11 What is the primary reason for adopting transposition of conductors in a three phase distribution system?O A. To balance the currents in an asymmetric arrangement of phase conductorsO B. To reduce the resistances of the phase conductorsO C. To increase the reactive voltage drop along the length of the lineO D. To reduce the reactances of the phase conductors

In this question we will write about transposition of conductors in 3 phase distribution system....

What is the primary reason for adopting transposition of conductors in a three phase distribution syster O A. To balance the currents in an asymmetric arrangement of phase conductors B. To reduce the resistances of the phase conductors C. To increase the reactive voltage drop along the length of the line D. To reduce the reactances of the phase conductors

What is the primary reason for adopting transposition of conductors in a three phase distribution syster O A. To balance the currents in an asymmetric arrangement of phase conductors B. To reduce the resistances of the phase conductors C. To increase the reactive voltage drop along the length of the line D. To reduce the reactances of the phase conductors

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Implement the function f from the circuit in Figure 1 using an 8-1 line multiplexer, and any additional circuitry that may be required.
Give examples of power ratings for home appliances and electronics.
Anything AND'ed with its complement will give an output of a.0 b.1 c.Could be 1 or 0 d.This is not a situation that could ever occur
Question 19 For the FET, the relationship between the input and output quantities is nonlinear, squared nonlinear, cubed linear, proportional due to the term in Shockley's equation.
I want a solution in less than 30 minutes In general, the transient stability limit is the __________ whilst the steady-state limit is the _____________ . a. Same, Same b. biggest, smallest c. lowest, largest d. largest, lowest
make me an example of a complex power pls. asap
Describe the reasons why the same analysis is not performed for the blocking factor as for the factor of interest explain why in detail
Q. What is short circuit evaluation? Give an example. DO NOT COPY FROM OTHER WEBSITES
Power systems quality
Homework (H.W) Q1. Design a full adder circuit using two block 4:1 multiplexers.
1/1i110 It in the figt) using Krr ehoff's taws. to to
Accircuit to C2 をR2 R, find the average Powr consumed bythe elements and the ComPlex Power note? set the elements Values by yourself