What is the water elevation of reservoir has the below capacity curve which can store ? 250,000 m3 300,000 250,000 200,000 150,000 100,000 50,000 115 120 125 130 135 140 145 148 Countors (m) Cumulative Volumes (m³)

What is the water elevation of reservoir has the below capacity curve which can store ? 250,000 m3 300,000 250,000 200,000 150,000 100,000 50,000 115 120 125 130 135 140 145 148 Countors (m) Cumulative Volumes (m³)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A river reached a flood that was passing through it. At a given instant, the storage of water in the…

Q: Oil is conveyed on a 6” diameter pipe, sg=0.8 the velocity is 30ft/s. The pipe diameter narrows to…

Q: ) A pump has a characteristic curve described by the equation: hp = 12-0.1Q^2 What is the pump…

Q: The area within the contour line at the site of reservoir and the face of the dam are as under -…

A: Area of contour line at the reservoir and the face of the dam:-S.No.contour…

Q: 8.4 The storage-elevation-discharge Elevation (m) Discharge (m³/s) Storage (10 m³) characteristic of…

Q: A pump is being utilized to deliver a flow rate of 500 li/sec from a reservoir of surface elevation…

A: Answer We are given Flow rate Q = 500 l/s Elevation of suction reservoir = 65 m Elevation of…

Q: The water in an open channel drainage canal flows with a velocity of VA = 1.5 m/s into the drainpipe…

A: Solution: Given Data: VA=1.5 m/sd=750 mm d=750mm=0.75 mArea AB=π4d2=π40.752Area AB=0.441m2

Q: Your assigned problem: If the water surface elevation in reservoir B is 110m, what must be the water…

Q: A new water supply main is being planned for a new city of 2 million population and average per…

Q: what power must the pump supply in HP to allow this flow?

A: Given:- Discharge, Q=0.35 m3/sHead loss is equal to twice velocity head in 30 cm pipe To find:-…

Q: The storage-elevation-discharge characteristic of a reservoir is as follows: 100.00 Elevation (m)…

Q: Estimate the flow under the dam below given: k = 5.2x10^-4 cm/s, h1 = 32ft, h2 = 11ft. Answer in…

A: Coefficient of permeability, To find: Flow under the dam.

Q: Knowing that the bottom of the reservoir is flat with a level of 800Om above mean sea level,…

Q: If 150 L/s of water flows through the system shown in the figure below, calculate the pressure at 2.…

A: For the point 1 - P1 = 0, V1 = 0, Z1 = 35m For the point 2 - Z2 = 0

Q: To prevent downstream flooding, the maximum flow to be released from the catchment is set at 273…

Q: In a three reservoir problem, the elevation of reservoir 1 and 2 are 462 m and 368 m respectively.…

A: Consider the following diagram:

Q: Water flows along the drainage canal having the properties as shown below. S, = 1 ft/500 ft.…

Q: Two reservoirs are connected by a pipe having a diameter of 253 mm and a length of 13,643 m. If the…

A: D = 253 mm or 0.253 m L = 13643 m C = 131

Q: The annual peak flow rates in a river between 1980 and 1996 are as follows: Year Peak flow Year Peak…

A: Annual peak flow rates in a river between 1980 and 1996:YearPeak flow,…

Q: 5: There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in…

Q: Consider two discharges of BOD from chemical plants along a river separated by some distance d. a.…

Q: The river discharges into the reservoir shown at a rate of 400,000 ft³/s, and the outf the reservoir…

A: Given :

Q: How do you determine the capacity of the reservoir? Explain the process for determining the capacity…

A: Reservoirs are generally constructed on rivers in order to full fill the water demand during…

Q: Q3/ Determine the useful storage depth that used in hydroelectric power plant according to the…

A: The water levels in a reservoir are divided into:Maximum flood level(MFL): It is the highest water…

Q: Discuss with the help of a typical cross section please explain various components of a dam, also…

Q: 2 A rectangular channel of 2.5 m width is carrying a discharge of 4 m³/s. Considering that…

Q: The elevation-area and elevation-discharge relationships for a reservoir are as follows: A= 2 + H Q…

Q: A 2-hour unit hydrograph can be approximated as trapezium as shown in figure. The UH refers to…

A: Given- 2 hr unit hydrograph- Catchment area=?

Q: (a) The hydrological behavior of a region depends on its climate, topography and geology. Based on…

A: Effect of climate: The climate is a very important factor in hydrology. The rate of evaporation is…

Q: A reservoir is to be constructed at a location where monthly flow data are available for 20 months.…

A: The Sequent peak algorithm is extremely quick and simple to program. A solitary verifiable record is…

Q: 1. A reservoir has the following inflows and outflows for the first three (3) months of the year. If…

A: Storage beginning of January month= 60 m3 The inflow and outflow of first three months of the year…

Q: Assume you are dealing with a vertical-walled reservoir having a surface area of 500,000 ?2 and that…

Q: The reservoirs in the following figure contain water. If the pipe is made of cast iron (e =0.15 mm)…

A: Given Data: The difference in the reservoir heads is hf hf=∆z=z1-z2=100 m The length of the pipe is…

Q: (a) The hydrological behavior of a region depends on its climate, topography and geology. Based on…

Q: o 2 significant

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 m The storage and outflow from reservoir…

Q: A river reach had a flow wave passing through it. At a given instant the storage of water in the…

Q: A pump having the characteristics curve is given below delivers water from a river at elevation 52 m…

A: D = 350 mm or 0.35 m L = 2000 m f = 0.022

Q: The storage-outflow characteristics for a reservoir are given below. Storage (106 m³) 70 80 85…

A: To find:graph of storage outflow function

Q: A flow of 2.51/s will fill in 2 hours a storage tank volume of: 18 m^3 9000 m^3 5 m^3 18000 m^3

Q: 665 li/s, calculate the following. Discharge through pipe 1, discharge through pipe 3 Elevation of…

Q: You have plotted the stream profile of a rural catchment and determined the area the under the steam…

Q: Q3: The stage discharge for a river is given below: Stage(H),m 3 4. 7 q m/s 90 203 420 710 900 1-…

A: Given the stage-discharge for a river as, Stage(H), m q m3/s 1 90 3 203 4 420 6 710 7…

Question

What is the water elevation of reservoir has
the below capacity curve which can store
? 250,000 m3
300,000
250,000
200,000
150,000
100,000
50,000
115
120
125
130
135
140
145
148
Countors (m)
Cumulative Volumes (m³)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need solutions in 10 minutes please
A pipe of diameter 20 cm and length 2000 m connects two reservoirs, having difference of water as 20 m. Determine the discharge through the pipe.
A sluice gate, as shown in figure 01, is used to control the upstream water level in a3 m wide rectangular channel The water discharge in the channel is 15 m3/s. Explain the terms superclitical, subcritical and criticaL
Water flows through a venturi meter whose inlet diameter is 31 cm and throat diameter is 19 cm. The pressure at the inlet is 755 kPa and at the throat is 550 kPa.Neglecting head loss, determine the discharge in m^3/s? *
Three reservoirs Z, Y, and X meet at Junction P. Reservoir Y (25m above Reservoir X) is at Elev. 282m. Diameter Length Pipe C (mm) (m) Pipe 750 988 100 Z Pipe 900 1410 110 Y Pipe 600 1022 90 X If the rate of flow from the highest reservoir, Reservoir Z, is 605 L/s, then: What is the elevation of the highest reservoir, Reservoir Z, to the nearest whole number?
A reservoir is to be constructed to regulate the flow of a river. The monthly inflow amounts are given below. Assuming 100% regulation, estimate the storage capacity of the reservoir. Month 0 St (106 m³) 5 N 7 D 8 J 9 F 12 M 15 A 14 M 9 J 4 J 2 A 1 S 4
The table below represents the flow information for a river, follow the flood hydrograph of this river if you know that the coefficient of Maxingham K = 8, X value = 0.25 m. Then find: A- The value of the final discharge at the time of 8 hours. b- The final discharge value at the time of 12 hours. 28 10 24 15 20 20 16 25 12 30 8 30 4 16 0 [8] time (hour) inflow (m3/s)
For studying of a dam in the laboratory, a model overflow has been built in the scale of to Prototype. The flowrate of the flow in the model is 0.15 . The required time for moving of water between two points in the model is 1 minute. Calculate: i. The volume flowrate in the prototype. ii. The required time for moving of water between the points in the prototype.
I need the answer to the question in fluid mechanics
3.
Q4) A lagoon has an area of 100 m² and the flow into the lagoon is 15 m/hour. 1. What is the volumetric flow rate in m³/second? 2. What is the residence time in this lagoon in minutes?
Hydrology: i need the answer quickly i need all the steps, i need the answer in Handwritten.