What are the stipulations of the Occupational Health and Safety Act, 1993, Guidelines for Driven Machinery Regulations, 2015, Number 11 (1) (a), (b), and (c) regarding slitting machines? For the toolbar PROSE

Q: explain how a bandsaw, drilling press, and milling machine are used

A: Working of the band saw machine:-  This machine is used to make the rough cuts through the metal…

Q: Define what a gripper is and provide alternative techniques for “gripping

A: A gripper is a device that enables the holding of an object to be manipulated. Just like a hand,…

Q: 5) Compare Power Screws with Ball Screws (based on their design parameters and application…

A: The detailed answer is provided below.

Q: (Electrochemical Machining) An ECM operation is used to cut a hole into a plate of stainless steel…

A:

Q: What do you think will happen if there are no control devices in most industrial processes? Is there…

A: given; What do you think will happen if there are no control devices in most industrial processes?…

Q: Problem 2. (Determining Cutting Speeds in Machining Economics) A turning operation is performed with…

A: Given: n=0.12 ; C=60 m/min Length of workpiece→L=450 mm Diameter of the workpiece→D=80 mm…

Q: Suppose in a face milling operation, the dimensions of the workpiece are 5 inches by 10 inches. The…

A:

Q: Discuss what would likely happen if a needed sscrew or a working tool is missing from a traditional…

A: It is asked to discuss the effect of missing screw or tools from a traditional mass production line.

Q: 3. Which of the following processes would be appropriate for cutting a narrow slot, less than 1mm…

A: Given ,Different non traditional machining processes.To find - appropriate process for cutting a…

Q: The following data is given for slab milling of a 300 mm long 50 mm wide mild steel block: Cutter of…

A:

Q: Read the description of the operations required to make a part, and considering the production rate,…

A: Given: operations required and production rate To find: Select machine

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.