Answered: What does the dials on the power supply… | bartleby

Related questions

Question

What does the dials on the power supply mean? What does it mean if they put two plugs in the ac for the power supply? Why did they put one plug on top of the other? What would happen if they put one plug on ac and other on dc?

spacesaver
LOCKMASTER POWER UNIT
SELECT VOLTAGE
RESET
6
5-
4
3
OVERLOAD
7
10
11
-12
13
14
15
Umieck papped fo
1-Vac & dc. 8.5A max.
d.c.
UNILAB

Expert Solution

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

16. You see a group of small fuse holders on a DIN rail in an industrial control cabinet. The fuse holders are in groups of five and are separated by a single terminal block. What's connected to that terminal block? A. System ground B. A control signal C. The AC or DC power to the fuses D. The power supply neutral 17. Which one of the following types of raceway offers the greatest protection for the conductors in the raceway? A. Metal wireway B. EMT conduit C. Rigid conduit D. Flexible conduit 18. Class 1 conductors or cables may be run with other Class 1 conductors if they all A. are part of different machine circuits. B. have different power supplies. C. have reduced voltages on the conductors. D. have the same insulation value.
1. Explain how AC and DC current are different in your own words. Give an example of when you might encounter each type of current. 2. You find that there is too much resistance in a circuit to light up your LED's when you put them in a row, so you decide to hook them up in parallel. Why do they now light up and what possible danger is there now?
1. A series circuit has 3 resistors of values 10, 20, and 30 Ohms and a current of 2.0 Amps. What must be the voltage supplied to the circuit? a) 50 volts b) 250 volts c) 120 volts d) 25 volts 21V , 102 50 50 2. In the above 10-Ohm resistor, what is the current reading after the power supply? a) 0.60 A b) 3.0 A ) 1.2A d) 2.4A
2. An ideal battery (no resistance) for which V =9 Volts is placed in series with a 100 2 resistor and a 20 mF capacitor in a closed loop circuit, as shown in the figure below. What is the RC time constant? The switch is closed at time t= 0. What will be the current in the-circuit just after the switch is closed? What is the current in the circuit a long time after the switch is closed? Use DESMOS to make a graph of the current in amperes versus the time in seconds, from t= 0 to t = 5RC.