Wet steam at 10 bar and vapor mass fraction xv =0.25 is fed to a boiler and converted to superheated steam at constant pressure at a temperature of 300˚C.  a) Find the heat input required in kW for a flow rate of 5,000 kg/h.

Q: A ship’s steam turbine receives steam at a pressure of 700 [psia] and a velocity of 100 [ft/s]. The…

A: Given data are as follows: Inlet steam pressure = 700 psia Inlet steam velocity = 100 ft/s outlet…

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: For transfusion of blood to a patient, it is decided to have a heat exchanger which heat the blood…

A: Given that TC1  =6 CTC2 = 37 CQ = 590 mlminCp  = 4180 KJ/kg      According to bartleby rule I can…

Q: Water at a rate of m=63 g/s at 38°C is available for use as a coolant in a double- bipe heat…

A: Maximum heat transfer rate for rate is calculated. Capacity rate of water is calculated. The number…

Q: We use a steel cylinder with a cross-sectional area of 0.0290 m² and containing 1.24 x 10¬2m³ of…

A: (a) Write the expression for coefficient of volume expansion as follows: β = ∆VV∆T      ......1…

Q: There are three thermal energy reservoirs that are being used by a reversible engine, namely X,Y,…

A: Given that, An equal amount of heat is being absorbed by the engine from reservoirs X and Y Qx = Qy…

Q: Thermal efficiency of the ideal engine

A:

Q: Q1. Water is being pumped from the bottom of a well 20 ft deep at the rate of 2000 lb /hr into a…

A: Dear subscriber ! As per our answering policy, we have solved the first of the three questions…

Q: An evacuated 150-L tank is connected to a line flowing air at room temperature, 25oC, and 8 MPa…

A: Volume (V) = 150 L Tin = 25°c = 298 K T3 = 25°c = 298 K Pin = 8 MPa = 8000 KPa P2 = 6 MPa = 6000 KPa…

Q: A reversible compression of 1 mol of an ideal gas in piston/cylinder device results in a pressure…

A: Given, The moles of ideal gas, n = 1 mol The initial pressure, P1 = 15 bar = 0.2 bar The final…

Q: Calculate the heat transfer and exit temperature of both

A:

Q: Water (T = 20°C) from a reservoir is pumped up at 5 kg/s through a 3-in Sch. 40 pipe connected to a…

A: Given :Fluid Flow and Pumping:Water is being pumped from a reservoir through a The flow rate is Pump…

Q: Every 6F stream is made up of contrasting Sections 2 components (A & B) The numbers 1, 2 & • refer…

A: Given that  there is a block diagram given we have to find mass flow rate of 1,2 and 3

Q: Air is used to heat a room . The flow rate of the entering air to the heating unit is(2.50 m³ /s) at…

A:

Q: (b) In figure Q1(a) a system is taken from state A to state B along the path ACB, 95 J of heat flows…

A:

Q: Steam at 400 kPa and 700°C is being transferred through a 100-cm-diameter pipe at a speed of 55 m/s.…

A:

Q: Air enters a compressor operating at steady state at a pressure of 1 bar, a temperature of 290K and…

A: The Air compressor must operate at steady-state conditions. The inlet and outlet states must be…

Q: 1200 grams of air is contained in a frictionless piston-cylinder assembly at a pressure of 0.15 MPa…

A:

Q: Q6 Air, at a temperature of 32°C passes through a heat exchanger at a velocity of 3 m/s, and its…

A:

Q: Oil at a rate of 1000 kg/min flows from an open reservoir placed at the top of a hill 400 m in…

A: The mass flow rate of oil, m = 1000 kg/min Height of the top of the hill to its bottom, Δ z = 400 m…

Q: A turbine accepts superheated steam at 800 psia and 1200°F and rejects it as saturated vapor at 2…

A:

Q: A diagram of a high boiling azeotrope is given below. Negative Deviations from Rauolt's Law vapor…

A: Given:

Q: In a continuously operated bioreactor metabolic heat is generated at the rate of 4 kW. Also, mixing…

A: In a continuous reactor, the input and output streams carry material in a flowing manner. It is an…

Q: Example :- Calculate the speed required for 0.6 m' tank in which 100 W/m is supplied to the tank,…

A: Given For 0.6 m3 power P = 100 W/m3

Q: bm of helium at 80°F a he tank for 30 min. De Specific heat of helium

A:

Q: expanded irreversibly through a turbine

A:

Q: Water is stored in a large, well-insulated storage tank at 21.0°C open to atmosphere. It is pumped…

A:

Q: 9.18. In a continuous-flow process, a gas is throttled to half its density. The throttling is well…

A: Throttling process is defined as the process for which enthalpy remains constant that is no work is…

Q: .7Nitrogen gas (N2) at 100 °C enters a horizontal friction less tube with the velocity of 75 m/sec…

A:

Q: A sample of 10 g of liquid benzene at its boiling point is vaporised using a 12 V, 0.5 A electric…

A: (a) Write the expression for enthalpy and internal energy as follows: ∆H = ∆U + ∆nRT     ......1…

Q: Steam enters a turbine operating at steady state at 1.5 MPa and 418.4 °C, with a velocity of 79 m/s.…

A:

Q: 6-49 A heat pump is used to maintain a house at a constant temperature of 230C. The house is losing…

A: Given that: Heat lost by house, QL = 85000 kJ/h Heat gained by appliances and lights, QApp = 4000…

Q: 19. a 1.99 kg of gas (R= 428.6 J/kg=K) undergo a non-flow isometric process from 577.7 kPa and 57.15…

A: Given Mass of gas m=1.99kg R=428.6 J/kg-K P=577.7 kPa T=57.15 °C  P=1765.46 kPa Heat added=119 kJ/s…

Q: Nitrogen is contained in a rigid tank (10 m at an initial pressure of 200 kPa. Heat transfers from…

A: