A 100 Q resistor is connected in parallel with a 50 resistor. Which of the following best describes the equivalent resistance of this parallel network? A. greater than 150 2 B. equal to 150 N C. equal to 75N D. equal to 50 2 E. less than 50 2 O A O E B. C.

A 100 Q resistor is connected in parallel with a 50 resistor. Which of the following best describes the equivalent resistance of this parallel network? A. greater than 150 2 B. equal to 150 N C. equal to 75N D. equal to 50 2 E. less than 50 2 O A O E B. C.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 2PE: (a) What is the resistance of a 1.00 102-O, a 2.50-k O, and a 4.00-kresistor connected in series?...

See similar textbooks

Related questions

Q: and a 15 ohm resistor are connected in parallel and placed across the terminals of a 15 volt…

A: Given: Resistance, R1=10 Ω Resistance, R2=15 Ω Voltage, V=15 V To find: a) Sketch the circuit…

Q: 4. Arrange the following from highest to lowest current. Show circuit diagrams of each. a. 1.40…

Q: 13. DETAILS = GHCOLALG12 4.5.065.MI. If three resistors with resistances of R₁, R₂, and R3 are wired…

A: Resistance R2 is 10 ohm greater than R1 Resistance R3 is 50 ohm greater than R1 Combined…

Q: 6. Consider the circuit shown below. U9 U8 a. Calculate the equivalent resistance of the system. b.…

Q: C1. There are two wires, one is made of copper and the other one is silver. These two wires of the…

A: 1. The resistance of the wire always depend on the length, cross sectional area and the resistivity…

Q: An 18.0 2, 9.00 2, and 6.00 N resistor are connected in series with an emf source. The current in…

Q: The amount of current following in a circuit was measured to be 1 = 0.00037 A Express in Powers of…

A: Given Current in a circuit = 0.00037 A To calculate : conversion into powers of ten

Q: In the diagram, the current in the 3 ohm resistor is 4 A. What is the potential difference between…

Q: Assume the wires below are made of the same material and have the same cross section. Which wire…

A: Given information :- Here we are given four same materials whose area of cross-section is same but…

Q: 7. A parallel combination of a 5.00 2 resistor and an unknown resistor R is connected in series with…

A: Given data The resistance of the first resistor is R1 = 5 ohm The resistance of the unknown…

Q: 14. Which resistor is in series with resistor R? a. R₁ b. R2 C. R3 O d. R4 OC D O A OB R R4 R₁ R2 R3

Q: 3. What is the maximum number of 100-W light bulbs you can connect in parallel in a 120-V home…

A: Here first we calculate the resistance of single resister by using the power formula. After that we…

Q: Two materials have different resistivities. Two wires of the same length are made, one from each of…

A: Given: The length of the wire is the same. The resistivity of the wire is different.

Q: A Galvanometer has an internal resistance of 120 ohm with a maximum allowed current of 250 µA. If…

A: The expression to calculate shunt resistance is. S=IgGI-Ig

Q: A 20 V battery is connected to a resistor. Neglecting the internal resistance of the battery, the…

A: Voltage of the battery, Vs=20 V Power delivered to the resistor, P=10 W

Q: Four identical resistors are connected in series to a battery. If the current of 12 A flows from the…

A: current = i = 12 Amp resistors are in series

Q: a. What is the equivalent resistance for this circuit? R1=10 2 R3=4 2 R2=1 2 12 V R4=1 2 b. What…

Q: A certain person will experience a mild electric shock when the current between two fingers exceeds…

Q: 3. A 692 and a 120 resistor are connected in series with a 36 volt battery,. How many Joules per…

Q: How is an ammeter connected in a circuit to measure current flowing through it? a. An ammeter is…

A: Charges can be positive or negative. A charged particle is one that has an excess of either positive…

Q: In Drude's model of electrical conduction, current density is not directly proportional to a.…

A: The Drude model of electrical conduction explain the transport properties of electrons in materials…

Q: 1. The sum of the resistance of resistors in series can sometimes be greater than the individual…

Concept explainers

Temperature Variance of Resistance

Electrical resistance or simply resistance is the property of a material that opposes the free flow of electrons through it. The total amount of resistance to the flow of charges (or current) is affected by many factors like the length of the conducting material, its cross-sectional area, resistivity, and temperature.

Question

A 100 Q resistor is connected in parallel with a 50 2 resistor.
Which of the following best describes the equivalent resistance of this parallel network?
A. greater than 150 Q
B. equal to 150 Q
C. equal to 75 Q
D. equal to 50 Q
E. less than 50 2
O A
O B
OC
OD
O E

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) What is the terminal voltage of a large 1.54-V carbon-zinc dry cell used in a physics lab to supply 2.00 A to a circuit if the cell’s internal resistance is 0.100 ? (b) How much electrical power does the cell produce? (c) What power goes to its load?
A car battery with a 12-V emf and an internal resistance of 0.050 is being charged with a current of 60 A. Note that in this process the battery is being charged. (a) What is the potential difference across its terminals? (b) At what rate is thermal energy being dissipated in the battery? (c) At what rate is electric energy being converted to chemical energy? (d) What are the answers to (a) and (b) when the battery is used to supply 60 A to the starter motor?
When resistors with different resistances are connected in parallel, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
(a) Can the circuit shown in Figure P27.21 be reduced to a single resistor connected to a battery? Explain. Calculate the currents (b) I1, (c) I2, and (d) I3. Figure P27.21
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
(a) Digital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor (which has a= - 0.0600/°C ) when it is at the same temperature as the patient. What is a patient's temperature if the thermistor’s resistance at that temperature is 82.0% of its value at 37.0°C (normal body temperature)? (b) The negative value for a may not be maintained for very low temperatures. Discuss why and whether this is the case here. (Hint: Resistance can’t become negative.)
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
Three identical 60.0-W, 120-V lightbulbs are connected across a 120-V power source as shown in Figure P28.72. Assuming the resistance of each lightbulb is constant (even though in reality the resistance might increase markedly with current), find (a) the total power supplied by the power source and (b) the potential difference across each lightbulb.
For the purpose of measuring the electric resistance of shoes through the body of the wearer standing on a metal ground plate, the American National Standards Institute (ANSI) specifies the circuit shown in Figure P27.14. The potential difference V across the 1.00-M resistor is measured with an ideal voltmeter. (a) Show that the resistance of the footwear is Rshoes=50.0VVV (b) In a medical test, a current through the human body should not exceed 150 A. Can the current delivered by the ANSI-specified circuit exceed 150 A? To decide, consider a person standing barefoot on the ground plate. Figure P27.14
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
Currents of approximately 0.06 A can be potentially fatal. Currents in that range can make the heart fibrillate (beat in an uncontrolled manner). The resistance of a dry human body can be approximately 100 k . (a) What voltage can cause 0.06 A through a dry human body? (b) When a human body is wet, the resistance can fall to 100 . What voltage can cause harm to a wet body?
The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ27.9. When the potential difference across the device is 2 V, what is its resistance? (a) 1 (b) 34 (c) (d) undefined (e) none of those answers