Which statement describes a way of facilitating VLAN trunking? a. The VLAN number is contained in a header added to frames b. Use a separate physical connection for each VLAN c. VLAN membership identifiable by means of an IP to VLAN lookup database d. Switches learn MAC addresses by examining the data-link header of incoming frames

Q: Which parts of the IP datagram are subject to variation from one datagram to the next within this…

A: In the context of IP datagrams within a chain of ICMP signals, certain fields experience variation…

Q: Which of the following is a task performed by a NIC and its driver? (Choose all that apply.) a.…

A: Answer: a,b and c

Q: Which protocol is responsible for identifying the physical address associated with a specific IP…

A: Physical address is the address of device also known as MAC address.

Q: QUESTION 19 DNS is a scalable protocol True False

A: As per bartleby guidelines I am solving first question only.

Q: NAT uses port numbers to keep track of packets sent by nodes from within the network. a. True b.…

A: True or false of the given  statements

Q: which layer adds a header to the packet at the sender side coming from the upper layer that includes…

A: Header is added to the packet at the sender side coming from upper layer that includes logical…

Q: ____ is a non-proprietary FHRP protocol that provides mechanism for determining which router should…

A: The correct answer is : (a) Virtual Router Redundancy Protocol

Q: Which Transport Layer Protocols are suitable for each of the ollowing below. Give two reasons for…

A: Which Transport Layrer Protocols are suitable for each of the following below .Give two reasons for…

Q: n a network using datagrams, a new route is calculated _____.

A: c.for every packet

Q: Refer to the below exhibit. What protocol should be configured on SW-A Port O/1if it is to send…

A: Lets see the solution.

Q: 29. Two routers are deployed on the same LAN and both run OSPF. Which of the following multicast…

A: Direct IP encapsulation of OSPF packets is done with the protocol field set to 89. Depending on the…

Q: What parameter is required for EIGRP route redistribution? Exit interfaces and next hop IP addresses…

A: What is an ip address: An IP address is a unique numerical identifier assigned to devices in a…

Q: 4. Study the following output taken on R1: RIsping 10.5.5.5S source 10.1.1.1 Type ape sequence so…

A: Given: R1#ping 10.5.5.55 source 10.1.1.1 Type escape sequence to abort. Sending 5,100-byte ICMP…

Q: 29 Hosts 21 hosts LAN Segment 1 LAN Segment 2 192.168.1.0/24 WAN Link 1 oter WAN Link 2 WAN Link 4…

A: The ip address of the network is given as the 192.168.1.0/24. All the addresses can be calculated by…

Q: 3. How does (NAT) work when you visit an external website from your home computer that is behind the…

A: 3. A Network Address Translation (NAT) is the most common way of planning a web convention (IP)…

Q: 11. The router which is Joining local areas to backbone area in hierarchical structure of OSPS is…

A: Solution:- 11. Routing devices that belong to more than one area and connect one or more OSPF local…

Q: Question 12 As a datagram is transmitted over the Internet, all intermediate routers see the source…

A: Basically , A datagram is used for Wireless Communication and it contains both the address of source…

Q: Q17: Why OSPF has Low Bandwidth Requirements? Q18: What is the name of the router that maintain the…

A: As per guidelines we are suppose to answer only first question :   Open Shortest Path First (OSPF)…

Q: Which layer of OSI model is responsible for delivery of the entire message from the source host to…

A: The transport layer is responsible for the process to process delivery of the entire message.…

Q: 1. Which fields of the IP header change from router to router? 2. Calculate the HLEN value if the…

A: One of the most important parts of network communication is the IP (Internet protocol) header, which…

Q: At a sending machine, a passed from network layer is encapsulated into a by adding data link header…

A: The correct answer of the questions is Option("b") "datagram , segment

Q: In which layer of the OSI model the packets are assigned with port numbers? 1 point       Network…

A: Your question is about In which layer of the OSI model the packets are assigned with port numbers?…

Q: in the figure, assume the destination of the incoming packet is host 10.0.0.1, what should be the…

A: Given that, Destination incoming packet is host 10.0.0.1 Given Network diagram contains one router…

Q: Diagram of frame format on 802.1q encapsulation Configuration of Router and Switches Snapshot of…

A: VLAN: Before VLANs, separate networks were supposed to be created such as LAN1 and LAN2. And the…

Q: During the encapsulation process, what identifiers are added at the transport layer?  Select one: A.…

A: When data arrives at the transport layer, the protocols at that layer begin the encapsulation…

Q: 1) Which of the following does the IP service provide? a) None, IP is an unreliable service b)…

A: An unstable, connectionless delivery mechanism is offered by the IP layer. Its lack of error…

Q: q6-  Which statement is true about the operations of the IPv4 protocol? Select one: A. IPv4…

A: The above question is solved in step 2 :-

Q: Which IP stack layers are processed by a router? Where may link-layer switches be used? Who handles…

A: Your answer is given below.

Q: Lonside that there are links that allow hosts to be connected to trunk ports on switches. 1) What…

A: IEEE 802.1Q is a standard for connecting numerous switches and routers as well as establishing VLAN…

Q: Which of the following is NOT true about the Transport Layer?   a. The Transport Layer protocol…

A: Here, Four options are given.

Q: When talking about connection-oriented demultiplexing, explain how it works in terms of the…

A: DEMULTIPLEXING: The demultiplexed separates the signals and sends them to the nodes. Demultiplexing…

Q: When a router cannot route a datagram or host cannot deliver a datagram, the datagram is message…

A:

Q: What information is used by a link-layer switch in order to help a packet/frame reach its…

A: What information is used by a link-layer switch in order to help a packet/frame reach its…

Q: Which IP stack layers are processed by a router? Where may link-layer switches be used? Who handles…

A: A router processes which levels of the Internet protocol stack? As a result, the routers only…

Q: Which one is true for the following sentence ? " In IP routing path to destination is determined by…

A: Every packet has a whole address for its predetermined destination so that forwarding decisions are…

Q: 35, How to generate a default route? A. Generated by physical layer protocols. B. Generated by…

A: Physical layer protocols are for transporting data dynamic routing protocols like ospf can generate…

Q: Which task is performed by the dynamic routing protocols? * a. discover end devices b. update…

A: As networks increase in size and complexity, using a dynamic routing protocol to provide network…

Recovery and Performance of Network

A network is a group of peripherals, computers, servers, network devices, mainframes, and other devices that are connected to allow electronic communication, and data and resource sharing. The computer network connects the devices either by using cables or wireless fidelity to transmit, share, or exchange both resources and data.