Which one of the following statement is correct? a) Split flow has one input flow and two output flow b) Divided flow has two output flow and one input flow c) Double split flow has two input flow and one output d) Cross flow has two input and two output flows

Q: If an object that has a volume of 10 cubic centimeters is inserted in a liquid, how much liquid…

A: Volume of object (V) = 10 cubic centimeters or 10 cc

Q: A hydraulic lift office chair has its seat attached to a piston with an area of 18 cm2. The chair is…

A: Given data The area of the bigger piston is Ab = 18 cm2 The area of the smaller piston is As = 3.5…

Q: Flow velocity question.

A: Given information: Here, ▽h is the hydraulic gradient and K is the hydraulic conductivity.

Q: A stream having a width of 5.4m carries 16.5 m^3/s of flow rate at a velocity of 4.2 m/s. Determine…

A: Given: W=5.4m, V=16.5m3/s, v=4.2m/s a) The flow depth is found by :  y1=VvW=0.7275m The Froude…

Q: Water flows from point A to point C at a speed of 10m/s through a pipe with an area of 3m^2 and a…

A: Given:   Water flows from point A to point C at a speed of 10m/s through a pipe with an area of 3m^2…

Q: On which principle does the hydraulic lift works? A) Newton's law B) Pascal's law C) Archimedes's…

A: From Pascal's law, the amount of pressure is equally transmitted in all directions. The pressure is…

Q: 1.Using the figure, explain how a countercurrent flow becomes more beneficial than a concurrent flow…

A:

Q: ched to a piston of area 3.83 cm2, what is the mass of the customer that the customer can raise?…

A: GivenForce applied by barber, F1=100 NArea of Hydraulic piston, A1=1.39 cm2=1.39×10-4 m2Chair…

Q: 1.6 A manometer connects an oil pipeline and a water pipeline, as shown. Determine the difference in…

A: Pressure due a column of fluid is given by P = ρgh, where ρ = the density of the fluid, g =…

Q: QUESTION 2 a) With reference to a control volume device, define mass flow rate and volume flow rate.…

A: Solution-(a) Mass flow rate:-Mass flow rate is defined as the rate at which a fixed quantity of mass…

Q: Whater is flowing out a 16.5cm squared circular pipe at 14m/s. a) What is the volumetric flow rate…

A: Area = 16 cm2v = 14m/sdensity of water = 1000 kg/m3

Q: The pressure of a fluid varies with depth h as P = PQ+pgh, where p is the fluid density. This…

A: Given : Pressure =P Depth =h Fluid density =ρ

Q: The maximum gauge pressure in a hydraulic lift is 19.4 atm. What is the largest size vehicle (kg) it…

A: Solution:-   Given that;       The maximum gauge presssure in a hydratic lift is P1 = 19.4 atm…

Q: The flow nozzle in the figure is used to measure the flow rate. if we install the 5 inch diameter…

A:

Q: A hydraulic car lift uses a small piston with a cross-sectional area of 2.50 cm2and a large piston…

A:

Q: For a flow in a restricted pipe, which of the following statements are correct? | а. b = 1 Sov • dA…

A: Option d

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

A:

Q: In the hydraulic press shown, the small plunger has a diameter of 4.5 cm and the large one is 62 cm.…

A:

Q: 22. A hydraulic system is used to lift a 2000 kg vehicle in an auto garage. If the vehicle sits on a…

A:

Q: A dentist's chair with a patient in it weighs 1880 N. The output plunger of a hydraulic system…

A:

Q: What is the pressure at the bottom of a dam if the water is 80 meters deep? remember what is on top…

A:

Q: Two streams merge to form a river. One stream has a width of 8.7 m, depth of 3.1m, and current speed…

A:

Q: 15.2 PQ4A rectangular open channel has a base of length 2h, and the water is flowing with a depth of…

A: (a) Write the given data. Base length=2bDepth=b

Q: T 10 m 70 m -10 m Section A-A 60⁰ 200 m Determine the mass of the concrete required to construct the…

A:

Q: In the figure below, what is the volume flow rate in the lower opening (Point 2) which has diameter…

A:

Q: Two streams merge to form a river. One stream has a width of 8.1 m, depth of 3.9 m, and current…

A: Given that, Let there be two streams, stream 1 and stream 2. They merge to form a river.  For stream…

Q: ia) Write the flow rate relation mass, density and volume. ib) Advantage of SI system of units over…

A: a.  Mass flow rate can be calculated by multiplying the volume flow rate by the mass density of the…

Q: 6. If a hydraulic pump had an input force from a piston of 10 N over an area of 10 square meters,…

A:

Q: The large piston of a hydraulic lift had a cross-sectional area 10 times more than the small…

A: Anwer            200

Q: Two streams merge to form a river. One stream has a width of 8.3 m, depth of 3.9 m, and current…

A:

Q: Detailed work required. Do not use Artificial intelligence

A:

Q: 8. 15 > flow in m/s. Ip! 3

A: According to Continuity equation, the net volumetric flow rate through a tube of flow always remain…

Q: Please don't use Artificial intelligence,Solve in Handwritten format. This is important

A:

Q: The radius of the aorta is about 1.3 cm, and the blood passing through it has a speed of about 40…

A: Given data :  Radius of aorta r1 = 1.3 × 10-2 m   Speed of blood in aorta v1 = 40 × 10-2 m/s  Cross…

Q: Water flows in a horizontal pipe from wide to narrow portion. The wider portion atea is 8 cm square…

A: Given data: Cross sectional area of wider portion A = 8 cm2 Speed of water at wider area (v) = 10…

Q: 1_The volume of water per minutes accumulated in the volumetric bench in flow over weirs exp.…

A: The volume of water per minute accumulated in the volumetric bench in flow over weirs represent the…

Q: Two streams merge to form a river. One stream has a width of 8.1 m, depth of 3.6 m, and current…

A: If two streams of speeds v1 and v2 with cross-sectional areas A1 and A2, respectively, merge to form…

Q: What is the pressure at the bottom of a dam if the water is 74 meters deep? remember what is on top…

A: Given that  Depth of dam h=74m  Atmospheric pressure P0=1.013×1055Pa

Q: 20. The principle of fluid pressure that is used in hydraulic brakes or lifts is that: a) pressure…

A:

Q: Explain when an external flow is two-dimensional ,three-dimentional,and axisymmetric.what type of…

A: The flow over a body can be described as the two-dimensional flow when the body is very large in…

Q: A stream moving with a speed of 0.5 m/s reaches a point where the cross-sectional area of the stream…

A: Speed at a point, v1 = 0.5 m/sConsider the area of cross section is A. New area, A' = original/4 =…

Q: A laser Doppler velocimeter was used to determine the velocity of the water flow in an open channel…

A: Density of a material is given by ρ = mV, where m = the mass of the material, V = volume of the…