discharge through of open channel is (2 m³/sec). Find the critical depth.
On a property, water is pumped from point A at the bottom of a hill to point B on top of the hill via a cast iron pipe at a flow rate of ?=Q= 0.06 ?3/?m3/s. The total pipe length is 173 ?m of diameter 0.14 ?m, and the elevation difference between A and B is 27 ?m. Between points A and B it is required to use 20 of the 90?90o flanged smooth bends (???=KLB= 0.19) and 5 of the fully open gate valve (???=KLG= 0.22). The entrance and exit losses are 0.54 and 1.3, respectively. Calculate the minimum pump power required to pump water from A to B, given that the pump efficiency is 0.76. Density and viscosity of water are 1000 ??/?3kg/m3 and 0.00131 ??/?.?kg/m.s, respectively.
What is the normal depth of the flow in a trapezoidal channel with side slopes of 3:2 (VH), bottom width of 3m and channel slope of 0.0008, if the discharge is 40m³/s and the Manning's n is 0.013? Lütfen birini seçin: a 1.533 m b.1.868 m. c.1.142 m d.2.164 m
At what depth will water flow in a 4-m wide rectangular channel if n=0.018 so 0.0009 and Q=7 meter cube/sec