When two capacitors are connected in parallel across a 10.8 V rms, 1.00 kHz oscillator, the oscillator supplies a total rms current of 556 mA . When the same two capacitors are connected to the oscillator in series, the oscillator supplies an Part A rms current of 126 mA . What are the values of the two capacitors? Enter your answers numerically separated by a comma. ΠV ΑΣφ C1, C2 = µF Submit Request Answer

When two capacitors are connected in parallel across a 10.8 V rms, 1.00 kHz oscillator, the oscillator supplies a total rms current of 556 mA . When the same two capacitors are connected to the oscillator in series, the oscillator supplies an Part A rms current of 126 mA . What are the values of the two capacitors? Enter your answers numerically separated by a comma. ΠV ΑΣφ C1, C2 = µF Submit Request Answer

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The figure below shows the time variation of the current through an electrical heater when it is plugged into a 240.0 V(rms), 60.0 Hz outlet. 5a I (A) 10 5 -5 -10 What is the peak voltage? (Please answer in Sl unit and multiply your answer by 10-2) t
According to MS IEC 60038, the requirements of nominal low voltage supply in Malaysia is 240 Vrms or 400 Vrms with variations of +10 % and -6 % and the nominal frequency is allowed to fluctuate at ± 1% from 50 Hz. Figure 1 shows a capture of a single phase supply voltage in Malaysia. Examine the waveform under each time zone and determine its compliantness to the standard. Show all relevant calculations. 360 V- 120 V -Zone 1- 0 40 80 120 160 200 -Zone 2 240 280 320 360 Time (ms) 340V Figure 1 400 -Zone 3- 440 480 520
A 19-Ω Microphone and a 16-Ω microphone are connected in parallel across the same receiver, which supplies an ac voltage with rms value 3.00 V. Find the total rms current supplied by the receiver in A
A capacitor is connected across an ac generator whose frequency is 750 Hz and whose peak output voltage is 210 V. The rms current in the circuit is 3.1 A. (a) What is the capacitance of the capacitor? (b) What is the magnitude of the maximum charge on one plate of the capacitor? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. +q₂ (a) Number 4.432 (b) Number i 930.72 Units Units Irms Vsin 2π ft No units No units
need help with parts b,e,g
The reactance of a capacitor is 4.0 k Ohms at a frequency of 0.60 kHz. What is the capacitance?
Please asap
A current of I(t) = (5.50 mA)((sin(325 s-1)t ) passes through a 38 microF capacitor. What is the rms voltage across the capacitor?
A capacitor is connected across the terminals of an ac generator that has a frequency of 490 Hz and supplies a voltage of 39 V. When a second capacitor is connected in parallel with the first one, the current from the generator increases by 0.18 A. Find the capacitance of the second capacitor. Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. Number 1 a pag Jadi Units
Capacitance and Impedance Capacitance is much more difficult to measure than resistance. This problem shows one crude way to get that measurement done. Consider a 15 Ω resistor in series with an unknown capacitor. You can use a function generator like those in the studio to make a 20 volt rms signal at 6100 Hz. If a multimeter shows the rms current through the circuit to be 1.259 A, what is the capacitance of your capacitor? I tried solving for the impedance and then plugging that equation into ohm's law, but I get an equation that says C does not have a real value.
The figure below shows three lightbulbs connected to a 120-V AC (rms) household supply voltage. Bulbs 1 and 2 have a power rating of 100 W, and bulb 3 has a 120-W rating. 120 V 1 2 3 (a) Find the rms current in each bulb. Ipulb 1 = A Ibulb 2 = A Ipulb 3 = A (b) Find the resistance of each bulb. Rbulb 1 = Ω Rpulb 2 = Ω Rpulb 3 = Ω (c) What is the total resistance of the combination of the three lightbulbs?
Please box answer for E