What is the damping ratio of the system given below? R(s) 20 C(s) 7+8s+ 20 1.894 0.894 O 1

Q: The least common fault in 3-phase power systems is O Three-phase short circuit O Single line to…

A: Choose the correct option The least common fault in 3 phase power system?    as per our guidelines…

Q: Flag question Time period of voltage waveform(household power supply) in Sultanate of Oman is…

A: Oman country  using 50 hz supply frequency

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: Given: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is…

Q: The concept of the state of a dynamic system refer to a .maximum set of variables The root locus is…

A:

Q: MPCB is used to protect the motor from over load. Select one: True False

A:

Q: What is the difference between the pins under number 1 and the pins under number 4, and mention when…

A: The difference between pin 1 and pin 4 is the transmitting ability (information) to external…

Q: Remaining Time: 53 minutes, 27 seconds +Ouestion Completion Status: A Moving to another question…

A: Given  In capacitive load ,the load angle

Q: What is the approximate value of surge impedance of a power cable ? 400 100 40 1600 A Moving to…

A: Surge impedance is defined as the square root of ratio of line impedance Z and shunt admittance Y is…

Q: All of the following statements about the TRIAC could be true except: OA. TRIACS are not used in…

A: TRIAC:- A TRIAC is a three-terminal AC switch that differs from conventional silicon-controlled…

Q: What is the FOA ratings in MVA

A:

Q: Which of the following is NOT included in MMDST kit? Small bell with 2 ½ inch diameter opening…

A: The solution is given below.

Q: a. b. d.

A: A computer port is used as an interface between the computer and different peripheral devices.

Q: The full form of PIPO is

A: Given, PIPO

Q: I. QUESTIONS/PROBLEMS 1. How are plus and minus current signs determined?

A:

Q: In N-channel JFET the Id is controlled by_______. a.Idss b.Vgs c.Vds d.Ig

A:

Q: QUESTION 29 Select all signals that are inputs for the 8088. Use the schematic for our board. OSC…

A: Consider the schematics of 8088 shown below,

Q: c) Given the changed lines of code below, answer the following questions. ANALOG_COMPARE_SETUP: LDI…

A: The given code is shown below.ANALOG_COMPARE _SETUP:LDI R16,0STS ADCSRA, R16LDI R 16, 0b00000000STS…

Q: 1. Explain the relationship of the measured voltage and the tripping time shown in the graph? What…

A: A graph is given in the question. It shows the values of tripping time corresponding to some values…

Q: . Find the current I11 and 12 from the circuit shown below ak ik 斗 タ太ヶ

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: write main points of full subtractor?

A: Here i have mentioned the main points of full subtractor.

Q: Explain the differece between continous and discountinous current mode of convetrer operation

A: There are basically two modes of converter operations  1) Continuous Converter Operation the current…

Q: d. The position error will be constant and the velocity error will be zero of a type-2 system

A: Step1 In this question, we have to check the statement whether it is true or false. To finding error…

Q: Write the specifications and market names of the cables NYA (NV), NYMHY (HO5VV-F), NYM (NVV) and NYY…

A:

Q: 4. Determine the failure rate of a repairable item if its failure rate to first failure is A=0,002…

A: Given  Failure rate and mean time to restore,we need to determine the failure rate of repairable…

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: We are authorized to answer one question at a time, since you have not mentioned question you are…

Q: RAZ LAZ www CAZ: RAZ LAZ RAZ LAZ GAZ CAZ GAZ CAZ GAZ

A: There are three types of transmission lines based on the product of frequency and length. For 50 Hz…

Q: 1. Using source transformation, determine the current i through the resistor R2 shown in the circuit…

A:

Q: can you make the formula clearer

A:

Q: The X/R circuit ratio of an automatic reclosure is inversely proportional to the asymmetrical factor…

A: Automatic recloser: It a type of switchgear that is used in overhead electrical distribution system.…

Q: s1) a) What area does the circuit run in? Calculate the middle band voltage gain Av=? VA=303V,…

A:

Q: digital communication I need Line codes for bits stream [101000110]. 1-Unipolar Rz and Unipolar NRz…

A: The digital data encoding schemes are categorized into five types based on their synchronization…

Q: (b) Referring to block diagram model shown in Fig. Q1(b), obtain the transfer function C(s)/R(s) by…

A:

Q: what is the type of the Iraq electricity tariff

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: she mechanism asa d pilal symd pan themugh a lypical Cmos imerten ancul.

A: All the circuits consist of some parasitic capacitance components attached in it. The parasitic…

Q: In a typical AAS what is the ouput of the istrument given out as data?     % composition…

A: Generally in the typical AAS the output of the instrument output data is  absorbance.

Q: (a) Describe how TLBs are used to increase paging efficiency.

A: TLB contain entries page table have been most recently used. The processor examines , the frame…

Q: Which of the following type will be mostly adopted in case small hydropower systems? O a.…

A: In case of pumped storage hydropower plant and Reservoir hydropower plant, a dams or big reservoirs…

Q: inm do A ☺ 52

A: From the mesh Analysis

Q: Write the names of the given components and equipment in Table1. Table 1 2. 3. 4. 5. 6. 7. 8. 9. 10.…

A: Here the names are, 1. Speaker. 2.Solar panel

Q: Where does 23/332 for N1/N2 come

A:

Q: Need help finding TF

A: Given: Block diagram of a control system. Formula and concept: Transfer function: Transfer function…

Q: Q1: Normalize the following numbers (a) ABCDEFH (b) 1.0000000000001B (c) 10^4 - 10^3 Q2: Code…

A: Q1: Normalize the following numbers (a) ABCDEFH (b) 1.0000000000001B (c) 10^4-10^3 Q2: Code…

Q: Explain LVDT with neat sketch.

A: The construction of LVDT is shown in figure. LVDT translates the linear motion into electrical…

Q: Deviations in quality of service include power irregularities. Which irregularity occurs when…

A: This problem is from power system.  The solution is given below.