What reactive element comprising the circuit if the instantaneous voltage and current is 450 cos (100t + 40 deg), volts and 25 cos(100t - 40 deg) amps respectively? O 177.26 microfarad O 177.26 mH OO. 17726 microfarad O 0.17726 mH

Q: (2) A controlled half-wave rectifier has a 240 V rms 60Hz ac source, The load a is R=30 Ohm resistor…

A: Given,    A controlled half wave rectifier,       Vrms= 240V         f = 60Hz         R = 30 ohm

Q: The input to a full-wave rectifier is 30 V AC (RMS). The load resistor is 10 ohms. The DC power at…

A:

Q: What is a microchip, and how does it differ from a standard integrated circuit (IC)?

A: A microchip, also known as a microcontroller or microprocessor, is a tiny electronic device that…

Q: Give a conclusion about clipper circuits and clamper circuits.

A: The clipper circuit is one in which the signal cannot exceed the value of fixed magnitude. The…

Q: Check all the correct statements. Diodes convert AC to DC. Diodes convert DC to AC. Diodes can…

A: Check all the correct statements. Diodes convert AC to DC. Diodes convert DC to AC. Diodes can…

Q: Part A: 1. 2. 3. Connect the circuit shown below. 5V 1k0 ww Circuit A Measure the voltage drop…

A: The circuit diagram is shown below, We know, when the p-type element is coupled to the positive…

Q: Consider an n-type semiconductor, in which minimum conductivity design criteria is applied. Select…

A: Given data:The semiconductor is of n-type.Minimum conductivity design criteria are…

Q: Part B: 1. 2. 3. Circuit A 1. Connect the circuit below. Circuit B 2. Conclusion: 3. 4. Circuit B…

A: answer: given that a linear circuit with a led connected in that considering VD - diode voltage…

Q: Can you please explain pinch off voltage and go into more detail about how you found VP? thank you

A: The pinch off voltage Vp is the value of drain to source voltage (Vds) at which the drain current…

Q: The input voltage of a single-phase full- wave diode rectifier is v= 100 sinwt Volts and the…

A: The solution can be achieved as follows.

Q: The power output of the half-wave rectifier is rated at 102.4 W with a load resistor of 40 ohms. The…

A: Given, P = 102.4 W R = 40 ohm

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: 8. The standard measurement data table of a thermocouple is developed when the thermocouple's…

A: thermocouple circuit with one end in an ice bath (0°C) and the other in an unknown temperature. This…

Q: (2) A controlled half-wave rectifier has a 240 V rms 60Hz ac source, The load a is R=30 Ohm resistor…

A: Given data, RMS voltage Vr=240 V Frequency f = 60 Hz Load resistance, R=30 Ω Load current Io=2.5 A

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.