What is the direction of water in the set up? * 3 5 7 from 5 to 7 from 7 to 5 from 2 to 9 O from 9 to 2

Q: 7. Calculate the Mn, Mw and D for a polymer mixture sample comprising 2 g of polymer molecules…

A: Please find the attachment.

Q: The following is a standard solution of phosphorus (P) data measured by a spectrophotometer. ppm P…

A: The absorbance v/s concentration in ppm data given is, Given: Mass of Na2HPO4 sample = 2.1 g.…

Q: Can you please help calculate the reduced mass, μ, for a C-H bond. Answer to 2 decimal places.

A:

Q: An antacid tablet was ground, and 0.510 g of the powder was dissolved in 30.00 mL of 0.500 M HCl.…

A: Mass of antacid = 0.510 g Volume of HCl = 30 mL Molarity of HCl = 0.5 M Volume of NaOH = 9.25 mL…

Q: Required Concentration of Reagent 1.37 mM NaCl 27 mM KCI 100 mM Na₂HPO4 18 mM KH₂PO4 Molecular…

A:

Q: 2. You receive a request for 2% w/w calamine in emulsifying ointment, however you only have the 5%…

A: Firstly we need to found total weight that will make it 2% w/w. Then we will subtract 200 grams to…

Q: What type of distillation set up is in the picture? dang fsk recelving fak

A: Distillation is a the process of separation of liquids on the basis of their boiling points.…

Q: Add KCL 20mEq/L D5NS 1 L bag @ 125ml/hr. How many bags are needed in 24 hours ?

A: Solution:    KCl D5NS show presence of potassium chloride in 5% dextrose and sodium chloride. 20 mEq…

Q: For this prelab, all solutions were prepared exactly as described in the lab manual; all data were…

A: The given question involves calculating the percentage by mass of acetylsalicylic acid (ASA) in a…

Q: Use the Mol S₂032 consumed and Mol la produced from the table above for the calculations in Table 2…

A: To determine the initial concentration of thiosulfate ion, I3- produced, persulfate ion, I- at the…

Q: A scientist has an aqueous solution with an unknown concentration. He uses a 1-cm cuvette and…

A:

Q: RMR (kcal/day) = (9.99 x 79.5kg) + (6.25 X 182.9cm) - (4.92 x 35) + (166 x 1)- 161

A: RMR is the resting metabolic rate. It is the amount of energy in calories burnt while resting and it…

Q: Part C: Determination of the alcohol content of unknown liquor Stretien Volume (mL) Sample ТИШТИНА…

A: The objective of this question is to determine the alcohol content of an unknown liquor sample using…

Q: Complete the table below. Round each of your entries to 2 significant digits. You may assume the…

A: Information of question

Q: -3 -2 -1 0 +1 +2 +3 +4 +5 +6 +7 구모 99 5NO 2 + 6H+ + 2MnO4 999 오,99 5NO3 + 2Mn+2 + 3H2O Reset

A: This question belong to periodic table and Redox reactions.

Q: 4. You are placing the following quantities of BSA (1 µg/µL) in wells A1-A8 for a total volume of…

A: A table of data with mass and volume of BSA. Total volume and  corresponding Absorbance values.

Q: Find out the vitamin C content. Put vitamin C in sulfuric acid and then rinse with water, 250cm3.…

A: Iodometry is a titration technique in which iodine is indirectly liberated during the reaction which…

Q: A BOA kd ous soluion How many ppm of Br, s ths oluton 35.1 pp

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Calculate the mass and volume (mL) of 5.0 mmol triethylsilane Mw: 116.28 g/mol Density: 0.728 g/mL

A: Given :-  moles of triethylsilane = 5.0 mmol  Molecular weight = 116.28 g/mol Density= 0.728 g/mL…

Q: You are given a standard with a concentration of 10 ppm. You are to create 5 different samples, all…

A: Concentration of the standard = 10 ppmTotal volume of each sample = 100 mLWe have to solve the…

Q: Concentration of A (M) 45 450 minutes 550 minutes 400 minutes 500 minutes 600 minutes 4 3.5 3 2 1.5…

A: Answer:A graph between concentration and time is given to us and through observation we have to…

Q: Dr. TS You found lead in blood collected from children living within 5 km from the Ship Channel.…

A: Average lead concentration in mg/L is given below.

Q: What is the melting point range for both Salicylic acid and Aspirin? When I found online, different…

A: The objective of the question is to predict the correct melting range for both salicylic acid and…

Q: 2) Calculate the theoretical yield of aspirin. This should be done based on mass. Use Equation…

A: The quantity of a product obtained from a reaction is expressed in terms of the yield of the…

Q: For the data below, Write the linear equation of the line (use 5 Decimal places and don't add…

A:

Q: This is an experimental set-up for the purification of water experiment. State uses of each labeled…

A: We are given the complete setup of a distillation apparatus for the purification with labelling of…

Q: Balancing Act! Balance this equation! (Equation number 1 of 10) СаСОз + 2HСІ — CaCl2 + H20 + CO2 1 v…

A:

Q: Create an illustration showing the preparation of two-fold serial dilution follows the ratio of the…

A: To create an illustration showing the preparation of two-fold serial dilution.

Q: Please help me calculate this: I have a protein sample that has the concentration of 0.30835 µg/ml.…

A: 1 milliliter is equal to 1000 microliters. In the question given that , initial concentration of a…

Q: II. Determination of Total Hardness of Water Source of water sample: Volume of water sample 22.00 mL…

A: Given that, Volume of EDTA solution consumed (V1)=14.06mL  Molarity of standard EDTA solution used…

Q: Battery acid Toothpaste Agua oxygenada Antacid Softdrinks (Coke) Laughing gas

A: The given common name are general calling name of these chemicals which are having following…

Q: Calculate the following question: Convert: %T = 14% Absorbance =

A:

Q: Write a step-by-step procedure for this serial dilution. • The stock concentration of the blue dye…

A: In this problem we need to prepare different concentrated solution from a particular solution given.…

Q: In the copper experiment, a copper wire For the toolbar, press ALT+F10 (PC) or

A: Copper is dissolved in nitric acid

Q: 16. A physician orders that a child should be given potassium chloride milliequivalents per kilogram…

A: A physician orders that a child should be given potassium chloride (KCl) 1.6 milliequivalents per…

Q: In a 0.32 mM aqueous solution of trimethylacetic acid (C₂H,CO₂H), what is the percentage of…

A:

Q: 60.What is/are the purpose/s of heating sodium carbonate in 270°C for one hour before using it in…

A: The hydrochloric acid is standardized by titration with sodium carbonate. The reaction between them…

Q: Kerosene has a specific weight of γ_k = 51.1 lb/ft³ and benzene has a specific weight of γ_b = 56.2…

A: Density of substance is calculated by dividing mass with volume.

Q: 8. A student made a series of measurements of Mg** concentration in drinking water giving the…

A: Introduction :  Drinking water contains magnesium high concentration of magnesium and sulfur is…

Q: Your standard curve will contain the log of concentration in ng/mL on the x axis, and absorbance on…

A: It is given that the graph is between log of concentration (in ng/mL) on x-axis and absorbance on…

Q: The study of detecting small quantities of substances in samples would most likely be performed by a…

A:

Q: Three students (Saerom, Hayoung, and Jiwon) are asked to determine the ppm Ca in a drinking water…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Which analytical separation method is best for recovering river bodies that are polluted by heavy…

A: Basically the river bodies are polluted by heavy metals like…

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.