Which of the following most nearly gives the angle θ for equilibrium? Which of the following most nearly gives the tension on the cord AB? Which of the following most nearly gives the force on the spring AC?

Q: Q5 / Two cable are tied together at (c) and are loaded as shown in fig (5). Determine the tension in…

A: Let TAC and TBC is the tension in the cable AC and BC. Calculate the weight of the suspended mass,…

Q: Two transmission belts pass over a double-sheaved pulley that is attached to an axle supported by…

A: Introduction We will calculate the reaction force at A and B that is created by belts B and D in…

Q: What is the magnitude of the reaction at roller D if P = 8 kN and C is a pin connection? A 2.5 kN 4…

A: Given:Uniformly distributed load from A to C Point load between  C and D Pin joint at C

Q: The spanner shown is used to rotate a shaft. A pin fits in a hole at A, while a flat, frictionless…

A: The objective of this problem is to find the component of the reaction at A in a direction…

Q: Q2/ Determine the unstretched length of spring AC if a force P 801b causes the angle 0 = 60° for…

A: Solution:

Q: Question 3 (Type B): The 50 N force F is parallel to the y axis. Determine the components of the…

A: The force F is

Q: Σ F, = 0 Because each joint is subjected to a coplanar and concurrent force system, no moment…

A:

Q: Determine the moment reaction at B.

A:

Q: 4e. If the two forces are F1=(3i-2j-9k) kN and F2=(-16i) kN, Find out All the  correct equations…

A: F1=(3i-2j-9k) kN  F2=(-16i) kN As per guideline, I can solve 1 question at a time . So ,please…

Q: 1 ft 4 ft A 2 ft 45° X F₁ B 3 ft 5 ft 30° 45° y If F₁ = 300 lb. and F₂ is 250 lb., what are the…

A: Given:The force is .The force is .Consider free body diagram:Here,  is reaction force at A in…

Q: Determine the magnitudes of all pin reactions for the frame loaded as shown. Assume F = 630 N, a =…

A:

Q: Determine the magnitudes of all pin reactions for the frame loaded as shown. Assume F = 630 N, a =…

A:

Q: Neglecting friction and the radius of the pulley. determine the reaction at C. D 150 mm |B 120 N |A…

A: Answer: ◆ The reaction at C is 224 N acting at 2.05°. ◆ Therefore, the correct answer is option (c).

Q: Q.2.ch.3: Determine the magnitude and direction 0 of F so that the particle is in equilibrium. A kN…

A: A=11 kNB=5 kNC=4 kNAngle D=36oAngle E=50o

Q: For the frame shown below draw the influence lines for Ey, Fy, VC and MC using the equilibrium…

A: Given dataLA=4mLB=3m

Q: 1.5 m B 1.5 m I m 2.5 m 3 m -- 1.5 1.5 m-1 mª| 3 m

A: given data: w=900N/m total weight=900*3=2700N

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.