Which of the reactions shown can be used to make the given compound? С.Хосно O O O O i ů OH H OH OCH3 NaOCH Catalytic H+ CH₂OH (-H₂O) H₂O+ Catalytic H CH₂OH (+₂0)

Q: show by calculation how could you prepare 500 ml of 0.3N H3PO4 from its concentrated solution has…

A: Molarity is defined as the number of moles of solute in a liter of solution. It is a way to…

Q: When methanol is dissolved n water a conducting solution results. Justify your answer.

A: Ionic substances dissolve in water and conduct electricity due to freedom of motion of ions.

Q: What advantages and disadvantages does water have as a recrystallization solvent?

A: Recrystallization is used to purify chemicals by dissolving both impurities and a compound is…

Q: Step 1 :4.9668 g of Na₂SO3 was dissolved in 30ml distilled water by heating. Step 2: Then 6.0895g of…

A: The objective of this question is to calculate the thereotical yield. The theoretical yield of a…

Q: Discuss the general steps in gravimetric analysis.

A: General steps for gravimetric analysis is given below.

Q: The amount of protein in a sample of cheese is determined by a Kjeldahl analysis for nitrogen. After…

A: Here we have to determine the mass percentage of protein present in sample of cheese in the…

Q: The distribution constant for solute Z. between Water is 3.7. Calculate the remaining consentration…

A: To calculate the remaining concentration of solute Z in the solution, we can use the distribution…

Q: Compare and contrast the conductivity of the salt compound and the sugar compound.

A: The conductivity of salt compound and sugar compound has to be compared and contrasted.

Q: 6. How can you prepare:

A:

Q: How was the precipitate obtained after filtration? (A By scraping from the filter paper and…

A: Filtration- the process in which solid particles in a liquid are removed by the use of a filter…

Q: 0.004343 moles of acetic acid were obtained from titration of an 10.00 mL sample of vinager.…

A:

Q: HO, T-OH, heat HỒ O'HNAN e arrow pushing mechanism

A:

Q: Describe requirement of chemical and physical properties for polymer electrolyte in clear…

A: A polymer electrolyte is a type of material that combines the properties of a polymer matrix with…

Q: 1.

A: “Since you have posted multiple questions, we will provide the solution  only to the first question…

Q: Give detailed solution and please provide explanation of the conceptplease provide answer as soon as…

A: Percent by volume (or %v/v) is expressed as the ratio of the volume of the solute to the total…

Q: Put them in order from most concentrated to least concentrated. А.) А, В, С В.) С, В, А С.) А, С, В…

A: 1 Concentration  is amount of solute  in particular solution.      It has following formula—…

Q: Please explain how you got your answer and/or state the name of the concept. Thank you! oll ? CI

A:

Q: Provide the following: A) Given B) Formula C) Calculations and D) Answer. Find the acid number of a…

A: Acid number can be figure out from the mass of base required.

Q: Part III: Determination of Saturated Solutions Temperature (°C) Molarity (dilute) Molarity…

A:

Q: Predict the trend in solubility of the sodium halides in water using hard and soft acid-base (HSAB)…

A: The halides of Sodium are NaF, NaCl, NaBr, NaI. Cations act as an acid and anions act as a base. Na+…

Q: Which intermolecular interactions must be considered in analyzing the solution of sodium acetate in…

A: When we are analyzing the solution of sodium acetate in water we must consider

Q: COLUMN A COLUMN B COLUMN C A. cuprous sulfate pentahydrate 1. KNO, a. base b. oxyacid c. binary…

A: Introduction In order to identify the name of any particular compound, one should have the knowledge…

Q: Compare the three main purification methods (recrystallization, distillation, and extraction) by…

A: The three main purification methods are recrystallization, distillation, and extraction.. With the…

Q: If 11.45 ml of 0.0523 M S203 2- reacts with 12 in a sample of PVP-I solution, how many grams of 12…

A: Solution: To solve this problem, we need to use the balanced chemical equation for the reaction…

Q: Comparison between the relative amount of precipitation for soft vs hard water soap test.

A:

Q: Give good hand written explanation Asap What volume of concentrated hydrochloric acid solution…

A: Given that -  Number of moles of hydrochloric acid solute = 2.1 mol  We know that most Concentrated…

Q: 6- Term used to describe the stiffening of the cement paste is... 7- is the total surface area of…

A: Introduction :  Cement is made by heating limestone with other material such as clay at 1450°C in…

Q: In the laboratory you dissolve 20.0 g of ammonium phosphate in a volumetric flask and add water to a…

A: Molarity,concentration of cations and anions can be calculated as follows

Q: A sample is analyzed for chloride using the Volhard method. What is the percentage chloride as NaCl…

A: Given, Weight of sample: 303.0 mg AgNO3 used: 40.00 mL of 0.1234 M KSCN used: 12.20 mL of 0.0930 M…

Q: Chem 1121

A: Molarity is given by,Molarity = mole/literThe concentration of diluted solution is calculated by…

Q: No plagiarism please! 11. Describe a method to separate salt from a homogeneous mixture of salt…

A: In this question, describe a method which is used to separate a salt from a homogeneous mixture.

Q: [Review Topics] [References] Use the References to access important values if needed for this…

A: The relation between molality and mole is-  Molality= mole / kg of solvent

Q: LIAIH, 12.

A: The given reaction is opening of epoxide of ring using LiAlH4 as a reagent.

Q: 2. Name the following compounds. H Н. H3C CH₂ Н Н Н. H.C H Та H CH₂ -CI H

A: Cyclohexane chair form is more stable than the other forms. According to IUPAC  1. Follow the lowest…

Q: Oral rehydration salts are stated to contain the following components:   Sodium Chloride 3.5g…

A: The equation to calculate the percentage mass of substance A compared to the mass of B can be…

Q: 2. Consider the Latimer diagram for phosphorus in acidic and basic solutions at 25 °C. Acidic…

A: In a Latimer diagram, the E°overall is calculated as: E°overall=n1E°1+n2E°2+...n1+n2+... where, n1,…

Q: B. Complete the missing standard reduction potentials (x, y and z) for the Latimer diagram in basic…

A: Solution to step B is given as follows:  Latimer diagram is solved by adding the ∆G = -nFEo values…

Q: which of the following compounds likely to produce a Solution that Enducts dectricity (strong…

A:

Aromatic Compounds

Aromatic organic compound or aromatic system is an important class of hydrocarbons under the branch of organic chemistry. Aromatic compounds are also called arenas. The definition of aromatic organic compounds can be stated as a class of organic compounds with a planar cyclic ring of atoms bonded through alternated single and double bonds. Due to these alternating bonds, a peculiar feature termed as ‘resonance’, that is, delocalization of pi electrons or the electrons is shared within the atoms of the ring which are present in the aromatic compounds. The word ‘aromatic’ includes a Greek word ‘aroma’ which means smell, indicating that they were named as such due to the sweet odor they produce. Many well-known flavors such as vanilla, cinnamon, and few scents from flowers are extracted from aromatic compounds. Benzene with chemical formula C6H6 is a very common aromatic compound that contains six atoms of carbon held in the cyclic ring of alternate double bonds. It is also to be noted that not all aromatic compounds contain benzene ring. This can be explained by Huckel’s rule.