Which of the following actions would increase foam fractionator efficiency? Lowering salinity (such as complete freshwater) O Increasing the contact time within the foam fractionator O Increasing bubble size through the fractionator O Decreasing contact time between water and bubbles

Q: Why would industry prefer to purify solids by sublimation or zone refining rather than…

A: The advantage of sublimation for purification process are i) Minimum amount of product is lost. ii)…

Q: Assume the total heat of vaporization (per gram) of water can be used to supply the energy needed to…

A:

Q: The volume occupied by 2 g of a gas at STP, if its vapour density is 56 is 0.25 L 0.4 L O 1.1 L 0.7…

A: One mole of any gas at STP occupies 22.4 L of volume. Molecular weight = 2 × Vapour density

Q: Are Particles Visible? Can it be Filtered? Do Partices Settle? See Tyndall Effect? Msture Example…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 2- Why is the flask in which the evaporation process takes place closed by a piece of aluminum? In…

A: In the experiment to determine the partial weight of volatile liquid, it is important that the…

Q: Theoretically, the inherent viscosity for solutions (not pure solvents) should always be  a.…

A: Inherent Viscosity ηi = ln ηr/c ln ηr is zero for puresolvent and increases with increasing…

Q: Nano chemistry questions! True or false? 1. Bulk materials have almost constant properties…

A: The solutions are given below -

Q: Define Solid aerosol, solid foam and solid sol

A: Solid aerosols, solid foam, and solid sol are all heterogeneous solutions and classified as…

Q: Organic liquids are usually less dense than water.  True  False

A:

Q: "hich characteristic of water O a O b adhesion surface tension

A: B answer is correct. Surface Tension The high surface tension helps the paper clip - with much…

Q: 8.Specific gravity of a solid in flotation method is compared indirectly with a liquid known…

A: Question:Specific gravity of a solid in flotation method is compared indirectly with a liquid known…

Q: 17. What is the mass of an object that has a density of 0.23 g/cm and whse volume is 52 cm?

A: As requested, the solution of question number 17 is as follows: Given:  Density of substance=…

Q: Explain why the flow of a compressed gas must be controlled for practical and safe use.

A: The reason why the flow of compressed gas must be controlled for practical and safe use has to be…

Q: explain the difference gel filitration and gel permeation ?

A: Both Gel filtration and gel permeation techniques involves the separation of molecules in a sample…

Q: Particulate Electrical Forces Unit Test Water exhibits hydrogen bonding. Which option describes what…

A: Water exhibits hydrogen bonding. The option, which describes about water has to be identified.

Q: 7. The lower surface area provides a better surface contact with the solvent, facilitating faster…

A: The dissolution is defined as a process in which solute's molecules dissolved in the solvent. The…

Q: concentrated H2SO4 has the following composition specific gravity 1.84 and purity of H2SO4 is 97…

A: Calculation of concentration of the solution in molarity (mol/L) with known values of density,…

Q: Define cohesion and adhesion, and how they can predict capillary action.

A: Adhesion can be defined as the sticking tendency of particles of different types of material.…

Q: Calculate the quantity of lime and soda required for softening one million litre of the following…

A: Water can be hard or soft. Water became hard due to the presence of MgCO3, , MgCl2 and CaCl2. But,…

Q: Dynamic equilibrium can be defined as rate of dissolution rate of dissolving rate of condensing >…

A: we have to find what is happened at dynamic equilibrium.

Q: Describe method of acid vapor Pressure.

A: Menometric method

Q: Why membranes separation is a cost savings and low energy requirement process? States 4 types of…

A: Membrane separation is a process which selectively separates materials present in the mixture using…

Q: Which of the following statements is true when considering temperature during a recrystallization?…

A: For crystallization, it is important to prepare a saturated solution of the sample in minimum amount…

Q: Suggest three ways to increase the rate at which zinc dissolves in sulfuric acid. Use large pieces…

A:

Q: What is the best way to extract water from air?

A:

Q: Chemistry __________ will have the highest boiling point. 3,4-diethyl-octanol 2,3-dimethyl-octanol…

A: Given  3,4-diethyl-octanol 2,3-dimethyl-octanol 2-ethyl-hexanol ethanol decane Higher Boiling Point…

Q: 7 questions for Properties of Liquids and IMF

A: There are various types of intermolecular forces such as hydrogen bonding, vanderwaal interaction,…

Q: When a meteorologist reports precipitation in the weather forecast, this usually associated with a…

A: Precipitation is a kind of weather condition that is something falls from the sky.

Q: What is the kinetic property observed in suspension? What is the optical property observed in…

A: It is a heterogeneous mixture of solid particle suspended in a solvent.  The solid particles are…

Q: Why does micelle formation take place when soap is added to water? Will a micelle be formed in other…

A: When we will add soap in water. There are two ends of soap molecule, one end is hydrocarbon chains…

Q: Carbon tetrachloride (CC14) is diffusing through benzene (C6H6), as the drawing illustrates. The…

A: Given , Carbon tetra chloride is diffusing through benzene

Q: What is a supercritical gas? What is the function of a modifier?.

A: Since you have posted multiple questions in a single session we are entitled to answer only first…

Q: The pure liquid with the lowervapor pressure at room temperature has the ______ boiling point.

A: Vapor pressure :- The pressure exerted by the vapour molecules on the surface of a liquid when both…