Answered: why did you not need to accurately…

why did you not need to accurately weigh out ki used in the standard and unknown analysis for indirect iodometric analysis of copper?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter27: Molecular Fluorescence Spectroscopy

Section: Chapter Questions

Problem 27.9QAP

See similar textbooks

Related questions

Q: Bone is a biomaterial also referred to hydroxyapatite containing mostly calcium phosphate. Related…

A: Sample is a substance that contains all the important and useless components. Analyte is the…

Q: Discuss the general steps in gravimetric analysis.

A: General steps for gravimetric analysis is given below.

Q: Calculate the copper concentration (a) in the diluted sample solution expressed in ppm Cu, and (b)…

A: Here standard addition technique is used to standardize the copper sample in which to a fixed volume…

Q: Which of the following statements is false? A. Temporary hardness is the hardness caused by calcium…

A: Temporary hardness is the hardness caused by calcium and magnesium bicarbonates.

Q: A water sample was analyzed for the total hardness through the reaction between the sample and EDTA.…

A: Given that MM of CaCO3=100.0869g/mol. Standardization of EDTA is given in the question. We have to…

Q: mg Cefuroxime Sodium Powder for Injection with 6mL of sterile water for injection. The reconstituted…

A: Cefuroxime is an antibiotic and is a type of second generation cephalosporin and used for treatment…

Q: What are the advantages and disadvantages of volumetric and gravimetric analysis

A: Gravimetric analysis is a very accurate quantitative analysis .Advantages of gravimetric analysis…

Q: A mixture has thre components. The percentage of sand was determined to be 26.04%, the percentage of…

Q: Arrange the steps of gravimetric analysis in chronological order

A: Gravimetric analysis is a quantitative method of the measurement of the substance on basis of their…

Q: Which among these is the most important piece of data in a gravimetric analysis? Mass of analyte…

A: Gravimetric analysis : Gravimetric analysis, a method of quantitative chemical analysis in which…

Q: To adjust the thiosulfate (S20,2) solution to be used as a titrant in the copper determination,…

A: THe chemical equation of liberation of I2 by KIO3 is given as:IO3- + 5 I- (excess) + 6 H+ → 3 I2 + 3…

Q: analysis

Q: For EACH type of gravimetric analysis: Give actual applications of each analysis. Include the…

A: Gravimetric analysis: It is a quantitative analytical method that is based upon the measurement of…

Q: Five white, 500-mg uncoated ascorbic acid (AA) tablets with an average weight of 0.6100-g were…

A: To calculate the amount of ascorbic acid present in a uncoated ascorbic acid tablet having an…

Q: The iron content of a large lump of ore is determined by taking a single small sample, dissolving it…

A: A random error is a discrepancy that occurs by chance between the observed and actual values of…

Q: A 2.0 g of MgCO3 was dissolved and diluted to exactly 500-mL volumetric flask. If 50-mL aliquot was…

A: Mass of MgCO3 = 2g Mol. Mass of MgCO3 = 84g/mol Volume of dilution = 500ml Volume of aliquot = 50ml…

Q: what is the significance of gravimetry analysis?

Q: 1. What is the MW of the analyte? 2. What is the meq of the analyte? 3. What will be the weight (in…

A: Since you have asked a question with multiple subparts we will answer the first three for you. To…

Q: and in 4) To adjust the thiosulfate (S2O32) solution to be used as a titrant in the copper…

Q: The molarity of a solution is determined by four separate titrations or replicates, where the…

A: Given, Data set of molarity value determined by four separate titration or replicates ,…

Q: Which method of analysis generally is the faster method, gravimetric or volumetric? Why is that?

A: The question is based on the concept of analytical process. we need to identify the faster process…

Q: Calcium in a sample solution is determined by atomic absorption spectroscopy (AAS). A stock solution…

A: According to Beer's law, absorbance of a solution is directly proportional to its concentration.…

Q: 2. The analytical ability of two lab technicians was compared by having each perform analyses for…

A: Given DataAnalyst As.d = 0.12 %N=6Analyst Bs.d. =0.06 %N=5To determine:whether these results suggest…

Q: A 0.1093-g sample of impure Na2CO3( Molecular weight 106) was analyzed by the Volhard method. After…

A: Given: 1) The reaction taking place: Na2CO3 + 2AgNO3 → Ag2CO3 + 2NaNO3 2) The reaction of KSCN with…

Q: how to use Gas Chromatography in Cosmetics Provide a procedure on how to do this example that you…

A: Principle of Gas Chromatography :- Gas chromatography differs from other forms of chromatography in…

Q: What is the practical application of gravimetric method of analysis

A: Gravimetric analysis is the quantitative analysis of an analyte. The composition of the materials…

Q: You want to make a solution of the primary standard sodium oxalate. It has a molecular mass of…

A: Error or Absolute error is the difference between measured and actual values.

Q: A 1.250 g sample of bauxite (the primary ore of aluminum) was analyzed for aluminum. The sample was…

A: Given: Weight of sample of bauxite = 1.250 g Mass of Al2O3 recovered =0.2890 g Mass of Ash = 0.0007…

Q: Five white, 500-mg uncoated ascorbic acid (AA) tablets with an average weight of 0.6152-g were…

Q: You are preparing a 100.0 mL standard solution needed for titration analysis. The NaOH (40 g/mol)…

A: ff

Q: Identify and explain the mistakes made in the following laboratory protocols: A 1250 mg sample of…

A: Before measuring the mass of any chemical compound, it is quite necessary to adjust the balance to…

Q: A student determined fluoride in a toothpaste sample using ion chromatography. A toothpaste sample…

A: To solve this problem, we need to use the given concentration of fluoride in the toothpaste sample…

Q: You were assigned to assay a product sample of milk of magnesia. A 0.600-g sample was reacted with…

A: Introduction A naturally occurring mineral called milk of magnesia is essential for the health of…

Q: 00 mL of a diprotic acid primary standard solution was accurately prepared to a concentration of…

A: Given: Volume of diprotic acid = 10.mL Concentration of Diprotic acid = 0.1431 M To Calculate: The…

Q: A spectrophotometric method for the analysis of iron has a linear calibration curve for standards of…

A: In a 1 L volumetric cup: CFe3+ is almost 0.5 g/L x (40… 60)/100 = 0.2… 0.3 g/L (around 0.25) The…

Q: The calcium and magnesium in a urine sample were precipitated as oxalates. A mixed precipitate of…

Concept explainers

Applications of Molecular Spectroscopy

When light sources pass through the diffraction grating then light splits into different wavelengths. The light source produces two types of patterns that are shown as destructive and non-destructive. The light source is in the form of quanta that is quantitation.

Question

why did you not need to accurately weigh out ki used in the standard and unknown analysis for indirect iodometric analysis of copper?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What are the criteria for a successful determination in gravimetric analysis?
Which among these is the most important piece of data in a gravimetric analysis? Mass of analyte Mass of weighing form Mass of crucible Mass of precipitating agent
Discuss the general steps in gravimetric analysis.
What is precipitation from homogeneous solution; what are the benefits of this method.
A 0.1093-g sample of impure Na2CO3( Molecular weight 106) was analyzed by the Volhard method. After adding 50.00 mL of 0.06911 M AGN03 (Molecular weight 169.87), the sample was back titrated with 0.05781 M KSCN, requiring 27.36 mL to reach the end point. Report the purity of the Na2CO3 sample.
A 1.250 g sample of bauxite (the primary ore of aluminum) was analyzed for aluminum. The sample was powderized and treated in concentrated nitric acid. The nitric acid was removed and solids were treated in hot water with added nitric acid. Insoluble solids were removed by gravity filtration. The solution was made basic by the slow addition of dilute ammonia forming the gelatinous precipitate (Al(OH), and Al,O,.x H2O). The precipitate was heated to coagulate it then filtered over filter paper. The paper and solids were placed in a porcelain crucible and the paper was ashed while the precipitate was ignited at 600°C to convert the precipitate to pure Al,O,. The mass of Al,O, recovered was 0.2890 g. The average mass of ash after charring 10 sheets of the identical filter paper was 0.0007 g. Calculate the percent aluminum in the bauxite ore sample.
Please provide the correct answers based on the following attached data.
In a gravimetric determination of a soluble sulfate the data gathered is presented (see attachment). Calculate the amount of BaCl2 needed fortitration.
An sample of eggshell that weighs 1.0014g and is 51μm thick is titrated with disodium EDTA. A solution of the 1.0014g sample and 30 mL of HCl is vacuum filtered after being mixed. The product of the filtration is added to a 250mL volumetric flask and is diluted by being filled to the 250 mL mark with deionized water. 10 mL of this diluted mixture is mixed with EBT indicator and titrated with 0.05 M disodium EDTA. It takes 12.3 mL of disodium EDTA to notice a change in color. What percent mass of calcium is in the eggshell?
All of the following criteria must be met for a titrimetric analysis to be feasible EXCEPT: Select one: a. Reaction between the standard and analyte must be known. b. There should be a substance for endpoint detection c. Reaction must proceed quantitatively to completion. d. Reaction between the reactants must be slow.
A water sample was analyzed for Fe content using the iron- phenanthroline method. The following data were obtained from the analysis: Reagent Blank Absorbance Absorbance (au) Reagent Blank Absorbance 0.003 Concentration of Stock Solution: 10 ppm Volume of Stock Solution (mL) Total Volume of Standard Solution Concentration of Standard Solution (ppm) Absorbance (au) (mL) 0.50 10.00 0.012 1.00 10.00 0.132 2.00 10.00 0.267 3.00 10.00 0.349 4.00 10.00 0.428 5.00 10.00 0.560 Volume of Unknown Solution Total Volume of Unknown Solution Trial Absorbance (au) (mL) (mL) 1 5.00 10.00 0.289 2 5.00 10.00 0.296 3 5.00 10.00 0.281 Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r²) A m = 0.1128; b = -4.0 x 10-5; r2 = 0.9880 B m = 0.1128; b = -4.0 x 10-5; r² = 0.9762 C) m = 0.1128; b = -3.0 x 10-³; r² = 0.9880 D m = 0.1128; b = -3.0 x 10-³; r² = 0.9762
A spectrophotometric method for the analysis of iron has a linear calibration curve for standards of 0.00, 5.00, 10.00, 15.00, and 20.00 ppm. An iron ore sample with an expected iron content of 40–60% w/w is to be analyzed by this method. An approximately 0.5-g sample is taken, dissolved in a minimum of concentrated HCl, and diluted to 1 L in a volumetric flask using distilled water. A 5.00-mL aliquot is removed with a pipet. To what volume (10, 25, 50, 100, 250, 500, or 1000 mL) should it be diluted to minimize the uncertainty in the analysis? Explain.