Why should rain gauge be at least 30m away from the nearby obstruction
Q: The side of a hill makes an angle of 12° with horizontal. A wire is to be run from the top of a 60-m…
A: Given data, Angle of hill = 12° Wire run from top tower = 60 m Stack located down from hillsides =…
Q: All data are in feet. The elevation of BM-A is 1364.58 feet. Rod readings are as follows: +S on…
A:
Q: The backsight to a BM is 3.125 m and the FS from the same instrument set up is 3.625 m. If the…
A: Given Data, Distance from level to BM = 3850 m Distance from level to TP = 4714.05 mCalculate the…
Q: Just because there is a BIM, that doesn't mean all possible BIM Uses need to be harnesse during…
A: True
Q: Given the following differential level notes: STA ELEVATION BS HI FS 1.73 346.50m BM-A TP 1 i.85…
A: Given height of instrument method HI = elevation + BS elevation = HI - FS given elevation of BM a =…
Q: 2. Determine the absolute pressure of the water in the pipe at B if the tank is filled with crude…
A:
Q: TWO STATIONS ARE AT THE WATER LEVEL ON OPPOSITE SHORE OF A BAY 18 KM. WIDE. IF THE LINE OF SIGHT IS…
A:
Q: Compute for HD if the upper, middle and lower hair readings in a three-wire levelling are 2.79m,…
A:
Q: Find the height of the building if the angle of elevation of its top is 61° 37’ when seen from a…
A: Given angle of elevation = 610 37' distance from the ground L = 675.4 m Let H be the height of the…
Q: (c) A Dumpy Level was place at the mid point C of A and B which were 200 ft apart. The staff…
A:
Q: Why is it advisable to set up a level with all three tripod legs on, or in, the same material…
A: It helps in settlement to be consistent in the material as well as provide the firm surface so that…
Q: In which situations are wet ESPs (WESPs) used?
A: Solution: A wet electrostatic precipitator often used to PM emissions in the exhaust gas streams…
Q: A leveling staff setup on point R of elevation (-8.79 m), is observed from point A where the three…
A: According to given Data leveling staff setup on point R of elevation = -8.79 m is observed from…
Q: Profile Level Notes: The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus…
A: Given The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus sight) on STA 0+00…
Q: A transit with an internal focusing telescope and with a stadia interval factor of 100 was set at…
A:
Q: SITUATION 5. A column 600 mm in diameter is reinforced with 8-25mmø bars and 12 mm spirals spaced at…
A: Question is based on the reinforced column . Diameter of column , reinforcement and other design…
Q: Continuation from Question no. 3: Determine the horizontal reaction at C. B 76.33 KN 75.33 KN 74.33…
A:
Q: A 300mm x 400mm RC column is reinforced with b vertical bars, three bars in each 300mm face.…
A:
Q: Problem Statement Based on Problem 5-47 from the textbook. Determine the reactions at the pin A and…
A: Reactions at A Tension in cord
Q: USE SLOPE DEFLECTION METHOD. From the indeterminate beam shown, find the fixed end moment at D,…
A: The moments developed in beams with both ends fixed is called Fixed End Moment.
Q: Discuss the following: 1. Taping on Level Ground 2. Taping on Sloping ground 3. Breaking the tape
A: Taping is generally the linear measurement of the horizontal distance between two points using a…
Q: A billboard 5m high hangs on a vertical wall so that the bottom edge is 4m above an observer's eye.…
A: The correct answer is 6m
Q: 15.1 Refer to the infinite slope shown in Figure 15.47. Given: B = 25°, y= 17.8 KN/m', d' = 28", and…
A:
Q: Given the data shown: What is distance AB? 1. What is distance BC? a. 13.21 c. 12.03 b.…
A:
Q: The angle of elevation of the top of the tower at two points 30 m. and 80 m. away from the foot of…
A:
Q: Profile Level Notes: The elevation of BM A = 628.99' BS (plus sight) on BM A = 4.30' %3D IFS (minus…
A: Given Elevation , backs sights and Intermediate sights/Fore sights .
Q: Delermine maximum upward reaction at C and A if there is d0 KN point load, as KN/m uniformly…
A: Given data in question Loads Point load UDL Span member length To find out Maximum upward…
Q: Complete a set of differential leveling field notes for the simulated survey below. Perform a…
A: Data given Find: (1) the RL of all stations (2) Mathematical error check (3) Allowable error check
Q: Determine the maximum compressive force at member HL due to an 8kN point load.
A: Answer Let us first draw the ILD for member HL Pass a section through member HL as shown below…
Q: Q2: Find the centroid for the next shaded area. 1m Im 1 Y 1.5m 1m
A:
Q: 12 - How many grades does our Earth rotate in 66 hours? A) 990 B) 1100 C) 2200 D) 3.96 E)…
A: Earth rotates about 15o in one hour. Rotation of earth in 66 hour = 66×15o=990o
Q: Q1)In the figure below, readings A(4.917,2.087)m, B(3.050,0.504)m. Compute:- 1- Elevation A. 2-…
A: Given data Point A and B and there respective co ordinates. Elevation of point B is already given.…
Q: List 3 equipment used in taping over level and sloping ground.
A: The equipment's used in taping over level and sloping ground are 100 meters steel tape, range poles…
Step by step
Solved in 2 steps