What is the volume needed for the concrete (s=2.40) attached to the cable just to start opening gate AB?

Q: Column bars are offset at the top: a. To bring the column back into vertical alignment b. To overlap…

A: Reinforcement bars are offset in Column at top so that reinforcing bars in next storey can be…

Q: Top tie 4. Assume that the wet concrete (s.w. = 150 Ibf/ft³) behaves as a liquid. Determine the…

A: The given data is: sw=150lb/ft3 Height of concrete in form=9 ft Force on form Ft=sw×z×A

Q: What is Open caissons?

A: The foundation is the subsurface structure which is used to transmit the structure load to the…

Q: 8. Calculate the uplift force on the lift station box. The base of the box is 3' x 3'. 424 2' 3' 7'

A: Uplift Force: The uplift force is the upward force that is applied to the structure. The pressure of…

Q: A300 mm x 300 mm reinforced concrete column shown is reinforced with 8-16 mm diameter bars with fy -…

A: Transverse reinforcement spacing should be minimum of  48* dia of tie bars 16*dia of main bar Least…

Q: a          cable carries a load uniformly distributed along the cable itself?

A: Cables are used to support the dead weight and live loads of the bridge decks having long spans. The…

Q: Define the term Shear Centre for Open Thin-Walled Members?

A: The shear center is a point from which a concentrated load passes; then, there will be only bending…

Q: Take a look at the section below, consider is 30 inches long and has 0.1 inches of wall thickness. 5…

A: The objective of the question is to calculate the shear flow, locate the shear center, calculate the…

Q: Given the height of the backfill shown, what is most nearly the height of the keyless concrete…

A: The horizontal force is calculated as, Consider the summation of vertical forces.

Q: The three cables support the 400-lb load as shown in Figure 1). Figure ** 30 28 1 of 1 Part A…

A: As multiple parts are asked and as per the guidelines only first three sub-parts will be…

Q: Given: Find: ● hca hvc A B F=22.0lbs hca=6.75in hbc=10in Lac=9.5in Lac C F Tension in cable CB =…

A:

Q: Briefly explain why there are only two shear strength values listed for wood-to-steel and…

A: Bolts can be in single or double shear.When the bolt is in double shear two cross sections are…

Q: In the design of corbel beams in a pumping station, why are shear links designed in the top 2/3 of…

A: Introduction -  The corbel beams are those which have Zd < 0.6 Here, Z = The distance of bearing…

Q: 17) What is the depth of a W12x170?

A: Note :- as per our guidelines we are supposed to answer one question at a time as it is neither true…

Q: Is the arch system under the uniformly distributed load as shown statically determinant? Provide…

A: A truss or frame is statically determinate if all the support reactions and member forces can be…

Q: Figure P5.3 shows the column reinforcement for a 16 in. diameter concrete column, with f, = 75,000…

A: The given data is: Diameter=16 in Fy=75000 psi fc'=8000 psi For building frame, As=7.3 in2 For the…

Q: Describe Pressure zones assumed for calculating strut loads.

A: Typical section showing different zones:

Q: 2. A water gate is 3m high and 1m wide. What is the force acting on the lower stay when the top of…

A: What is the force acting on the lower stay,F?

Q: A steel cable used in a suspended roof system has an allowable tensile strength of 150 ksi. It must…

A: Introduction : Tensile strength or Tensile stress =Loadarea area =π4*d2 where d is the diameter…

Q: how to draw the beam load for a combined one and two way slab

A: Step 1: Understand the Slab SystemOne-Way Slab: A one-way slab distributes the load to two opposite…

Q: Solve for the concrete materials of slab, beams and girders using class "A" concrete.

A:

Q: determine the length of a cable's damage?

A: This question comes from Construction Management and Equipment & Fire and Safety Engineering.…

Q: 3. A 25-m length of steel cable has a diameter of 12 mm, an elastic modulus of 250 GPa, and a yield…

A:

Q: A 3 m ca B D 2 m 4 m Determine the force on hinge C and block D if the 097 +9! ! ! tom 4+4 400

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.