While measuring the discharge in a small stream, it was found that the depth of flow increases at the rate of 0.2 m/h. If the discharge at that section was 50 m⅔ and the surface width of the stream was 10m, estimate the discharge at a 1.5 km section upstream.

Q: View Policies Current Attempt in Progress Water flows over the spillway shown in the figure below.…

A:

Q: Compute the total discharge in the stream based on thẻ given cro 12 18 24 30 distance, m 1.6 1.9 2.5…

A: Assuming same the cross-sectional dimensional through: The average Velocity will be,…

Q: n a rectangular channel 2.5 feet wide with a discharge of 15 cfs and upstream depth of 6 inches,…

A:

Q: While measurement the discharge in a stream it was found that the depth of flow increased at the…

A:

Q: A full width sharp-crested weir with a weir height of P= 0.54 m was installed in a 0.77-m…

A:

Q: The head on a sharp-crested, rectangular weir was incorrectly observed to be 1.8 m. when it was…

A: Given Coefficient of discharge, Cd = 0.979 Crest length, b = 4.09 m Actual head = 3.93 m Incorrect…

Q: Dr. Luma Fadhil hanics of Materials 2nd Class Sec.: F Draw the shear-force and bending-moment…

A:

Q: ← Uniform Flow A wide rectangular channel has a longitudinal slope of 1 in 2500 and its manning's…

A: Given- Wide rectangular channel- Slope S= 1 in 2500, n=0.024, Discharge q=1.8 m3/s/m, It is needed…

Q: Question- The normal depth in a wide rectangular channel is increased by 10%. The percentage…

A:

Q: This problem refers to the sketch shown in Figure 2. If the discharge in the channel (n = 0.028) is…

A: Manning coefficient (n) = 0.028Discharge (Q) = 6 m3/sec Depth of flow (y) = 1.8m Maximum velocity…

Q: Q4/ Determine the state of flow for the following cases: 1. Rectangular channel with area 4 m²,…

A:

Q: (a) Define and explain uniform flow. How is open channel flow different from pipe flow? (b) Under…

A:

Q: Using the data obtained with the help of a current meter having constants a=0.05 and b=23 as given…

A: The cross-sectional area is the area of a two-dimensional object that is obtained when a…

Q: A rectangular open channel carries a discharge of 15 m³/s when the depth of flow is 1.5 m and the…

A:

Q: Question- The normal depth in a wide rectangular channel is increased by 10%. The percentage…

A: Given data- A wide rectangular channel- Normal depth is increased by 10%, To Find- The % increase in…

Q: The following twenty problems refer to a transition in a rectangular channel with a bottom elevation…

A:

Q: n a 1:50 model of a spillway, the discharge was measured to be 0.3 m³/s. The corresponding prototype…

A: Given: A 1:50 model of spillway. The discharge was measured to be 0.3 m3/s. The corresponding…

Q: A Parshall flume is to be designed to measure the discharge in a channel. If the design flowrate is…

A:

Q: Calculate the critical velocity (m/sec) of a channel using Kennedy's theory, the depth of flow is 3…

A: Critical velocity is that velocity at which neither silting nor scouring take place. The channel is…

Q: A 250 waste water pipe is installed on a slope of 0.010 mm/mm and has a roughness n = 0.013.…

A: Hence Velocity (V) = 1.222 m/s Depth of flow = y= 0.125 mExplanation: Step 2: Step 3: Step 4:

Q: Wo

A: A loaded beams have been given and it has been asked to determine shear force, bending moment…

Q: Question- The normal depth in a wide rectangular channel is increased by 10%. The percentage…

A:

Q: Question- The normal depth in a wide rectangular channel is increased by 10%. The percentage…

A:

Q: A rectangular channel of 6 m width carries uniform flow at a normal depth of 3m. If the flow is…

A:

Q: 1.Water flows through a rectangular sharp-crested weir with a channel width of 2 m. The channel…

A: The given data is: Width of channel, B=2 m Channel depth, P=1 m (Height of weir plate) Head of…

Q: A channel of width 450 mm branches into two sub- channels having width 300 mm and 200 mm as shown in…

A: given- main channel width=450 mmflow=0.9 m3/svelocity=3 m/s

Q: Find the diameter of the sewer pipe to carry runoff discharge (m^3 /sec) at full flow condition for…

A: Area of catchment= 100000 m2 Runoff coefficient C = 0.35  Flow velocity in sever = 1 m/sec  Full…

Q: Q3/ determine the discharge in the compound open channel shown in figure assume a bed slope (O.001)…

A: Bed slope (s) = 0.001 Mannings coefficient (n) = 0.03 Area of channel (A) = ( 5 x 0.5 ) + ( 0.2 x…

Q: A 3.5m wide basin at a water treatment plant discharges flow through a 2.5m long singly contracted…

A: Data given Length of weir, L = 2.5 m number of contractions, n = 1 Weir discharge coefficient, Cw =…

Q: Calculate the discharge (m³/s) in a river that is affect by back-water, corresponding to fall (F₂)…

A: given- fall value-F2=1.4 mfall value-F1=0.6 mdischarge for fall value of F1Q1=280 m3/sm=0.5

Q: Question The values given in the table below were obtained from a flow observation station.…

A: Find The total flow.

Q: A rectangular channel of width 500 mm and a uniform flow depth of 250 mm has a discharge of 0.1…

A: Given that....

Q: The discharge was measured in a small stream. It was found that the depth of flow increase at a rate…

A: Given Data  Depth of flow increase at a rate = 0.2m/hr  Discharge at that section (Q2) = 30 m3/sec…

Q: A wide river with a water surface elevation 1/8000 of depth of flow D. If the depth of flow in the…

A: Discharge ratio- Q1/Q2=2.58 Surface slope decrease by 40%, Elevation=1/8000. % change in discharge=?

Q: Calculate the critical velocity (m/sec) of a channel using Kennedy's theory, the depth of flow is 3…

A:

Q: • HW1// Route the flood hydrograph indicated below through a reservoir. The storage (elevation…

A: Given,  Flow=3LH 32 L=70 ft  Crest height=60 ft To determine, Route the flood hydrograph

Q: Water flows through a V-notch weir in a channel 2 m wide. The channel depth is 1 m with a weir head…

A:

Q: A discharge of 4m3/s occurs in a rectangular open channel 1m wide with s=0.002 and n=0.0145 Identify…

A:

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.