The side of a hill makes an angle of 12° with horizontal. A wire is to be run from the top of a 60-m tower on the top of the hill to a stake located 36 m down the hillside from the base of the tower. What length of wire is needed in meters? A. 79.65 m B. 76.12 m C. 72.54 m D. 82.45 m E. None of the above OA OC

The side of a hill makes an angle of 12° with horizontal. A wire is to be run from the top of a 60-m tower on the top of the hill to a stake located 36 m down the hillside from the base of the tower. What length of wire is needed in meters? A. 79.65 m B. 76.12 m C. 72.54 m D. 82.45 m E. None of the above OA OC

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the magnitude and direction of reactionu at the rupports. All measureme ntr are in meters. 121 N/m 4
A built-up beam made from fastening two channels to a wide flange section carries loads as shown. The fasteners are 12mmØ bolts with allowable shear stresst = 110 MPa. For bearing 0h= 220 MPa for single shear, and op= 275 MPa for double shear. E= 200 GPa. F= 420 MPa a. Determine the maximum bending stress on the section b. Determine the maximum shearing stress at Neutral Axis.
1.Calculate the magnitude Vp of the componentvp
Please give me correct ans please
Q3) From the figure below Compute :- 1)Elevation of point B 2)Elevation of point C 3)Height of the tower Ym 1.6m to atte ВО A elev-90m 120 120m Tower 20³.
A 350 mm x 500 mm rectangular beam carries a uniform dead load of 4.5 kN/m (including its own weight) and uniform live load of 3 kN/m. If a concentrated live load P 150 kN was added as shown in the figure, a) calculate the tension steel area required to support the loading. b) determine how many 20 mm diameter rebar was needed. c) draw the cross-section of the reinforced rectangular beam.
Show complete solution and answer in the nearest 4 decimal places. An engineer's transit is setup at point B which has an elevation of 145.65m above MSL. Point B issituated between points A and C. Point B is the lowest among the three points. The horizontal distance BA and BC are 180m and 200m respectively. The rod reading at A is 1.50m with the line of sight inclined 15 degrees with the horizontal. The rod reading at C is 1.95m with the line of sight inclined 35 degrees with the horizontal. The height of the instrument/transit is 1.10m from the ground. a) What is the difference in elevation of point A and C? b) What is the elevation of point €?
Choose the correct answer in the choices with solution thank you! I need asap after 5minutes thank you so much
1141.) A boy running a foot racc rounds a flat curvo of so ft.rod if ho runs at the rotc of 15 mph, of what angle w/ the vertical will he inolino his body ? Answers: e = 16. 73°
choose the correct answer
A transit was set up 30 meters and 80 meters away from point A and B respectively. The rod intercept at A is 0.23 m while that at B is 0.72 meters. What is the stadia interval factor of the instrument? * 3 points a. 103 b. Not listed on the given choices c. 100 d. 99 e. 102
Find the RAy and RBy. Thanks