Answered: In a DC circuit with a single resistor,…

QUESTION 20

In a DC circuit with a single resistor, a current of 13 Amperes flows through a point in the circuit. After a time of 10 minutes, which of these expressions yields how much charge has flowed through the point in this time in SI units?

	a.	13 divided by 10
	b.	13 times 600
	c.	13 times 10

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

QUESTION 22 Given two resistors of 70 ohms and 40 ohms connected in series to a DC battery. If the 70-ohm resistor has a current of 3.00 Amperes through it then which of these is the current through the 40-ohm resistor in SI units? a. four sevenths of 3.00 b. one-third c. 3.00
3. A 60 and a 120 resistor are connected in series with a 36 volt battery,. How many Joules per second are dissipated by the 120 resistor. A. 14 watts B. 24 watts C. 48 watts D. 64 watts
The time constant in an RC circuit is the time it takes a. so that the current drops to zero. b. so that the current reaches its maximum value c. so that the capacitor is fully charged. d. in which the current decreases to 37% of its initial value.
Which of the following is an installation requirement for the grounding electrode conductor in a communications system? A. It must be run as straight as practicable. B. It must be, at minimum, 4 AWG. C. It must be solid or stranded aluminum. D. It must be isolated and covered.
7. In a DC circuit 8.41 x 10 19 electrons travel through a point in the circuit in two seconds. What current is in the circuit? a. 7.43 Amperes b. 5.36 Amperes c. 6.73 Amperes d. 1.10 Amperes e. 8.41 x 1019 Amperes
1.a. An unintentional electrical path that's conducting current from an ungrounded conductor to a normallynoncurrent-carrying metal raceway would be defined as a groundA. conductor.B. fault.C. electrode.D. interrupter. 1.b. It's important for designers and installers to ensure that equipment ground-fault current paths have________, which will facilitate the tripping of the overcurrent protective device.A. low impedanceB. proper labelingC. high impedanceD. an equilibrium
Circuit Problem: Express each labelled voltage and current (e.g., vx, ix) in terms of the resistances and source currents and voltages (e.g., R0).
In the picture below there are 2 electromotive force with a large voltage of 12.5 V and an internal resistance of 0.75 Ohm arranged in series. Furthermore, the circuit with a series of resistance as shown in the picture. EJ & R₁=852 B R=1602 ·m R$40 R₂=1602 mmm. R₁=802 Calculate : a. The total resistance of the circuit. b. Strong current generated www.
three light bulbs with an internal resistance of 1ohm each are wired first in series and then in parallel. each time they are connected to a 12v battery. which of teh following statement is true a. the equivalent resistance of the circuit will be greater when they are wired in parallel. b. the current through each light bulb will be greater when they are wired in parallel c. the voltage drop across each resistor will be greater when they are wired in series d. the light bulb will burn brighter when they are wired in series

In a DC circuit with a single resistor, a current of 13 Amperes flows through a point in the circuit. After a time of 10 minutes, which of these expressions yields how much charge has flowed through the point in this time in SI units? a. 13 divided by 10 b. 13 times 600 c. 13 times 10

QUESTION 20