Which of the following is not a representation of the atmospheric pressure at sea level under normal condition. a. 1 atm b. 2116 lb/ft^2 c. 39.8 inches of mercury d. 10.33 m of water compute and explain.

Which of the following is not a representation of the atmospheric pressure at sea level under normal condition. a. 1 atm b. 2116 lb/ft^2 c. 39.8 inches of mercury d. 10.33 m of water compute and explain.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A pressure gage 13.31 m. above the bottom of a tank containing a liquid reads 58.93 kPa; another gage at height 2.54 m. reads 82.68 kPa. Determine the density of the liquid. Round off to three decimal places.
i need the answer now
7. At ground level the atmospheric pressure is 101.325 kPa at 15 °C. Calculate the pressure at a point 6500 m above the ground, assuming (a) no density variation, (b) an isothermal variation of density with pressure. 8. If the barometer reads 750 mm of mercury, what absolute pressure corresponds to a gage pressure of 130 kPa? 9. Determine the absolute pressure corresponding to a vacuum of 20 cm of mercury when the barometer reads 745 mm of mercury. 10. If the pressure in a gas tank is 2.50 atmospheres, find the pressure in kPa and the pressure head in meter of water. 11. The gage pressure at the suction side of a pump shows a vacuum of 25 cm of mercury. Compute (a) pressure head in meter of water, (b) pressure in kPa, (c) absolute pressure in kPa if the barometer reads 750 mm of mercury. 12. The pressure of the air inside a tank containing air and water is 20 kPa absolute. Determine the gage pressure at a point 1.5 m below the water surface. Assume standard atmospheric pressure.
If the pressure in a tank is 451 kPa, find the equivalent pressure head (in meters) of a liquid having a specific gravity equal to 5.538. Round off to three decimal places.
2- The density of a liquid is to be determined by an old 1-cm-diameter cylindrical hydrometer whose division marks are completely wiped out. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the other liquid, and it is observed that the mark for water has risen S cm above the liquid-air interface. If the height of the original water mark is 12.7 cm, determine the density of the liquid S (cm) Last names starting 0.95 with A to L Unknown liquid Mark for water S cm
#6 only
2. A mercury barometer reads 720 mm A) What would be the corresponding reading of water barometer? B) What is the absolute atmospheric pressure in kPa C) What is the approximate elevation above sea level assuming atmospheric condition? Neglect vapor pressure. Yair = 12 N/m³
A barometric pressure of 50 in. Hg corresponds to what value of atmospheric pressure in psi, and in pascals? (a) p = (b) p = psi Pa
A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage at height 3.16 m. reads 85.83 kPa. Determine the density of the liquid. Round off to three decimal places.
An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.5 m as shown in the figure below. A mercury barometer located inside the shell reads 765 mm Hg, and a mercury U-tube manometer designed to give the outside water pressure indicates a differential reading of 735 mm Hg as illustrated. Based on these data what is the atmospheric pressure at the ocean surface? Patm = kPa 735 mm Ocean surface Seawater 360 mm Mercury Shell- Shell wall V 14 9.5m
Fluid Mechanics! ty!!!!
The water tank has a diameter of 750mm , a height of 1750mm to which the Initial height of water was 5 cm. If water was to be filled 90% of height and the water meter initial reading is 2000L, a. what is the final reading of the water in L b. Find the mass of water tank if its initial weight is 45 kg