What is the elevation of the water line at the bottom if the volume of reservoir is computed by end area method and found to be 26,000 cu m .This consists of three water lines A1 =3000 sq m,A2 = 2,600 sq m and A3 =2000 sq m.Elevations of these water lines are respectively 80 m and 74 m on top and middle note: Pls. show your complete solution

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 llp0w The storage and outflow from…

Q: 20 15 Head (cm) 10 5 0 5.0 cm 5.0 cm 1 2.0 cm T 5.0 cm + 2.5 cm 1.5 cm 2 a Ah = 5 cm ↓ 1 soil Datum…

A:

Q: Determine the total seepage loss per meter length of the dam (in m/day/m). Given X = 18 m; Y = 4 m;…

A: From figure:NF=number of flow channels=4ND=number of equipotential depths=10we have…

Q: Water is flowing at a steady rate through a homogeneous and saturated horizontal soil strip of 10 m…

A:

Q: D=1.2m

A: Diameter of Pipe, Do= 1.2 m Depth of flow, y = 0.08 mm θ is angle subtended by water surface at…

Q: The area within the contour line at the site of reservoir and the face of the dam are as under -…

A: Area of contour line at the reservoir and the face of the dam:-S.No.contour…

Q: Two reservoirs are connected by a 200-m long cast iron pipe line, as shown in the figure. If the…

A: Friction factor= 0.02  Discharge= 0.2 m3 / s

Q: 3. The figure shown is a frustum of a cone with an orifice in the bottom of 0.20 m². If the water…

A:

Q: In the Given Rectangular Dam, determine the magnitude of the resultant R and where it intersects the…

A: Formula used:Pressure along the sea water :P=γHR=Rx2+Ry2

Q: water flows through an aquifer with a cross-sectional area of 1.0 x . Hydraulic heads are 300 m and…

A:

Q: Problem Number 2: In the Given Rectangular Dam, determine the magnitude of the resultant R and where…

A:

Q: Water is flowing through an inclined aquifer (a=10°) as shown in the following figure. The depth of…

A:

Q: A weir installed at the end of a rectangular channel controls the flow of water. The rate of flow is…

A:

Q: Darcy's Law: Elevation: 285 m Impervious Sand B = 5.5 m Elevation : 250 m k₁ Ditch L₁ = 35 m L, 15 m…

A:

Q: Groundwater flows through an aquifer with a cross-sectional area of 1.0 × 104 m² and a length of…

A: Given data- Area of the aquifer- A=1.0×104 m2,Length L=1500 m,Heads 300 m & 250 m,Discharge…

Q: 7.24. The contour plan of a proposed reservoir has the following particulars: Contour (m) 200 205…

A:

Q: In a three reservoir problem, the elevation of reservoir 1 and 2 are 462 m and 368 m respectively.…

A: Consider the following diagram:

Q: Draw the downstream water profile for the following step-up and step-down conditions.

A: Given Water flow diagrams and it is asked to draw downstream water profile of Sub-critical and…

Q: Your assigned problem: If the water surface elevation in reservoir B is 110m, what must be the water…

A:

Q: Reservoir A has an elevation of 138 m. A pipe is connected from reservoir A to reservoir B. It has a…

A: Q=0.96 m3/s C=121 d=0.922m

Q: A  0.09m^2 standard circular orifice is illustrated in a 2m^2 square vessel that is 3m high. Make…

A: Orifice: An orifice is a tiny aperture on the side or bottom of a tank through which any type of…

Q: Water is flowing at a steady rate through a homogeneous and saturated horizontal soil strip of 10 m…

A:

Q: 2. A 40 cm diameter pipe 600 m long carries 260 liters per second of water from reservoir A,…

A: Length of the main pipe=600 m Diameter of the main pipe(do)=40 cm Discharging pipes diameter=500 m…

Q: 5. Aquifer shown in figure represents: (a) confined aquifer (b) unconfined aquifer (c) Can be…

A:

Q: wo reservoirs having difference in water levels as 12m are connected by a pipe line 3 km long and 30…

A:

Q: A rectangular irrigation canal 3 m wide carries water with a discharge of 6 m^3/s. A rectangular…

A: According to given dataThe height of the rectangular weir if it is suppressed will be H= 1.05m…

Q: An earth dam is shown in (Figure 1). Determine the seepage rate, q, in m³/day/m Length using…

A:

Q: 2. Water flows at a rate of 90lt/s from reservoir A to reservoir B through three concrete pipes…

A: given data, L1=6000m,D1=0.3m,f1=0.018; L2=4000m,D2=0.23m,f2=0.015; L3=2500m,D3=0.2m,f3=0.012 since…

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 m The storage and outflow from reservoir…

Q: 6. The figure shown is a frustum of a cone with an orifice in the bottom of 0.20 m². If the water…

A:

Q: 4. A confined horizontal aquifer of 20 m thickness and permeability K = 22 m/day, connects two…

A:

Q: A syphon of diameter 200 mm connects two reservoirs having a difference in elevation of 15 m. The…

A: Given- Diameter of syphon d=200 mm, Difference of elevation of two reservoirs=15 m, Total length of…

Q: Consider the figure below. The pump supplies water from reservoir A to reservoir B through the 500mm…

A: Options given for subpart a and b are not correct. If we take hf1 = 80 then the answers are…

Q: Estimate the uplift pressure under bottom left corner of this dam If the entire dam sits 6ft below…

A: Find the hydraulic head as follows:

Q: O O 00 EGL HGL EGL HGL Water T = 10-C O None of them correct EGL HGL Water T= 10-C Water T= 10-C…

A: Given:- Pipeline with a reservoir, pump and a pressure measuring gauge having a pressure of -88.29…

Q: PROBLEM 2 . A tank is in the shape of a frustum of a pyramid having a square section .The upper base…

A:

Q: Example 12.3. A small reservoir has a spillway crest elevation 200.0 m. Above this elevation, the…

A: Elevation of spillway =200.00 m Storage: S=36000+18000y (m3) Outflow: Q=10y (m3/s) Assume the…

Length and Length related Variables

Length can de defined as the measurement or extent of physical quantities or objects from one terminal to another terminal. Stone age humans used finger length, step length, and so on to measure the size or displacement of an object. Nowadays, depending on how precise the measurement requires to be and the object’s size is measured, we use measuring devices for measurements like rulers and steel tape. Most people have used a ruler or tape measure to measure a particular distance or the size of an object. For more precise measurements of tiny objects, the development of measurement tools such as the Vernier caliper, which permits us to measure dimensions within 1/1000 of an inch. In the last few decades, electronic distance measuring instruments (EDMI) have been implemented that permit us to measure distances from a few feet to many miles with reasonable accuracy.