How was the precipitate obtained after filtration? (A By scraping from the filter paper and transferring to a watch glass. B By charring the filter paper and igniting the product in a crucible. By drying the precipitate on the filter paper using a desiccator. D By redissolving in hydrochloric acid.

How was the precipitate obtained after filtration? (A By scraping from the filter paper and transferring to a watch glass. B By charring the filter paper and igniting the product in a crucible. By drying the precipitate on the filter paper using a desiccator. D By redissolving in hydrochloric acid.

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter12: Solutions

Section: Chapter Questions

Problem 12.6QE

See similar textbooks

Similar questions

Ammonium sulfate is added to an unknown mixture of ions. A precipitate forms. The solution is centrifuged, and the remaining solutions is decanted. Ammonium oxalate is then added to the solution and no precipitate forms. Sodium monohydrogen phosphate and sodium hydroxide are added to the decanted solution, and no precipitate forms. Sodium hydroxide is added to a fresh sample of the unknown. A damp piece of litmus paper over the opening of the test tube turns blue. Select the ions present. Question 4 options: Ba2+ Ca2+ Mg2+ NH41+
Ammonium sulfate is added to an unknown mixture of ions. A precipitate forms. The solution is centrifuged, and the remaining solutions is decanted. Ammonium oxalate is then added to the solution and no precipitate forms. Sodium monohydrogen phosphate and sodium hydroxide are added to the decanted solution, and no precipitate forms. Sodium hydroxide is added to a fresh sample of the unknown. A damp piece of litmus paper over the opening of the test tube remains red. Select the ions present. Question 5 options: Ba2+ Ca2+ Mg2+ NH41+
1.In using a burette, why is it important (a) to rinse it with a little of the solution it is going to contain, (b) to clamp it vertically, (c) to have the part below the tap full? 2. The following procedures were carried out during the titration: (a) The sides of the conical flask were washed down with deionized water. (b) The conical flask was frequently swirled or shaken.
write the method for preparation of caustic soda.
A mixture contain benzoic acid, salt, powdered silica (white sand) and contaminated with coloring. The aim of the experiment is to recover the pure benzoic acid and salt , make a schematic diagram or sketch on what method is applied to separate each component from the mixture to obtain the desired product.
A student carried out an experiment trying to prepare tetra-methyl-ammonium tri-iodide.The student weighed 1.13 g tetra-methyl-ammonium iodide into a beaker containing 25 mL ethanol, and then added 1.57 g of iodine. The mixture was heated gently, whilst stirring, on a hotplate until tetra-methyl-ammonium iodide, a white powder, was completely dissolved. After the mixture was allowed to cool down to room temperature, the mixture was further cooled on ice. After filtration on a Buechner funnel, washing with diethyl ether and leaving it under vacuum suction for a couple of minutes, the student recovered the product and weighed it. The mass of the obtained tetra-methyl-ammonium triiodide was 1.62 g.What is the yield of the reaction in percent [%]? For the calculation, assume that the product is completely dry and pure, so there are no impurities like side-products, unreacted educts, or solvent residues.
A sample containing BaCl, 2H,0, KCI and inert material weighed 0.8417 g. After heating the sample at 160°C for 45 min, it weighed 0.8076 g. The sample was then dissolved in water and treated with a slight excess of AgNo,. The resulting precipitate was collected and found to weigh 0.5847 g. Calculate the % Bacl,-2H,0 and % KCI in the sample. 3.
Caustic potash that has been exposed to air is found on analysis to contain 90.00% KOH, 2.38% K2CO3 and 7.62% H2O. What weight of residue will be obtained if 1.00 g of this sample is added to 46.00 mL of 1.00 N HCl and the resulting solution, after neutralization with 1.070N KOH is evaporated to dryness?
1. Differentiate the Faians method from the Volhard method of precipitation titrimetry, Include key information such as indicator used, endpoint, analytes, and the chemical reactions.
X ray films consist of a flexible plastic base coated in a gel that contains light sensitive silver halide crystals (i.e. silver bromide and silver chloride). these films are exposed to X ray radiation to produce images of the inside of a subject. Once the films are no longer needed, it is common practice to recycle the film to recover the silver. This process is done by shutting the film and placing it in a large cyanide solution bath. The silver is precipitated out as silver cyanide. a. What can you conclude about the water solubility of silver cyanide? b. Using the knowledge of limiting reactants, how can the process of be optimized to ensure that the maximum amount of silver is recovered?
Yield
Please help me