What are the units of CA0 , CB0 ,and K where ; VA AND VB  are flow rate in m3/min NA Is the normailty

Q: 1. The system as shown in Fig.1. The gauge pressure at the bottom of the tank is 242 kPa, what is…

A: Given, Gauge pressure at the bottom of the tank, P=242 kPa=242000 Pa

Q: If 100 lb m/min of A (MA  2) and 300 lb m/min of B (MB  3) flow through a pipe, what are the mass…

A: Given: The mass flow rate of A is mA* = 100 lbm/min The molar mass of A is MA  = 2 lbm/lbmol or…

Q: Show that Reynold number, pud/µ, is non-dimensional. If the discharge Q through an orifice is a…

A:

Q: m 8-10. In a steady flow apparatus, a fluid enters with a specific volume of 0.40 a pressure of kg…

A: At inlet,  Specific Volume(ν1)=0.40m3/kg Pressure=550kPa Velocity=20m/sec At exit, Specific…

Q: The BERNOULLI equation that follows is for incompressible permanent flow where the functional…

A: Given that P1gamma+s1+v122g  = P2gamma+s2+v222g= constant

Q: (a) What are the units for the constant 5.67 ? (b) Develope another expression in which the…

A:

Q: Dimensional analysis with Buckinham's Pi Theorem is applied to the relationship between frictional…

A:

Q: The speed of sound in a fluid can be calculated using the following equation: where v = speed of…

A: Given data: The equation of the speed of the sound is given as

Q: To measure the mass flow rate of water flowing in a pipe, an orifice is used and a water-mercury…

A: The volumetric flow rate of water is to be calculated.

Q: The tank in figure below is filled through point 1 with velocity equal to 5 m/s and point 3 with…

A:

Q: Example (4-2): Water (p= 990 kg/m³ & μ= 0.01 pa.s) is pumping from an open-storage tank to water…

A: To calculate the discharge frictional head loss and pump liquid power, we will use the…

Q: Consider the steady laminar flow of water at 25°C through the piping system shown below. (a) Derive…

A: (a). Average Velocity expression at section 1 and 2, Shear Stress for laminar flow, τ = μdudy  μdudy…

Q: Q4: 8*10 m/s of water flowing through a pipe of 0.2 m I.D. What will be the difference in level on…

A: Given: Volumetric flow rate of water, Q = 8 x 10-4 m3/s Internal diameter of the pipe, Di = 0.2 m…

Q: You have to measure the flow rate of water through a small pipe. In order to do it, you place a…

A: The volume and time data for a fluid flow through a small pipe is given.

Q: 1) A tank is filled with oil whose density is 0.85 g/cm. If the volume of the tank is 2 m',…

A:

Q: Find the differential pressure, PA-PB in kPa for the manometer shown on figure 2 if h, = 0.64 m, h2…

A: S.G. = Density of substance/ density of water

Q: A' E Stream A B с D E A' Flow rate (Q, L/s) 120 80 160 Solid (C, mg/L) 2000 20 6000

A: Streamfloe rate (Q, L/s)Solid (C, mg/L)A1202000B8020C6000DEA'160

Q: gas above the liquid as shown below. Derive an ODE relating the liquid level h to the input flow…

A:

Q: 4–126 A steady, incompressible, two-dimensional velocity field is given by V = (u, v) = (0.65 +…

A: Given thatu =0.65 +1.7x v =1.3-1.7y

Q: 13. An orifice meter is used to measure the rate of flow of a fluid in pipes. The flow rateis…

A:

Q: A pump discharges a liquid into a drum at the rate of 0.032 m3/s, the drum, 1.50 m in diameter and…

A: Given that: Volume flow rate of liquid = 0.032 m3/s Diameter of drum = 1.50 m Radius of drum (r)=…

Q: 1. The Darcy-Weisbach Equation for specific energy loss hi due to friction between the moving fluid…

A: Darcy-Weisbach equation for specific energy loss is given.

Q: Verify the consistency of the energy equation for mass flow: vỷ – Vỷ (P2 - P1) + m (Z2 - Z1) + m -f…

A:

Q: 2 m 1 P = 100 kPa 12 m 2 1 m

A: Fluid dynamics is the study of fluid motion that involves forces which cause acceleration and…

Q: A Density changes in a fluid are inversely proportional to temperature changes. B) None of the…

A: (a) As the temperature increases, volumes of most of the fluids also increases and when the volume…

Q: An orifice meter is used to measure the rate of flow of fluids in pipes. The flow rate is related to…

A: This is a question from unit transformation. The key step to solve these questions is that unit of…

Q: The pressure drop for a fluid flowing through a packed bed of solids is given by the relation: ,0.15…

A:

Q: 1. Water is flowing through a 0.75 m diameter pipe. The velocity distribution in the pipe is given…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: What is the flow rate if I have an oxygen flow meter a set at 7 liters? What does that mean if I set…

A: Flow meters are used to determine the flow rates of the fluids. for liquids, we have a venturi meter…

Q: Q6: 5.3.1R (WP Water flowing in a pipe with a velocity of 25 m/s and a static gage pressure of 940…

A: Applying Mass balance over three sections- Density of water be, d = 1000 kg/m³ Mass in = Mass out…

Q: 8. Calculate the ft3/s or volumetric flowrate of water being discharge at an open tank which is 3048…

A:

Q: determine the mass tradisfer coefficient (cm/s) for a flow flow along a 8.7-cm flat plate. Assume a…

A: Given that :L =8.7 cm =8.7 x 10-2 mRe=1069sc =3876DAB =0.000026 cm2s =0.000026  x 10-4 m2s

Q: Sea water flows through a cast iron pipeline having a diameter of 'd' m. The volumetric flow rate is…

A: The Pressure difference, viscosity and the density of the fluid is:

Q: Are you sure about the flowrate? Because the equation you gave indicates that as FAo decreases, then…

A: If we decrease flow rate , then we have more residence time for the reactant to react  and if we…

Q: 1. A labelled flowchart of a continuous steady-state twounit process is shown below. Each stream…

A: A labelled flowchart of the steady state process is given. The mass flow rate of inlet stream is 100…

Q: A water container is kept on a weighing balance. Water from a tap is falling vertically in to the…

A: This question is based on Dynamics of fluid flow. Given : Q = Volume flowrate of water from the tap…

Q: A relationship often used to model fluid flow in porous media is Darcy's law, -- vP-PR)=-v9, where k…

A:

Q: A pump is used to deliver water from BAWADI reservoir that is situated at Mt. Cabuyao, Sto. Tomas at…

A: Given data: Absolute pressure at the surface of reservoir = 98.62 kPa Temperature of water = 20 0C…

Q: Total Volume Time to Inlet Outlet Input Flow Head, Output Efficiency, n of water, Head, hi head, ho…

A: The volume of water stored. Total time to collect the water. Inlet head, hi(m) Outlet head, ho(m)…

Q: A two-dimensional flow field described by V = (2x²y + x)i+ (2xy² + y + 1)j where the velocity is in…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Verify the consistency of the energy equation for mass flow: v? – Vệ (P, – P,) + m I (z, – z,) + m ·…

A: As the dimensions are given, we will verify the eqaution with dimensional analysis The given…

Q: Any physical system following reactive and steady state the mass balance equation is input = output…

A: Statement is "TRUE"  For Reactive and Steady State:  Accumulation = 0  ----(1)