2- The density of a liquid is to be determined by an old 1-cm-diameter cylindrical hydrometer whose division marks are completely wiped out. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the other liquid, and it is observed that the mark for water has risen S cm above the liquid-air interface. If the height of the original water mark is 12.7 cm, determine the density of the liquid S (cm) Last names starting 0.95 with A to L Unknown liquid Mark for water S cm

2- The density of a liquid is to be determined by an old 1-cm-diameter cylindrical hydrometer whose division marks are completely wiped out. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the other liquid, and it is observed that the mark for water has risen S cm above the liquid-air interface. If the height of the original water mark is 12.7 cm, determine the density of the liquid S (cm) Last names starting 0.95 with A to L Unknown liquid Mark for water S cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate in meters the length of a rectangular settling tank to treat 14,000 cubic meters of water…

Q: Convert a manometer reading into a pressure difference for an open-end manometer, a sealed end…

A: Convert a manometer reading into a pressure difference for an open-end manometer, a sealed end…

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb solution = 1.31m

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: Concept: Center of Pressure The total pressure force acting on a fully submerged body is called the…

Q: fluids shown in the figure are at 20°C. If V₁ = 2.6 ft/s and losses are neglected, determine the…

A: This question is related to the Fluid Mechanics from Civil Engineering. Given Data - V1 = 2.6…

Q: graphs four particles in s shown in Fig. P4.10. The Ar 0.002 s. The location the photos, are shown…

A: Given:-∆t=0.002secTo find:-fluid velocity

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: To Determine (a) the gage pressure reading on the pressure gage Pressure gage is 1m below the liquid…

Q: In the figure shown, the distance y + 1/2 z = 1.20 m. When fluid A is glycerin with AG = 1.26, fluid…

A: Given data Specific gravity of glycerine = 1.26 Specific gravity of mercury = 13.6 Pressure at m…

Q: Current Attempt in Progress A sound wave is observed to travel through a liquid with a speed of 1250…

A: Given: Velocity of sound wave in fluid Specific gravity of fluid To find: Bulk modulus of fluid…

Q: i) What is the gauge air pressure in the tank at Point 1?

Q: The reading of an automobile fuel gage is proportional to the gage pressure at the botoom of the…

Q: A venturi meter equipped with a differential mercury manometer as shown in Figure 1. At the inlet,…

A: Venturimeter is a device which a type of flowmeter which works on Bernoulli's principle. It is…

Q: 6.8 in PA Water FIGUD

Q: A manometer is connected to a tank on the side (see below). There are two layers of different…

A: A manometer is connected to the bottom of the tank for measuring pressureSpecific Gravity of Water=…

Q: Consider the U-tube manometer shown in the figure. Both ends of the U-tube manometer is open to…

Q: A tank is fitted with a manometer on the side, as shown. The liquid in the bottom of the tank and in…

Q: For the shown inverted manometer, all fluids are at 20°C. If P, - P, = 130 kPa, what must the height…

Q: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the…

Q: A tank initially contains 100 gallons of brine in which there is dissolved 20 lb of salt. Starting…

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

2- The density of a liquid is to be determined by an old 1-cm-diameter
cylindrical hydrometer whose division marks are completely
wiped out. The hydrometer is first dropped in water, and the water
level is marked. The hydrometer is then dropped into the other
liquid, and it is observed that the mark for water has risen S cm
above the liquid-air interface. If the height of the original water
mark is 12.7 cm, determine the density of the liquid
S (cm)
Last names starting 0.95
with A to L
Unknown
liquid
Mark for
water
S cm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. Determine the pressure difference (pM – pv) when the manometer indicates as shown below. (38.690 kPa) Ol of RD-0.0 15 am 20 am IT 12 cm 16 om Mercury
(5) As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water (15°C) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25 kPa vacuum, will h increase or decrease, and by how much? Assume atmospheric pressure is 100 kPa. acuum, will h increase or descrease and by how much? ime atmospheric pressure is 100 kPa. PROBLEM h Air space Water
In the Figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not exploding from the moisture in the air) and an absolute pressure measurement device. The measurement device reads an absolute pressure of P2 at the depth of L in the pool. dP a) Calculate the pressure gradient (-) b) Using Excel plot the pressure distribution from the P2 and P1. Figure 1: A 2-D pool of Sodium on Earth that magically is keeping all of it's liquid inside even though it has no front and back sides.
Determine the height h in m of substance X in the manometer. The height of the water is hw = 0.35 m. The specific gravity of the oil is 0.83, the density of the water used in the experiments is 998.2 kg/m3, the specific weight of substance X is 124 kN/m3. Indicate your answer to 3 decimal places.
Convert the 115/85 systolic/diastolic pressures given in millimeters of Hg to Pa .
An initially empty tank on Earth is being filled with water so that the height of the water in the tank increases at a steady rate. Which one of the following graphs best describes the gauge pressure P at a point on the bottom of this tank as a function of time t during the filling process? Assume the tank starts filling at time t = Os and that the top of the tank is open to the atmosphere. The atmospheric pressure does not change during the process. The water in the tank does not overflow or reach the top of the tank during this process. A) D) P B)
4.) A homogeneous solid cylinder (SG = 0.60), 1 m high and 3 m diameter floats with its axis vertical in oil (SG = 0.80) . Find the location of metacenter above the bottom of cylinder in meters. Write your answer in three decimal places. fluid mechanics
Provide solution and correct options
A manometer consists of a tube of 0.5 inch in the inner diameter and an amount of mercury (SG Hg =13.55). On one side of the tube, oil (SG=1.4) was trapped, a bubble formed, and the fluid inside was stationary. The volume of the oil was 0.6 in^3 and the volume of the air was 0.2 in^3. Now, the oil and bubble are removed. The pressure change across the air bubble is negligible and any curvature on the bubble surface can be neglected in calculating the volumes. Determine how much the mercury height rises (i.e. h 4 -h 2 ).