Answered: What is the area of below cross-section…

What is the area of below cross-section if you know the formation level is 27.49m and ground elevation equal 25.47? 15 m 1 3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A slope distance of 465.89m is measured between two points with a slope of 12o34’. What is the…

Q: From the given differential leveling notes: A. Determine the difference in elevation between TP1…

A: HI1 = EL1 + BS EL2 = HI1 - FS HI2 = EL2 + BS2

Q: Example-5. The ground levels of a proposed longitudinal road section of the consecu- tive points 30m…

Q: Find the factor of safety of a slope of infinite extent with 8m thickness having a slope angle =25°.…

Q: 4. What is slope between point Cand point D? 2500m A 2000m B B' 5000m

Q: FS 2.875 m 4.252 m 5.478 m 6.142 m BS ТР 1 ТР 2 4.325 m 9.542 m 9.631 m 8.133 m BM 1 Elev. = 56.287…

A: GIVEN Traverse Illustration To Determine HI, Elevation, Correction to be applied, and Corrected…

Q: What is the slope in a fixed support with a settlement of 1 mm? O undefined O 0.5 O1

A: Answer : slope will be zero at fixed support. Option (c) 0. Is correct.

Q: 1. The area in cut of two irregular sections 35 m. apart are 34 m? and 56m? respectively. The base…

Q: Define Base Inclination Factors

A: Inclination factors are defined as the factors which are used when the line of action of load is…

Q: A level is set up and a reading of 2.195 m is taken on a bench mark the elevation of which is 89.54…

Q: 5. It is desired to determine the height of a church steeple. level, a 500.00 ft length is measured…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: the slope distance 587.447 m and altitude angle 16°26'35", the horizontal distance is

A: Given,slope distance=587.447m Slope angle=16°26'35" To find ,:- horizontal distance

Q: Angle of elevation and depression are measured from the (horizontal/vertical)

Q: The following offsets were taken from a chain line to a hedge at a regular interval of 20m from…

A: The given data is: Chainage interval from d1 to d4 = 20 m Chainage interval from d4 to d8 = 200 m

Q: Problem 2 Angles AOB, BOC, and COD are measured on the same angle at point O. Determine the most…

Q: 4.b. Explain most economical trapezoidal channel section for particular side slope.

A: For the most efficient and economical channel section wetted perimeter should be minimum and…

Q: Describe changed conditions for existing slopes.

A: Slope stability is defined as a condition of holding rocks or any structure out against the undergo…

Q: A road is to be constructed in a new cutting. The areas of five equally spaced consecutive…

A: To fund volume of cut fill

Q: A. For a saturated rock, prove that: Yu = te

A: (Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: 1. With the given profile level notes, STA BM₂ 0 +00 +10 TP₁ 0 +22 + 30.5 +34.2 +39.3 + 42.5 TP₂ 0…

A: To find the Elevation at BMb and to plot the profile

Q: Why must we use the Strictler equation to compute Manning's "n" for rip-rap? Couldn't we just look…

A: Strictler equation n = 0.0132D50 where, D50 is the median size of the bed material in millimeters…

Q: A four-sided closed field traverse has the following angles: A = 81°53'30"; B = 70°28'30"; C =…

A: Four-sided closed field traverse has the following angles:A = 81°53′30″;B = 70°28′30″;C =…

Q: 20⁰ 30, A 6kN 2kN 0.4m 0.6m

A: Given:- To find:- Force in AB

Q: For a rock slope shown in figure belows, consider the following: i-55°, p-40.6-40. 0A-38° and…

Q: A level is set up and a reading of 2.895 m is taken on a bench mark the elevation of which is 67.145…

Q: 2. The elevation of junction point X has been detemined by differential levelling from benchmarks A,…

A: Given data Set ups Elevations Difference in Elevations

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

Q: ?What is the elevation of point BM1 in the below table if you know that the elevation of BM2 is…

Q: Describe the procedure of Improving Stability of Slopes?

A: Slope stability analysis:

Q: Determine the slope at C.

A: GIVEN : P = 110.5 KN L = 6 m TO FIND : SLOPE AT C ( θc )

Q: A level is set up and a reading of 2.195 m is taken on a bench mark the elevation of which is 89.54…

Q: Towers A and B stand on a leyel ground. From the top of the tower A which is 30 m, high the angle of…

A: Given data- The given situation in the question is shown below- To find- The height of tower B.

Q: Degree of static indeterminacy

A: Given data : The value of number of member in truss=3 The value of number of joint in truss=4 The…

Q: Which of the following would you prefer in terms of superficial fortification of slopes? a.…

A: In terms of superficial fortification of slopes geosynthetic clay barrier will be preferred. So, the…

Q: A level is set up and a reading of 2.815 m is taken on a bench mark the elevation of which is 92.145…

Q: Let's Find the cut and fill volumes that allows for a say a level road is being built @ elevation…

A: Cut and Fill : Cut and fill operation in construction is also known as excavation and embankment…

Q: A slope measurement of 549.11 m is made between points A and B. The elevation of A is 424.43m and…

A: Given data in question Elevations from datum Slope distance To find out Horizontal distance

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

Q: Problem No.4 A rising slope distance AB was measured to be 718.93m with a difference in elevation of…

Q: Define Coefficient of Lateral Earth Pressure at Rest

A: Earth pressure: Th force is acting on the retaining wall when the soil is under the sloping…

Q: 6. Three points A, B, C are marked on the centerline of a roadway. Line AB has an upward slope of…

A: Option (b) is most appropriate.

Concept explainers

Volumes

Volume usually is the dimensional quantity that involves the evaluation of any three-dimensional figure enfolded inside a closed space. The SI unit (International System of Units) of volume is m3 and the dimensional unit of volume is [L3]. For estimation of the volume of any figure, various formulae are used. Another application of volume includes the reference in the sound levels, the higher the sound intensity, the louder the sound heard, and hence, the larger the volume. The SI unit of sound volume is decibels (dB).

Question

What is the area of below cross-section if you know the formation level is 27.49m and ground elevation
equal 25.47?
15 m
1
3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q2: Convert the following bearing angles to azimuth, and vice versa: 1- N 41.5° W 2- 127.7° Q3: From the below contour map answer the following question: 1- What is the highest possible elevation? 2- What is the approximated distance between the A and B? 3- What is the relief between A and B? A
Center of circle Using Bishop's simplified method of slices, calculate the stability of the slope, use at a minimum of 15 slices Need to provide a to scale sketch showing your curved failure surface to include your slices. 12.0 m 10.0 m 30 kPa You need to also include your excel file with your calculations - 28 y= 17.9 kN/m' 8,6 m 1.5 12.7 m - 10 kPa d = 32 y = 18.2 kN/m
1. What is the description of capillarity in parallel plates? What is the usage of it in experiments of hydrostatics?
Determine the elevation of PVI and PVTL=59.731
From the given leveling notes, compute the elevation of BM2 ELEVATION OF BM1 IS EQUAL TO 149.20
: Workout the Earthwork quantities in embankment and cutting for the chainage length of 600 meters. Formation width is 20m. Side slopes in embankment is 2:1 and in cutting is 1.5:1. There is no transverse slope. Rising gradient of 1:250 upto 250m chaniage. Rising gradient of 1:100 upto 600m chainage. Chainage 0 50 100 150 200 250 300 350 R.L of Ground 152.0 152.35 152.6 152.8 153.0 152.6 152.2 151.5 R.L of Formation 151.6 Chainage 400 450 500 550 600 R.L of Ground 151.2 150.5 150.3 150.5 150.7 R.L of Formation 155.4
Determine hydraulic radius Wetted area=25 m2 Wetted perimeter3D15 m
3. In construction survey, a line BC 57.89m is to be laid out using a theodolite. The line has a descending slope of 2°35’. If point C is at 123.67m at what elevation should point B be located? 4. A ground line has an ascending slope of 8.75% from P1 to P2. The elevation of P1 is 234.56m, at what elevation should P2 be located?
The distance between two points A and B measured along a slope was 270 m. Determine thehorizontal distance between A and B when: a. the angle of the slope is 12° b. the slope is 1 in 10 c. the difference in elevation of A and B is 8 m
SITUATION VIII. Given the following cross section notes of an earthwork on an 8m roadway. 6.7 4.75 1.8 1.4 0.5 Figure: (-6.7,1.8) (0,1.4) (4.75,0.5 (-4,0) (4,0) What is the area of Cross section? a. 12.771 m b. 13.447m c. 14.254 m d. 12.615 m
Q) Find the reduce level at rod using trigonometric ratios.
Engr. Madrid performed differential levelling between two benchmarks, she then set up a dumpy level at a convenient location along the general route between BM1, which has an elevation of 463.80 m, and BM2 whose elevation is 457.67 m. A backsight of 1.25 is taken on BM1, then the rodman goes forward to TP1 having a reading of 5.32. The level is moved forward and and was set again to another location. A backsight reading of 9.98 m is taken on the rod held at TP1. At the last set up of the instrument again, a foresight reading of 12.87 was taken at BM2 and a backsight reading of 6.11 m was taken at TP2. Upon checking the levelling notes, the recorder noticed that she missed to take down the foresight reading at TP2. If the survey was correctly done, what could be the foresight reading at TP2? Select the correct response: 6.47 m 4.67 m 5.28 m 5.82 m