What is the potential at point M relative to the system in the figure? (Take as ɛ0=8,85.10^(-12)C^2/Nm^2, q=3C, a=2m)Mp 3428 -a+qa) 8,99.10°9 N/COB) 8.99.109O NS) -8.99,109 N/COD) -8,99.10^9VOTO) O

What is the potential at point M relative to the system in the figure? (Take as s0=8,85.10^(-12)C^2/Nm^2, q=3C, a=2m) p 341 M 28 - +q Oa) 8,99.109 NIC OB) 8.99.10^gV O NS) -8,99.109 NIC OD) 8,99.10°9V

What is the potential at point M relative to the system in the figure? (Take as s0=8,85.10^(-12)C^2/Nm^2, q=3C, a=2m) p 341 M 28 - +q Oa) 8,99.109 NIC OB) 8.99.10^gV O NS) -8,99.109 NIC OD) 8,99.10°9V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 5,-Find the values indieated · below For the tol circuit. l 20K when switch is in lov JOV 10uF Ne ビニ…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 4. What is the energy of the signal r(t) = sine a. none of these b. 2л E- C.T 00

Q: Find the current I, in the circuit shown. I. 50 2 100 2 ww 60/0° V j80 Q -j40 Note: The current I,…

Q: + VR - ILD-max = 30 mA || İLD 300 N VLD-max = 15 V ZLD VLD Oms 15ms 30ms 45ms 60ms 75ms ) Deter mine…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: 9. [(2260)/(15Z-75)]+[(1.2+j1.2)/(4.2+j2.4)]

Q: A schematic design of a full-wave bridge type power supply is given below. Provide the appropriate…

A: The Given full wave rectifier, The Values are VODC=7.5, P0=20mW, Vmp=311.13Vpf=60Hz,…

Q: THE SWITCH HAs BEtw IN PositINN "a" FOR A LoNG TrmE. tooKe a) At TemE t= o, THE SWITCH /s Mouro To…

Q: a) frid Dens for This periodic wave form Us(t) b) find the porer burned Power in the load Re <)…

A: We need to calculate RMS value of given wave form , we know the formula for RMS value. We also…

Q: 7. (30cis87.6)/24cis48

A: The question is about polar form.

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V

A: Solve the problem

Q: Identify the Circuit element from the given wave forms? Cne -1/2 a. Inductor O b. Capacitor c.…

A: As we see in the waveform given current lag voltage by 90° .

Q: A 60 Hz sinusoidal voltage with an RMS value of 440 V is applied to a TRIAC voltage regulator. The…

A: it is asked to find the output DC voltage of given TRIAC voltage regulator

Q: Determine: a) Describe how the square wave can be created by adding a fundamental frequency. Show…

A: given V=100*sin(100*pi*t)+50*sin(200*pi*t)

Q: Identify which measurement this osilloscope time difference reading is useful for. Ocilloscope-XSC1…

Q: Terms: amplitude (A), phase angle (op), frequency (f), angular frequency (w), period (T), peak value…

A: Given: Vp = 5 voltf = 60 Hz Find: Draw the Signal = ?

Q: In a frequency modulating system, the frequency deviation constant k = 1 kHz/V. A sinusoidal…

Q: : For the current waveform that shown in Figure belo w Find:- 1). Average value 2). R.M.S value 3).…

Q: How do you get a Sine wave from a Square wave , explain with the drawing ?

A: Square wave to Sine wave converter circuit is a analog circuit that are used for converting the…

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 5ms/cm and the…

A: Here each square box is 1 cm x 1 cm And 1 cm length is divided into 10 parts.

Q: P3 Calculate the correction factor of sinusoidal, square and triangular waveforms. VRMS Correction…

A: We need to calculate the correction factor of a sinusoidal, square and triangular waveform .…

Q: 2. A series RL circuit has voltage and current equations of e = 141.42 sin 2n30t + 141.42 sin 2n90t…

A: For series RL ckt..impedance Z=R+jXL .. Where R is resistance and XL is inductive reactance..

Q: R 200 Vs 120Vrms }60HZ 0° C. -j10 Calculate the magnitude of the voltage drop across the inductance.

A: Using voltage division rule we will find voltage across inductor. Given inductive reactance = j5…

Q: What is the form factor of this waveform...

A: The given waveform is shown below.

Q: Consider an RL circuit powered using a square wave from the signal generator. The figure below…

Q: A double beam oscilloscope displays 2 square waveform Gand H. The time/cm switch is on 2 ms/cm and…

A: Double Beam Oscilloscope With 2 Square waveforms. Given, time 2ms/cm, Volt/cm = 4

Q: QUESTION 8 Ten volt (10V) magnitude sinusoidal voltage of frequency 1MHz is applied across a 100 Ohm…

A: In this question, we need to choose the correct option. What is voltage across the capacitor.

Q: If two sinusoidal waves appeared on the screen, where the scale of ch1 is 2v/Div., and the scale of…

A: In the waveform, Voltages division for each waveform are given. Time division given Find the peak…

Q: C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of…

A: The circuit diagram is: V1 contains harmonics and the amplitude of the harmonics is inversely…

Q: R = 250R and the sinusoidal alternating emf revice operates at Em = 40 v and fo = 55 Hz a) What is…

A: The resistor, The emf, The frequency,

Q: Find the current I, in the circuit shown. ... 50 N 100 Q +. 60/0° V j80 Q -j40 Q Note: The current…

Q: Q2: (a) Determine the frequency of the waveform of following figure. 10 V t msec 50 (b) Find T-…

A: In this question , we will find frequency of given periodic wave form...

Q: Ererises IA platinum oil has a resofance of 3.14k r at go°C and 3.747 JV at 100°C. Find the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 4) Draw an oscilloscope screen on your paper and draw a square function having 6 V peak to peak…

Q: Using trapezium's Rule with n = 4 subintervals approximate the area under the sine curve f(x) = sinx…

A: From the Trapezoidal Rule

Q: Channel 1 and Channel 2 Time (ms) Phase problem. In the above figure the time base is 1 ms/div, what…

A: Given: Time base=1ms/div

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45° A

A: Given, Two magnitudes with angles , We have to draw the phasors. Please find the below attachment…

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

A: Given: A Square wave having, Vrms=163.21 VTime for two cycle=35 ms

Q: A schematic design of a full-wave bridge type power supply is given below. Provide the appropriate…

Q: R

Q: sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 30 µs/cm and the…

Q: QUESTION 6 at is the value the following sinusoidal voltage signal v(t) = 183 cos (234t+53°) V at t…

Q: b. Waveform B has a determined frequency wherein its one cycle is completed within 0.100 seconds but…

Question

What is the potential at point M relative to the system in the figure? (Take as ɛ0=8,85.10^(-12)C^2/Nm^2, q=3C, a=2m)
M
p 34
28 -
a
+q
a) 8,99.10°9 N/C
OB) 8.99.109
O NS) -8.99,109 N/C
OD) -8,99.10^9V
OTO) O

Expert Solution

Step 1

Choose the correct option

What is electric potential at the point M?

We know electric potential due to any point charge = kq/r

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Short answer asap.please..
do fast... explanation needed with correct ans.
Determine the phase angle difference. Write the values only in degrees in four decimal places. the correct answer is 90 degrees. show the solution please. thank you
Question No. 1 The switch Si of figure 5 has been closed for a long time. At 1=0sec, Sı is opened, at the same instance S2 is closed. a) Find the initial current through the coil b) Find the mathematical expression for the current (iz) through the inductor and corresponding voltage (vz) following the closing of the switch S: c) Sketch the waveform for iL and vz 82 8.2K2 1 KL F2-2Kn L 680mH O 6V 12mA Figure 5: RL circuit network for question no.5 (20]
23 minutes, 43 seconds. Question Completion Status: A Click Submit to complete this assessment. Quèstion 5 Given the sinusoidal voltage v(t) = 50 cos (250t + 25°), what is the period of this signal? %3D Non of the answers 0.052 39.78 0.0025 A Click Submit to complete this assessment.
9
Write code to produce the wave form as following(The phase change is pi) Serial binary data BPSK VA AMMA AMA Phase changes
The time/div and voltage/div axes of an oscilloscope have been erased. A student connects a 1 kHz, 5 V P-P square wave calibration pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of the figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (p - p) and period of the unknown signal are respectively
SAMPLE 2. Determine V across and I passing through Z, if Z is... a) 500 + j300OQ b) 100 Q and 10µF in parallel Ans: I = 0.3887Z– 31.5948° A V = 226.65292 – 0.6311° V I = 0.8344267.8325° A j10.2 4.0 I V = 236.55062 – 1.5115° V Wr 23020°V V 60HZ
The pictuere shows double-beam c.r.o. waveform traces. Find the ff:• Amplitude of P• Peak-to-peak value of Q• Periodic time of both waveforms• Frequency of both waveforms• R.m.s. value of P• R.m.s. value of Q• Phase displacement of waveform Q relativeto waveform P
Please show the neat and complete solution. Thank you